Question about 2001 Oldsmobile Alero

1 Answer

My 2001alero has been leaking oil. I was driving down the road and it didn't have any power. Ipushed the gas pedal to the floor and the car didn't Rev up at all and it acted like it wanted to shut off

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Oldsmobile Master
  • 5,370 Answers

Click this link below for oil leak and rev issues:-----http://repairhelpcenter.blogspot.in/2012/02/car-has-oil-leak-and-shuts-off-at-rev.html
For oil leak problem,click the link below.This are direct hel links to troubleshoot the problem :-----
Common Causes of Car Oil Leaks?http://schematicsdiagram.blogspot.com/2011/12/common-causes-of-car-oil-leaks.html
----------
Troubleshoot Car Oil leak?http://schematicsdiagram.blogspot.com/2011/12/troubleshoot-car-oil-leak.html
---------
leaking oil from oil pan?
http://howtobyme.blogspot.com/2011/11/kia-sportage-leaking-oil-from-oil-pan.html
-----------
Car Turns OFF due to low oil pressure warning light?http://schematicsdiagram.blogspot.com/2011/12/car-turns-off-due-to-low-oil-pressure.html
----------
leaking oil from timing cover?http://technoanswers.blogspot.in/2012/02/toyota-corolla-leaking-oil-from-timing.html
-----------
How to Check Differential Oil Leaks and Replace Oil
http://schematicsdiagram.blogspot.com/2011/07/how-to-check-differential-oil-leaks-and.html
-----------
Car oil leak?
http://schematicsdiagram.blogspot.com/2011/12/car-oil-leak.html

-----------
Car oil leaks from valve cover gasket?http://schematicsdiagram.blogspot.com/2011/12/car-oil-leaks-from-valve-cover-gasket.html
---------
Oil leaks from air filter ?http://technoanswers.blogspot.com/2012/01/oil-leaks-from-air-filter-on-ford.html
----------
Rear oil seal leaking?http://schematicsdiagram.blogspot.com/2011/12/rear-oil-seal-leaking.html
----------
This will help.

Posted on Feb 13, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My clutch goes all the way to the floor I have a standard Camaro 96 3.8


clutch pedals are suposed to go all the way to the floor , you sure you dont mean brake pedal (cus thats bad ! ) clutches should travel all the way to floor and release the "grab" of the engine about 2/3 down , this way they are more smoothly allowing shifting thru the gears and not jerking as you shift thru the gears , if clutch pedal does not start to "grab" the engines power by 2/3 off the floor and fully "grab"its power all the way up(slipping) ,and you have a hydraulic clutch (96's do) then the clutch disk may require replacement or there is a oil leak in the clutch/master/slave cylinder , look for small oil leaks from under car in area of foot pedals
clutches should be replaced as an assembly that includes , disk ,pressure plate, throwout bearing , with engine side clutch plate magnafluxed for heat cracks and any hydraulic oil leaks replaced or repaired

Mar 12, 2015 | 1996 Chevrolet Camaro

1 Answer

I have a 2001 buick regal ls, the problem I'm


Have a look for a hole in the block where the oil is coming from. If you have one you have blown a motor.

May 26, 2013 | Cars & Trucks

1 Answer

Why dosent my car advance when i step on the gas pedal


From what you say Daniel, your kickdown cable need's to be adjusted, here's how :

Down at the pressure lever on the front of the trans, loosen off the cable retaining nuts so there is a little slack in the cable.
then start taking the slack out of the cable a little bit at a time;
Rest a long screwdriver on the end of the pressure lever, holding the screwdriver with one hand start opening the throttle with your other hand.

Just at the point the idle RPM barely rises, the pressure lever should just barely move.

Driving test; Going along a level road at 25 mph light throttle, floor the gas pedal.
The trans should downshift to first gear.

repeat the same drive at 28 mph, floor the gas pedal, the trans only downshifts to second gear.

