Question about Lincoln Town Car

Open Question

How to remove the centre arm rest between front seat of 1997 lincoln town car

1997 lincoln town car, double center arm rest seems to be broken. would like to know how to remove them, to be able to fix them

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 6 Answers

SOURCE: fuel pump in a 1997 town car

i have successfully fixed my problem. the pump is located at the front of the fuel tank and is accessible without, i repeat WITHOUT removing the tank.

Posted on Sep 30, 2008

  • 373 Answers

SOURCE: 1997 Lincoln Town Car washer fluid light on panel.

replace fluid tank. might find it cheap in a junkyard

Posted on Apr 06, 2009

  • 365 Answers

SOURCE: Cehc engine light is on in our 1997 Lincoln town

THEY (2-3) are an absolute PAIN to change...try running "SeaFoam" in the tank for 100 miles or so first. Avaialble at Advance Auto Parts $8. follow directions
Good Luck

Posted on Jun 22, 2009

  • 34 Answers


The inertia switch should be located in the trunk, on the right-hand side, behind the feltlike trim material.

Posted on Jul 09, 2009

  • 105 Answers

SOURCE: How do you change the door hinge pin? On 1997 lincoln town car?

you really don't change the pin,...change the whole hinge,...junkyard! junkyard! good luck, cracklin joe

Posted on Jan 08, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Removing the seat back cushion from my 1997 Lincoln Town Car

The seat bottom needs to be removed before the seat back, and you can't get around that. You'll have to put your hand on the front vertical portion of the cushion near the floor of the car, and push it towards the rear about 1 inch, then push it up away from the floor. Your hand should be located at the center of where a passenger's body would be. Repeat for the opposite side. Once the seat bottom is out of the way you can access the bolts that hold the seat back in place, and then that cushion needs to be pulled up towards the roof.

Dec 15, 2016 | Lincoln Cars & Trucks

1 Answer

How to remove front middle arm rest 1998 lincoln town car?

Easiest way is get a hacksaw and cut the rod its attached to on both sides.

Only other way I can see doing involves removing the all seats.

Oct 29, 2015 | 1998 Lincoln Town Car

1 Answer

Wiper arm

Yes you can, it is splined so you can put it where
ever you like

Remove the plastic cap-- then the nut

Apr 10, 2014 | 1990 Lincoln Town Car

1 Answer

How to remove a 1997 town car executive drivers seat

To remove the back seat of a 1997 Cadillac Eldorado, push very hard at the center of each back seat (left and right seat) towards the back of the car. Then, while pushing back, lift up. It will pop out of its catch.-------------------------------------------------------------------------------------

Feb 19, 2013 | 2001 Lincoln Town Car

1 Answer

1990-1997 parts interchangeable. I have a 1990 linc cartier. need to know if i can put in a 1992 front arm rest w/ beverage holder

i had a 97 and yes the are the same cars, make sure seating options are the same though, good luck.

May 07, 2011 | 1990 Lincoln Town Car

1 Answer

The pitman arm is so tight that I broke a removal tool trying to get it off, what can I do to get a stuck on piyman arm off from a 1997 lincoln town car?

Put as much pressure as you dare on it with a puller then a couple of good wacks with a brass hammer will do the trick.

Feb 21, 2011 | 1997 Lincoln Town Car

3 Answers

I replaced the wiper control module and while I did that the wipers were in the up position. Now the new module is in and they are operating but come to rest in the upright position. Do I need to remove...

Perhaps, you could remove the arms and reset them, but, I am curious, did you replace the 'windshield wiper motor?' I was always taught that if the wiper arms did not come to rest in the right resting place, that the wiper motor was at fault.

Good luck on this repair.

Feb 05, 2011 | 1997 Lincoln Town Car

1 Answer

1997 lincoln town car..pas. seat goes foward but wont go bakwards...any help

Try pushing back as you work the switch forward and backward. The most likely problem is a stuck runner. Remove the two front bolts and the two rear nuts from the seat legs and tilt the seat backwards to clean and lubricate the runners

Oct 11, 2009 | 1997 Lincoln Town Car

1 Answer

Removing front headrest from 1995 bmw328i


to do this you need to remove two plastic pins that hold it. it is a good idea to put the leaner s on the front seats right down and leaver it with a screw driver. why are you removing the arm rest? with the arm rest removed the centre console is going to look ugly

Oct 05, 2008 | 1997 BMW 328

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts


Level 3 Expert

80407 Answers


Level 3 Expert

5687 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides