Question about 1997 Mercury Mountaineer

1 Answer

How to replace water pump on 97 mountaineer - 1997 Mercury Mountaineer

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercury Master
  • 5,370 Answers

For water pump replacement i suggest you to check the help link provided below.

click the link below :----

Water pump replacing procedure for all vehicles?

http://technoanswers.blogspot.com/2011/11/water-pump-replacing-procedure-for-all.html
---------

HOW TO REPLACE A WATER PUMP

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-water-pump.html

------------------
How to route Water Pump Belt for 1992 Oldsmobile ?

http://carbeltrouting.blogspot.com/2011/12/how-to-route-water-pump-belt-for-1992.html

---------
How to replace Water Pump on Car ?

http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-water-pump-on-acura-car.html

---------
How to Remove Water Pump?

http://technoanswers.blogspot.com/2011/12/how-to-remove-water-pump-on-toyota.html

-------
Where is Water Pump located ?

http://technoanswers.blogspot.com/2011/12/where-is-water-pump-located-on-toyota.html

-----------
This will help. Thanks

Posted on Feb 20, 2012

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

parkerjohn
  • 130 Answers

SOURCE: what to do if water pump bolt breaks,97 mercury

You have to drill the remainder of the bolt out of the hole. Start by taking a center punch and punch the dead center of the piece stuck in the hole, then take a small drill bit and get to work on the punch hole. Use a little wd40 on the bit to keep it from overheating and go about half speed on the drill (time consuming prosses). After you drilled deep enough grab the next size bit and continue to do this until you can fit a good size extracter in the hole to pull it out. If you do not have an extracter then continue to drill untill the bolt is completly out then retap new treads and find an oversized bolt.

Posted on Sep 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a pulsating draw at battery on a 97 mountaieer


I'm unclear what you mean by "#13 stops", Chris... but a pulsating current draw from the battery MAY be turn signals or emergency four-way flashers.

Aug 11, 2014 | 1997 Mercury Mountaineer

2 Answers

Why would pontiac 2000 grand am overheat while driving in the mountains?


It could be your radiator is partially blocked or your water pump is not working properly, could also be a blown head gasket or cracked head or timing. Several things that could be causing the problem

Jun 26, 2014 | 2000 Pontiac Grand Am GT

1 Answer

There is a roaring sound from under the front end on my '97 mercury mountaineer all wheel drive


there may be sticking of mud on the brake pads, try to clean with water pressure, if not the check your bearings.

Apr 01, 2014 | 1997 Mercury Mountaineer

1 Answer

97 mercury mountaineer. won't start


hi,

watch your oil pressure when cranking, you have to have some oil pressure to get the fuel system to start. you may have to find the hot wire at the relay and energize it to see if it is indeed the fuel pump going out. if its been sitting and its a 97 the fuel pump just might have went, you can also try hitting the gas tank from the outside in the middle to see if that works too. have a water hose or fire extinguisher around when your working on fuel system and leave one of your battery cable a little loose..

jm

Jul 04, 2017 | 1997 Mercury Mountaineer

1 Answer

What to do if water pump bolt breaks,97 mercury mountaineer


You have to drill the remainder of the bolt out of the hole. Start by taking a center punch and punch the dead center of the piece stuck in the hole, then take a small drill bit and get to work on the punch hole. Use a little wd40 on the bit to keep it from overheating and go about half speed on the drill (time consuming prosses). After you drilled deep enough grab the next size bit and continue to do this until you can fit a good size extracter in the hole to pull it out. If you do not have an extracter then continue to drill untill the bolt is completly out then retap new treads and find an oversized bolt.

Sep 14, 2011 | 1997 Mercury Mountaineer

1 Answer

Is it necessary to remove the thermostat housing in order to replace a water pump bypass hose? Mechanic advises that my 2000 Mountaineer's small by-pass hose is leaking. In order to replace it, either the...


in the upper radiator hose to the engine side of an elbow with 2 screws in there is the thermostat and water pump need to remove the fan belt clucht with the fan off the bottom hose that goes from the radiator to the pump to remove the screws remove the pump the pump clean the surface and install the new pump

Aug 07, 2009 | 2000 Mercury Mountaineer

1 Answer

In 97 mercury mountaineer, how to turn off "check engine" light


Go to the local parts store, have them check the codes (they will do this for free usually). It will tell you what sensor needs to be checked/replaced. Once the part is replaced, it will clear on its own. They can also reset the code, but it will come back if the trouble persists.

May 27, 2009 | 1997 Mercury Mountaineer

1 Answer

97 murcury mountaineer blows #10 fuse


check for a short by the starter exhaust melts these wires together good luck

Sep 20, 2008 | 1997 Mercury Mountaineer

Not finding what you are looking for?
1997 Mercury Mountaineer Logo

717 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

fordexpert

Level 3 Expert

5467 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...