Sep 10, 2012 | 1990 Honda Accord

1 Answer

Does anyone know how much it costs to replace the computer in my 2004 Trailblazer


Don't start replacing parts until you know for sure what has failed. I would say that the PCM is not the problem here. As far as the gas pedal is concerned, it sounds like you may have a broken linkage at the pedal, these trucks do not have a cable but only a rheostat that the computer reads.
The tachometer and speedometer problem could be a bad cluster.
You need to see a good mechanic to get a diagnosis.

Sep 01, 2012 | 2004 Chevrolet TrailBlazer

1 Answer

My brake pedal goes all the way to the floor


Brake pedal goes to the floor? When does it happen. That is the most important piece of information. Most brake systems are power assisted via vacuum from the engine. Your brake booster is what makes the "power assist" work. There are some specific times when you will feel your brake pedal "fade" to the floor and it is normal due to the cycle of the brake components operation.If your brake pedal goes to the floor every time you step on it, stop driving and get to a repair facility! If the pedal is working when driving and the vehicle seems to be working as it always has, then chances are there is no concern. To be on the safe side, have it checked the next time you are in for any other type of service.There is a sensor inside most brake reservoirs that activates the indicator light in your instrument cluster when the level is lower than it should be. As your brake pads wear down, the system requires more fluid so the level at the reservoir drops setting the light. Same thing if there is a leak. The fluid level drops and the light goes on. This brake fluid leak would most likely be combined with a spongy pedal or a pedal fade every time you step on the brakes. A leak would also almost always have a wet area around the leak. Sometimes the leak can be internal to a part of the car you cannot see, so don't count on it.One easy way to check most brake boosters and the brake system for leaks is to turn the vehicle off and pump the brake pedal. Every time you depress the pedal you should feel the pedal "height" come up and the pedal get harder. After a few firm pumps of the pedal, hold it down. Leave pressure on the pedal for 20 seconds or so. Does the pedal move slowly (or quickly) to the floor? If so then there is a leak somewhere in the system. Keeping pressure on the brake pedal, start the vehicle. Does the pedal no drop? It should. That is the power assisted vacuum kicking in as the engine starts to run.The bottom line is that we are talking about your brakes. Your life, your passengers lives and the lives of others on the road around you depends on that system working properly. If you have any doubts, or feel uncomfortable, take it in to have it looked at. Know specifically what it is doing so that you can have your repair facility look at what you are feeling and tell you if

Oct 29, 2011 | 1987 Nissan Pickup

2 Answers

I was parked on the side of the road in my ford ranger ute for about 3 to 4 minutes with the clutch pedal to the floor i was on the phone and then i could smell the clutch burning. I took my foot off the...


The clutch might be a hydraulic system. When it's leaking oil the pedal sticks to the floor and has to be pulled back manually. Because it's designed to be fail safe, it still works but only for some time till all the oil has leaked out.

The burning smell might be clutch oil dripping on the exhaust - meaning the seal on the clutch servo is leaking oil.

There are repairkits for clutch servo's - usually it's suggested to replace the cylinder seal on the clutch pedal also.

Jul 01, 2011 | Ford Ranger Cars & Trucks

1 Answer

Stuck clutch


The clutch has rusted to the flywheel drive the truck down the road you will have to start it in gear (1st) while driving push the clucth pedal to the floor and keep pushing up and down on the gas pedal to get the truck to rock forwards and backward the clutch should brake loose.

May 29, 2009 | 1991 Toyota 4Runner

1 Answer

Hopefully NOT a transmission problem!


First I would check fuel pressure.

May 05, 2009 | 1996 Nissan Sentra

1 Answer

Car began to lose power while on freeway then stopped


Sounds like the alternator is going bad and killing the battery.

Apr 02, 2009 | 2001 GMC Yukon Denali

Not finding what you are looking for?
2001 Oldsmobile Alero Logo

535 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...