Question about Honda Cars & Trucks

Open Question

How to fix a sun visor that keeps coming down on a 2003 honda crv suv

Just drops down when it wants

Posted by Anonymous on


5 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 119 Answers

SOURCE: Sun Visors won't stay forward towards windshield

inside the sun visor there is a spring which is moving to side when you push down the spring pushes side so it will keep down when you want to push to the normal possition spring releces and keep to that possition any way i would like to advice you to replace sun visor.

Posted on Nov 28, 2008

  • 1 Answer

SOURCE: Sun visor on driver's side

I had the same problem with my 2007 Sonata. I took it into the dealership and they were aware of the problem and fixed it.

Posted on Feb 14, 2009

  • 204 Answers

SOURCE: Sun visors won't stay flipped up.

most of the times on the visors if you look at were it mounts on the car you will see a small screw this is a set screw and if you tighten it just a little bit it should hold your visor up for you. but not all vehicles have a set screw as iam talking about. and if the impala dosent you need to get a compleat new visor
hope this helps you out

Posted on Apr 30, 2009

  • 2976 Answers

SOURCE: driver side sun visor falls down

If you have anything on top of the visor, remove it. If there are any screws visible near the pivot rod, tighten them. You can remove the visor and slightly bend the pivot rod, inside the visor. You can just buy a new one and replace it yourself. It's only a few screws.

Posted on Sep 16, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

How to replace a rover75 front stabiliser drop link

Well is a very had work to do u will have to lose the beam down for you to have space to lose it the bolt are turn upside down normal cars are been losed upward but for rover is down so you lose the beam down and you get to the stabilizer linkage I hope this help

Apr 05, 2014 | 2000 Rover 75

1 Answer

'99 silverado 5.3 engin will not idle runs at 2500 rpm and drops down to 1000 rpm the back up to 2500 rpm -------------------------

which car is it?

problem with 1993 Geo Prizm '99 silverado 5.3 engin will not idle runs at 2500 rpm and drops down to 1000 rpm the back up to 2500 rpm -------------------------

Apr 15, 2013 | 1993 Geo Prizm

1 Answer


you have to climb over back seat and pull panel off tailgate pull the motor out and let window down by hand .

Sep 16, 2012 | 1989 Ford Bronco

1 Answer

I have a 2003 mazda rx8 its a manuel anyway il be driving in 5th gear and il put my foot down and the rev needle will shoot up and then drop back down while my speed

Yes it is the clutch slipping, in high gear the greatest load is put on the clutch so that is when they slip the most.

Mar 16, 2012 | 2004 Mazda RX-8

1 Answer

When Running Current of the car goes down,and it Idles down...

this is normal to an extent. normal wear and tear will cause the altenator to drop voltage. at some point it will start showing on the gauge that drops as the engine speed drops. just watch and see when it starts to drop below 12 volts. time to change the altenator

Jun 14, 2010 | 2005 Suzuki Verona EX

2 Answers

Removing the oil pan from a 1994 vw jetta

you have to remove the oil pan without the gasket because the gasket is attached to your oil pan baffle and that can't be removed until you unbolt your oil pump. i pried the **** out of mine until i realized the gasket couldn't come with it. no haynes manual will explain it as simple as it could be, i hate those books

Jul 24, 2009 | 1994 Volkswagen Jetta

1 Answer

How do Install a distributor on 1994 Chevrolet caprice

to instal the distributor you need to have number one cylinder on top dead center . on compression stroke. Then when you put the distributor in. and you need the rotor pointing at number one spark plug wire.. Drop it in and it will turn it might turn too much when you drop it so pull it back up and drop it in back a notch till it drops in pointing at number one spark plug wire on the distributo cap.. .. sometimes they wont drop in all the way so you have to hold down on it till someone turns the engine over to make it drop on down about 1/2 inch more. I guess first thing you should do is follow number one spark plug wire to the distributor and mark it down below the cap on the metal part of the distributor.. number one cylinder on a chevrolet is if your standing in front of the car with the hood open its the first one on your right. say holler if you have more... Jerry

May 02, 2009 | 1994 Chevrolet Caprice Classic

1 Answer

Honda CR-V - 2004 - High RPM not returning to Idol RPM ????

i'am no expert on this car, but i would chk. the T.P.S. (throutle positioning sensor) there also may be carbon build up on throutle butterfly, not letting it close completely when you take your foot off the pedel.

Jan 14, 2009 | 2001 Honda CR-V

1 Answer

Rpm drops down when acu is turned on

Are you turning on the compressor (as in turning on the air conditioning) or just the vent? If you're turning on the compressor and the revs drop, that's normal. The compressor is driven by an engine belt, and when it is turned on, it puts additional drag and load on the engine, causing the revs to drop.

Oct 31, 2008 | 1998 Nissan Sentra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

390 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

78257 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides