Question about GMC Cars & Trucks

Open Question

My 2003 tracker seat belt is stuck in the cold

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1382 Answers

SOURCE: Seat belt stuck

Open small plastic access panel located between front and rear doors a few inches above floor. Disconnect the two wire connector (usually attached to car frame) and locate the male pin connector, usually 1 red and 1 blue wires. Run two long wires from a car battery negative post and positive post (battery on the car or separate.) Hold one wire against one pin of the connector and quickly touch the other wire against the remaining pin. This will cause the motor to turn in one direction. If motor turns in wrong direction simply reverse the wires until motor brings belt to desired position then quickly remove the wires. Reattach connectors to resume 'normal' operation after 'CAUSE' has been repaired.

Posted on Aug 27, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Stuck seat belt


Most seat belts have to be retracted first before they will pull out for fasting. Try to push the seat belt back into the recoil unit (the unit that winds the belt up when not in use) and then pull it back out. There may be something binding the belt stopping it from backing into the recoil unit; look at the plastic trim around it, seat covers ect.)

Apr 21, 2014 | 2002 Chevrolet Tracker

2 Answers

My drive side seat belt is stuck on my 2001 chevy tracker, any suggestions?


Unfortunately the seat belt must be replaced the mechanism that control it is stuck and cannot be release.

Mar 28, 2012 | 2001 Chevrolet Tracker

1 Answer

How to replace timing belt on a 2003 chevy tracker


Open the hood and locate the accessory belt routing diagram that is stamped to the top flat surface of the radiator shroud. Use the routing diagram to properly route the new belt around each accessory pulley.
Look on the front of the engine between the alternator and the power steering pump and locate the automatic belt tensioner. Use the pulley that is attached to the end of the tensioner to loosen the tension from the belt.
Position a breaker bar and a 14 mm socket onto the bolt head in the middle of the tensioner pulley. Turn the breaker bar clockwise to loosen the tension from the belt. Slide the belt off of the tensioner pulley and slowly release the breaker bar.
Slide the belt out from around all of the engine accessory pulleys. Pull the belt around each of the fan blades and up out of the engine compartment.
Slide the new belt around each of the fan blades and around each of the accessory pulleys as directed by the belt routing diagram.
Turn the tensioner clockwise with the breaker bar and the 14 mm socket again. Slide the belt around the tensioner pulley and slowly release the breaker bar. Pull the breaker bar and socket off of the tensioner and out of the engine compartment.
Crank the engine for ten to fifteen seconds to finish seating the ribs on the inside of the belt to the grooves of each accessory pulley. Turn the engine off.

Feb 20, 2011 | 2003 Chevrolet Tracker

2 Answers

Had to cut seat belt.Can it be fixed?


no,it has to be replaced most likely to locate perfectly good one from salvage yard alot cheaper than from dealership if not discontinued already.there is no approved repair for severed belt and besides let,s just say you,re daughter uses tracker to go to store and involved in collision want to take a chance on that repair NOT ME !!!

Jul 21, 2010 | 2001 Chevrolet Tracker

1 Answer

My seat belt wont go back to its place is stuck is a 2003 for explorer xlt


It's the seat belt re tractor needs replacement.

Good Luck!

Feb 07, 2010 | 2003 Ford Explorer

1 Answer

Seat belt stuck


Open small plastic access panel located between front and rear doors a few inches above floor. Disconnect the two wire connector (usually attached to car frame) and locate the male pin connector, usually 1 red and 1 blue wires. Run two long wires from a car battery negative post and positive post (battery on the car or separate.) Hold one wire against one pin of the connector and quickly touch the other wire against the remaining pin. This will cause the motor to turn in one direction. If motor turns in wrong direction simply reverse the wires until motor brings belt to desired position then quickly remove the wires. Reattach connectors to resume 'normal' operation after 'CAUSE' has been repaired.

Aug 27, 2009 | 1992 Ford Thunderbird

1 Answer

Stuck 99 chevy tracker seat belts


take them out and unclip the plastic covers and clean and dry lube them

May 29, 2009 | 1999 Chevrolet Tracker

1 Answer

Serpentine belt


mine only has 34kms, the belts cracked, its only 19.00$

Jul 20, 2008 | 2003 Chevrolet Tracker

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...