Question about 2008 Nissan Quest
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1999 nissan quest
Rigoe the points for the timing belt are usually located on the sprokets in conection with marks or dots on the engine block some where around the sprockets that hold the timing belt. Remenber to bring the piston number one to TDC (top dead center), this means you have to locate the piston number one, take the spark plug out and turn the cranshaft (the one with the pulley) by hand until the piston is all the way up. On the distributor the rotor should point to the spark-plug wire number one (you can make a mark outside of the distributor cap where the number one spark-plug wire is pointing so when you take the cap off you can see if the rotor is pointing the same direction). With the timing belt cover off you are going to be able to aling all this points at the exact locacation all together. So we have: Piston number one at TDC, The rotor(enside the distributor cap) pointing to the number one spark-plug wire, and the mark of the sprockets pointing the marks of the engine block( litle dot or dash). If you get all this right you are have done a good job and ready to make a trip you can get all this just by turning the cranshaft by hand with a rachet and a big socket. God bless you.
Posted on Apr 11, 2009
The camshaft sensor is located inside the distributor and is part of it, in order to replace it you must replace the distributor,to replace remove the dist cap. mark the location of the rotor,by marking where its pointing to, then mark the dist housing, so now theres a mark on the rotor and housing to show where rotor points, next mark the location of dist going into housing, mark the shaft and the block,because it spins in block this way you can line back up.next remove hold down bolt and pull out,mark the new dist in exacat same spots as the old so you can install back the same,you may have to put it in and pull it out until your marks are lined up,this way the timing will be dead on, when done you can check timing. good luck
Posted on May 09, 2010
SOURCE: Where is the spare tiure
its behind the front seats inside of the floor. you have too move front seats forward and second row seats back and ligt up the carpet between front and second row seats and there it is, spare tire.
Posted on Nov 18, 2010
Tips for a great answer:
Dec 18, 2014 | 2008 Nissan Quest
Jul 16, 2014 | 2008 Nissan Quest
Sep 16, 2012 | 2008 Nissan Quest
Dec 06, 2010 | 2004 Nissan Quest
Nov 30, 2010 | 2008 Nissan Quest
Nov 17, 2010 | 2008 Nissan Quest
Mar 19, 2010 | 2008 Nissan Quest
May 02, 2009 | 2002 Nissan Quest
278 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: