Question about Cars & Trucks

Open Question

Toyota vienta Stn Wagon tail light removal - Cars & Trucks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Legacy wagon tail light replacement

The one thing youll find with subaru's is that they like to put nuts in funny places that are hard to access. There are either 3 or 4 nuts holding the tail-light assembly in place, which means youll need to take out most of the inner panels to access the others. You should not need a sealant unless the rubber seal is done for or there is water inside the car. Hope this helps

Posted on Dec 09, 2008

  • 133 Answers

SOURCE: tail light replacement

hi sue from the boot side behind the carpet  

Posted on Jan 10, 2009

  • 112 Answers

SOURCE: Where is the tail light sensor located on a 1995

if its what i think it is its the stoplight sensor it locaded under your brake pedal you can try that

Posted on Dec 18, 2009

kirkx
  • 2019 Answers

SOURCE: Want to demobilise automatic door lock

Easy enough to do. You could identify the fuse that does this, or disconnect the wire from the speedometer, or pull and tape one of the solenoid wires in all of the doors. Depends on which is easiest.

Posted on May 07, 2010

Suzman
  • 642 Answers

SOURCE: when i turn on my

The number plate light works on the same circuit.Did you check this as well?
If this does not solve the problem you will need to trace the wiring for the taillights as it is shorting out against the bodywork somewhere. Start at the taillighht connector and work you way forward. Lots of patience will be required for this job.

Posted on Oct 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 15amp fuse keeps blowing with the tail lights and instruments on a 1993 Toyota corolla DX station wagon. Any help would be good. Thanks


take out both tail lights and look for a power wire that is broken and grounding out on the tail light fixture. Hope rhis helps.

Dec 15, 2012 | Cars & Trucks

1 Answer

Passenger tail light does not work on 91 corolla wagon but the brake light does ?? put new bulb in and checked the fuse but both are good


Either there is a bad ground (wire) for that bulb or the positive wire is shorting to ground somewhere before reaching the socket. Check connectors/sockets for corrosion as well. It's common at tail light fixtures.

Feb 10, 2011 | Toyota Corolla Cars & Trucks

1 Answer

When i turn on my head lights on i blow my tail light fuse (i disconneceted my tail lights and still blow the fuse again)toyota vienta 1995


The number plate light works on the same circuit.Did you check this as well?
If this does not solve the problem you will need to trace the wiring for the taillights as it is shorting out against the bodywork somewhere. Start at the taillighht connector and work you way forward. Lots of patience will be required for this job.

Oct 15, 2010 | Toyota Camry Cars & Trucks

1 Answer

1996 Camry Tail ights not working


So its a wagon? or I dont know what S/W is. If the license plate light works, the light failure sensor could be bad. It should be in the left rear corner area and have 4 wires. Green, Light Green, Yelow/Green and White/black. You should have power on the Green going into the box, and the Light Green out to the tail lights. If you have power on the Green, but no power on the Light Green, then the box is bad, either replace the box, or you can just connect the Green to the Light Green wire to get tail lights operating.

May 12, 2010 | 1996 Toyota Camry

1 Answer

Want to demobilise automatic door lock


Easy enough to do. You could identify the fuse that does this, or disconnect the wire from the speedometer, or pull and tape one of the solenoid wires in all of the doors. Depends on which is easiest.

May 07, 2010 | 1998 Toyota Camry

3 Answers

Problems with lights and steering in '97 Subaru Impreza Wagon


there ie a switch for parking lights on top of steering column ..i bump it all the time!

Sep 28, 2009 | 2007 Subaru Impreza Outback Sport Wagon

1 Answer

I loss my remote control of my 1997 toyota vienta


You will need to have it towed to the dealer.

Jun 03, 2009 | 1997 Toyota Camry

1 Answer

Legacy wagon tail light replacement


The one thing youll find with subaru's is that they like to put nuts in funny places that are hard to access. There are either 3 or 4 nuts holding the tail-light assembly in place, which means youll need to take out most of the inner panels to access the others. You should not need a sealant unless the rubber seal is done for or there is water inside the car. Hope this helps

Nov 02, 2008 | 1997 Subaru Legacy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...