Question about Cars & Trucks

Open Question

Hi, I drive an opel Corsa C 2003. there is this light on my dash board (the outlining of a car with a spanner through it) this was on and the car went into limp mode. i stopped the car turned it off but it doesn't want to start again. The light is now flickering what can i trouble shoot to determine the problem?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Opel Corsa B automatic transmission Fault

have you replace the transmission fuse it on the cigar lighter circuit?

Posted on Aug 01, 2009

Ad
  • 6982 Answers

SOURCE: 2001 opel corsa 1.4 is utility. Snapped the

Likely you are talking about the harmonic balancer.
The bolt turns counter clockwise and is generally removed using an air gun. There is another way to do that too but it is a bit dangerous. Using a solid breaker bar (one without jointed end) you can brace the end against the ground with the socket installed on the crank bolt (I actually have a pipe driven into the ground outside just for doing this...I just slide the bar into the pipe and keep it form dropping by using a vise grip on the handle). Once the socket is on the bolt, crank the engine over using the starter, the engine will force the bolt to back out.
After you get the belt installed, tighten it as much as you can by hand and ask a shop to just give it a final tightening with an air gun.
If the socket slips the bar can fly up so be very careful and don't stand where it can hit you!

Posted on Feb 15, 2010

alicantecoli
  • 22219 Answers

SOURCE: Diagram of waterpump for opel corsa utility 2007

its behind the timing belt ,but i do not have any pictures .

Posted on Mar 06, 2010

alicantecoli
  • 22219 Answers

SOURCE: opel corsa 1.4i car cuts

nice motor for work and shopping ,try the idle control valve ,its a steper motor in the side of the monopoint injection housing (looks like a carb body) at the front right side is a round motor looking thing with a multiplug with 4 wires in it ,held in with two torq headed screws ,take it out and clean it but do not twist it or force it in any way

Posted on Nov 30, 2010

  • 1 Answer

SOURCE: Opel Corsa engine maintenance schedule and

please tell me about the opel corsa engine maintenance after how much kilometer i will go to change the engine oil and all??

Posted on Mar 13, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Spanner and car light flashing on my opel corsa bakkie diesel 1.7 swinging but wont start


Has the system been scanned for fault codes? If not have that done first.

Jun 14, 2016 | Opel Cars & Trucks

1 Answer

Opel corsa 2006 utility 1.7dti. The roof light,


check the fuses lower dash cover should have list or look in the owners manual

Sep 28, 2014 | 2006 Opel Corsa Utility

1 Answer

1.9 dti opel pick up wont start


It could be an Immobilizer fault, if the spanner /car light comes on.
If you have a spare key, try it
A Flashing spanner light normally means immobiliser fault hence the non-start. The spanner light left might just be an indication that it has stored the "wrong transponder" code.
Opel will have to clear this but you might need a CIM as well that is the bit that reads the key to allow it to start.
Try the spare key if you have one

On 1.7 DTi models, a defective solenoid in the pump can cause failure of the ECU due to excessive current draw causing components to burn out. but this *should* cause other fault codes to appear.





.

Jun 08, 2014 | 2004 Opel Corsa

1 Answer

Where is the earth wire right indicator light of opel corsa 2003 sport 1.6 situated on car


follow the wire's back from the bulb holder , the earth wire will be the one that is bolted to the car body/chassis , earth wire's are usually black

May 21, 2014 | 2003 Opel Corsa

1 Answer

2008 opel corsa easytronic getting very sluggish and engine over revs at times and the yellow sign "spanner through car " came up on dash and stayed on?help


check the condition of the transmission oil . If it is not cherry red have it replaced. Run fault codes for faulty TCM unit or other sensors/servos for failure.

Nov 03, 2013 | Opel Corsa Cars & Trucks

1 Answer

Opel corsa ac relay problem


I had the same problem with my Corsa Lite Sport. Try turning the ignition key slightly counter-clockwise when you hear the clicking.

Jul 13, 2012 | 2005 Opel Corsa 1.4

1 Answer

HI HAVE A ENGINE FAULT LIGHT ON...PICTURE OF A SPANNER SIGN... DID REPLACE THE RADIATOR THE OTHER DAY...HOW DO I REST THIS? car 1.4l opel corsa bukkie...


Disconnect positive terminal on battery, bridge the positive lead to earth for 2 - 3 seconds (this clears the codes) then reconnect.

Job done :o)


Lloyd

Aug 21, 2010 | Ford Aerostar Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...