2007 Chevrolet Uplander LS Minivan Logo

Related Topics:

A
Anonymous Posted on Feb 12, 2012

Chevy Uplander door chime

How do you silence the door chime?

5 Related Answers

dgnoid

  • 84 Answers
  • Posted on Jun 23, 2009

SOURCE: 2006 Chevy Uplander. The power sliding doors won't shut

2 possible solutions. First clean the door pin contacts(multiple spring loaded pins on door side and matching plate on body) with a scotch pad until shiny gold color again. Second the rear edge of the door should be 1mm inside the body opening when closed. If those are correct it is going to take a software download from a dealer to the door control module to fix this. Otherwise you will have to pull the psd fuse and breaker from the right side dash fuse box.

Ad

Robert Sonmor

  • 58 Answers
  • Posted on Oct 28, 2009

SOURCE: Chevy Uplander (2006) when sliding doors are

One or more of your sliding door may have lost their learned opened/closed position.Also the door may be binding,obstructed or need a latch adjustment.If a relearn is required return to a GM dealership as a diagnostic scan tool is required.

ZJLimited

ZJ Limited

  • 17989 Answers
  • Posted on Feb 06, 2011

SOURCE: 98 chevy cavalier 2.2 will

It sounds like the solenoid isn't sending fire to the coil while cranking. When cranking the voltage comes to the coil from the starter to by pass the coil resistor. Once cranked it starts going through the resistor to keep excess voltage from frying the coil.

Anonymous

  • 3301 Answers
  • Posted on Sep 10, 2011

SOURCE: door chime on 2007 chevy uplander will not stop

check the door switches for a short

Anonymous

  • 3301 Answers
  • Posted on Sep 10, 2011

SOURCE: door chime on 2007 chevy uplander will not stop

unfortunately the fuse that runs the chime also runs other items on that circuit so pulling the fuse isn't an option, basically what you need to do is check each door switch , one is shorted, and is in the open position,, they are located at the side rails of each door, remove the deco rubber trim, and you will see that a screw holds them on, they pop right out, with a meter, check each switch for continuity with the switch in the OUT position, when the switch is depressed, you should get no reading, since that closes the circuit, you can either replace the bad switch, ( sometimes they just get stuck,m so move them around and spray some electrical contact cleaner on each one) BY the way,, on this model of vehicle, there have been a number of issues with the sliding door latch ,, here are some of the issues ,, http://www.lemonlawclaims.com/Chevrolet_uplander_sliding_door.htm

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

HOW DO YOU SILENCE A CHIME WORNING BELL?

There is a BLACK/PINK thin wire going up into steering column. Cut that to silence the chime when your key is in the ignition. Or before doing that locate the chime module under your dash (just follow the sound) and unplug the module from the connector and that will do it.
3helpful
2answers

Door chime on 2007 chevy uplander will not stop even when the door is closed properly. Is there anyway to disable it

unfortunately the fuse that runs the chime also runs other items on that circuit so pulling the fuse isn't an option, basically what you need to do is check each door switch , one is shorted, and is in the open position,, they are located at the side rails of each door, remove the deco rubber trim, and you will see that a screw holds them on, they pop right out, with a meter, check each switch for continuity with the switch in the OUT position, when the switch is depressed, you should get no reading, since that closes the circuit, you can either replace the bad switch, ( sometimes they just get stuck,m so move them around and spray some electrical contact cleaner on each one) BY the way,, on this model of vehicle, there have been a number of issues with the sliding door latch ,, here are some of the issues ,, http://www.lemonlawclaims.com/Chevrolet_uplander_sliding_door.htm
0helpful
1answer

The security or door alarms wont shut off on 2007 chevy uplander van

Had the same problem with my 2006 Uplander.
Sanded the door contacts and the pins with 80 grit emory cloth.
They get a glaze on them over time.It solved the problem.
Peace and quiet after 3 days of chimes.
0helpful
2answers

How do you reprogram a key fob to a 2008 chevy uplander?

There are no keyless entry remote self-programming instructions for the 2008 Chevy Uplander. You must get an Automotive Locksmith to program the remote to your vehicle for you.
0helpful
2answers

Door chime on 2007 chevy uplander will not stop even when the door is closed properly. Is there anyway to disable it without disabling radio

Had this problem for some time. I have had the dealer replace motor etc. Problem still returns. Noticed that the foam seal around the right side door has started flatening out over time and was beginning to spill into the lipped plate that the door sensor buttons possibly could be prevented from making proper contact. Trimmed approx. 3/8 of an inch off the foam in the area of the plate, and the problem seems to have gone away. Hope this helps.
0helpful
1answer

Chevy Uplander (2006) when sliding doors are closed and then van is put into reverse or drive, chimes begin nonstop inside of car. How do i stop them???

One or more of your sliding door may have lost their learned opened/closed position.Also the door may be binding,obstructed or need a latch adjustment.If a relearn is required return to a GM dealership as a diagnostic scan tool is required.
9helpful
2answers

The door chime on our 2005 Saturn Relay Van continuously goes off when you put it in gear. There are no obstructions but the automatic door switch fails to open the door sometimes and other times the chime...

I have a 2006 SV6 with the power sliding doors. The problem that I found was with the contacts on the door ( They are called plungers) the movable pins were losing connection with the fixed part The plunger is very easy to replace if you can find one. The plungers are covered with a rubber cover and is held in place with 2 plastic pins. My Pontiac dealer could not even find one in his books or even a picture of one, and claimed that he had never had anyone come with a door problem. My Chevy dealer said that it came with a wiring harness that is not needed for $154. The cure that I came up with was to take the plunger block apart (it snaps together)and replace the rusted out springs then solder 3" wires to the end of the plunger pins (they solder easy) to the tabs that go to the plug(pop out the tabs or you will melt the plastic. It took about 45 min. now the doors work like new and will never loose contact again
0helpful
3answers

The electric door will not close on my 2005 chevy uplander

the latch needs to be replaced Please rate my response thank you very much
Not finding what you are looking for?

640 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...