Question about 2006 Honda Odyssey

Open Question

Replace bulb in seat heater switch

The bulb for the passenger side seat heater switch is not working. The HI and Low lights work. How can I replace the bulb myself? thanks

Posted by on

  • 1 more comment 
  • solongjoe Dec 11, 2008

    The passenger side Hi indicator is out. They replaced the seat heater in the passenger side saying voltage was fluctuating under Honda Care, but the bulb was not covered!

  • ajohnsman Dec 14, 2008

    I have same problem with heated seat switch o6 honda odyssey any help how to replace or what to remove to replace would be great

  • Anonymous Feb 19, 2009

    In my Acura MDX 2006, Heated seat indicator bulb on driver's side is not working. Can any one help me to fix that?

×

6 Suggested Answers

SOURCE: seat heater switch back light bulb

http://www.beaufordbuddy.com/ipod_install_1.htm

Posted on Aug 23, 2008

j_del
  • 1586 Answers

SOURCE: burned out headlight/bulb bmw 1991 325i 2dr

It's a bulb replacement. If it's anything similar to my Audi, there is a cover on the back of the headlight housing that you pop off. Then you can reach in, pull the wire connector off the bulb, and unclip a metal retainer over the bulb, and pull the bulb out. Installation of the new one is the reverse. Just be SURE not to touch the glass part of the bulb. Skin oils can cause a halogen bulb to burn very hot and burn out very quickly. If you do touch the glass, wipe it gently but thoroughly on a cotton cloth to clean it off before you install it.

Posted on Oct 31, 2008

  • 1 Answer

SOURCE: 2006 Trailblazer Headlight Replacement

There are not two rods, there are two clips one under fender weild and one right above the light on top of the cover. Pull up on these two clips and pull the light forward a couple of inches and remove the dust cover. You have to take the air filter cover off to be able to reach in and replace the light. It took me about 10 min to figure these out but hope it helps out.

Posted on Jan 14, 2009

chuck943
  • 783 Answers

SOURCE: replace passenger side low beam bulb in a 2003 lincoln aviator

Open hood and remove the radiator site shield and the air delector on top of the headlamp assembly. You will then see 2 clips that you will pull up and then remove the headlamp assembly.

Posted on Apr 11, 2009

  • 5 Answers

SOURCE: 1991 Honda Accord brake light probelm.

Check the prones inside the connector that you plug into the brake light module. You may have to squeeze, wiggle, tilt each one to see which one is not connecting all that good. I know it may sound confusing. I tried to explain the best of I could.

Posted on Apr 29, 2009

  • 117 Answers

SOURCE: Electric seats won't move - Silverado 1500

depending on what year truck it is, there is a 40-60amp maxi fuse in the underhood fuse block that can also blow, the harnesses get stuck on the backside of the seat tracks and blow the underhood fuses.

Posted on Jul 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The low beam on passenger side does not work,high beams work on both sides


Hi Greg:
I'd pull the bulbs from both sides and switch them.
You'll know right away if the bulb is the problem.
If low beam on the passenger side still does not work, then there is either a broken wire or bad connection. Make sure the area where the bulb fits into the socket is clean.
Usually there is only one bulb that has both high and low beam.

May 27, 2015 | 2005 Cadillac Deville

1 Answer

Once again new problems. 2000 Dodge Status SE 2.4 DOHC 16 Valve; 1) tape player makes noses and won't eject adapter I use to play music thru my phone. Also can't use my last station pre set button because...


Sounds like you have had a lot of fun with this rig
#1 - replace the stereo - that's cheaper than sending yours out for repair.
#2 - Make sure your cooling system is full. You can get an air lock/bubble in the heater core that is really difficult to resolve sometimes. When the cooling system starts to get low on coolant - the heater core is the first to get starved. Physically feel the temperature of the heater hoses at the firewall - they should both be hot - if one is hot and the other not - there is a restriction in the heater core. If neither are hot - your coolant level is probably low. With the engine running you can pinch the upper radiator hose which should force flow through the heater core. Try those things - if you get sufficient heat from other modes - i.e. DEF VENT then your coolant level is not an issue. your controls are your problem - and is this a Auto Temp control system (digital) or manual?
#3 sounds like the ground circuit for Pass side Brake light is not sufficient. Works OK until the park light is turned on. I presume a bulb from the drivers side that worked ok doesn't on the pass side (known good bulb) - the ground circuit needs repair.
#4 the illumination issue - Dash lights/buttons/switches - all those should illuminate together (dimmer controlled)
Radio buttons - refer to #1
Console symbols - wiring connections for the bulbs
Dome lights working ok from rear doors and not the front - probably issues with the front door switches
that's a lot of different things for one car

Sep 09, 2014 | 2000 Dodge Stratus

3 Answers

One low beam head lights will not work, high beam works though


check for a damaged wire for the low beam. Also wouldn't hurt to check the ground wire as the high beam will try and ground through the low beam but not visa verse

Dec 29, 2013 | 1997 Chevrolet Blazer

1 Answer

Passenger light bulb


passenger side seat has a switch built into it that says someone is setting there. may be faulty . or something under the seat pushing up against it. simple fix snap the seatbelt on the passenger side. switch will have a wire connection under the seat, replace switch if need be. brake light blinking this could be simple as the emergency brake isn't fully released or it may be low on brake fluid. also some cars tell if a bulb is blown

Oct 03, 2013 | Dodge Neon Cars & Trucks

2 Answers

Passenger seat heater doesn't work on lexus es300


The heater its self needs to be replaced in the seat

Dec 28, 2011 | 1998 Lexus ES 300

1 Answer

Heated seats do not work


First off, I would contact your local Jeep dealer and have them run your VIN # to check for any recalls. The 1999-2004 Grand Cherokees had a recall on the seat heaters. If your vehicle doesn't fall into the VIN # range then either your seat heater switch has gone out, or you have a broken element in the seat heater. I have replaced more seat heaters than switchsm the elements heat up and break. Hope this helps out.

Best of luck

Jun 16, 2010 | 2001 Jeep Grand Cherokee

1 Answer

Driver seat heater only stays on for 15 seconds. If I only turn passenger seat heater on, passenger side works fine, when i add drivers side, both shut off. 2005 1500yukon XL Also heater blower just stoped...


No biggy.The seat heater can be repaired by the dealership.Should not cost much because there are no parts just a reprogram of the drivers seat module.The blower motor is the blower motor resistor module.It is on the passengers side under the dash next to the blower motor.You should be able to do this yourself if you have a little mechanical experience.Hope this helps.Good luck.

Jan 29, 2010 | 2003 GMC Yukon XL

1 Answer

Driver side seat heaters


This is a common problem, if the lights come on the switch ( which confirms your relay is working) then it is the heater in the seat itself. Dealer only part.
Hope this helps

Jan 12, 2009 | 2005 Ford Freestar

Not finding what you are looking for?
2006 Honda Odyssey Logo

Related Topics:

1,241 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...