Question about Mazda CX-9

Open Question

I have a 2008 Mazda CX9, I turned off the ignition yesterday and the ac/heater fan started blowing. Blows for exactly one minute and shuts off.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75744 Answers

SOURCE: 2008 saturn vue

You have a problem with the heater blower speed controller, they act this way just before they stop working completely.

Posted on Oct 09, 2008

  • 1 Answer

SOURCE: 1998 mazda b2500 continually blows

air valve on heater hose missing or cracked, small 2mm vac hooks up to the control valve on bottom L shaped connector. rubber boot.

Posted on Mar 02, 2009

emissionwiz
  • 75744 Answers

SOURCE: heater blows cold air ac blows warm air

Your problem is the air temp control blend door actuator is defective and not controlling temp u set. to change/access this part the dash assembly must be removed from the car.

Posted on Mar 24, 2009

  • 1 Answer

SOURCE: 1997 dodge intrepid heater/ac fuse keeps blowing

I have a 96 Intrepid, and none of the signal lights work. I tried replacing the fuse, but this did not remedy the problem. Could this be a loose connection?

Posted on Jul 06, 2009

  • 106 Answers

SOURCE: The heater blows cold when

It's possible you have a bad vaccum line to the actuator door in the heater assembly
or possibly a stuck thermostat

Posted on Oct 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater fan only works high


it sounds like the heater switch itself is bad. I would change it.

Jan 27, 2014 | Pontiac Montana Cars & Trucks

1 Answer

2005 chevy impala passenger side blows heat out continuously, driver's side works fine with heater & AC


You may find a reset will solve this annoying problem. The problem you have is the GM heater control unit has lost it's calibration, which can happen from time to time. The way to reset it is, start your car and turn your heater off, and shut off the car, pull out the keys. Then with vehicle off, disconnect the battery, (or batteries if it has two). Let sit for 10 minutes, then re-connect battery. Get in and start the engine, DON'T touch anything, let the heater control unit re-calibrate for at least 40 seconds, (by the clock), then try turning on the heater.
Good luck!

Jul 18, 2013 | Cars & Trucks

1 Answer

My 2008 mazda cx9 fan started blowing after shutting off the engine, blows for one minute and quits


To a limited extent this is normal because the engine goes into a heat soak condition when it is shut down- hot areas with the water jacket surrounding it are still heating up from the residual heat in the engine.

Feb 12, 2012 | Cars & Trucks

1 Answer

2008 Nissan Versa.....the heater fan keeps cutting out


THE FAN IGNITIOR MIGHT OF WENT OUT CHECK IT AND TEST IT IT ALSO COULD BE THE RELAY SYSTEM SWITCH

Jan 23, 2012 | 2008 Nissan Versa

2 Answers

Strange Problem Bravo Ute Air Conditioning


the blower motor has no affect on the AC system,
start the engine and turn on AC and watch the AC compressor to see if clutch engages,if it doesn't the system isn't full,if you are correct the clutch should be engaged and should quit when you change heater speeds,

Dec 23, 2009 | 1988 Mazda B2600 Cab Plus

1 Answer

2008 silverado heater a/c control only blows on


In AC mode check that the rad fan(s) kick in and opp.

Aug 25, 2009 | 2008 Chevrolet Silverado 1500

1 Answer

A/c fan blows without car turned on or key in ignition


Either you have connected your wiring incorrectly, recheck all of your wiring connections, Or the power supply for the fan is coming straight from the battery instead of running through the switched relay, most likely the relay is stuck closed allowing the fan to stay on.

Aug 21, 2009 | 2003 Chevrolet Impala

1 Answer

Does heater work with ignition turned off?


Not, The heat works off the temperature of the engine.

Jan 19, 2009 | 2004 GMC Envoy

1 Answer

2008 saturn vue when ac or heater is on the fan blows hard then completly shuts off then comes back on on low then blows hard again all without touching the knob


You have a problem with the heater blower speed controller, they act this way just before they stop working completely.

Oct 08, 2008 | Saturn Vue Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...