Question about 1993 Pontiac Bonneville

1 Answer

Where is a knock sensor on a 1993 pontiac bonneville

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 202 Answers

Usually on block between cyclinders ,,,, if its a v 4 ,,6 ..8 it will have one for each bank ,,,, like a little coil with a bolt through it ..

Posted on Feb 13, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1993 pontiac bonneville security light is flashing and wont start

when u see the security light blinking and it wont start u simply turn the switch on and leave it on till the security light stops blinking then turn the switch off and start the car up

Posted on Feb 14, 2009

  • 76 Answers

SOURCE: My 1993 Pontiac Bonneville SSE won't shift into park.

have you check the shifter linkage

Posted on Mar 07, 2009

ourhowse
  • 2007 Answers

SOURCE: 1993 Pontiac Bonneville

1. Air filter dirty
2. Bad engine ground connection.
3. Loose connection in the ignition system.
4. Faulty idle control system.
5. Faulty emissions or engine control system.
6. Fuel not reaching the injectors.

These are the 6 most common solutions. For yours, i would certainly be checking the engine ground cable, as your gauges are acting up too. Take it right off, clean the rust if there is any. Bend it back and forth every inch or so to see if there are any breaks or melted spots in it. Or, better yet, just throw it away and get a new one. Good luck, hope this helps.

Posted on May 01, 2009

  • 15 Answers

SOURCE: 1993 pontiac bonneville firing order diagram

Hope this helps!

1a8b7db.jpg

Posted on Dec 14, 2009

  • 67 Answers

SOURCE: looking for the air conditioning relay on 1993 pontiac bonneville

underneath the hood against the firewall there is a fuse relay panel.. the a/c compressor relay is the very first relay all the way to the passenger side

Posted on Jul 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need a fuse box diagram for a 1993 pontiac bonneville


On this website you find fuse box diagram and description for Pontiac Boneville (1993)


Pontiac Boneville 1993 fuse box diagram Auto Genius

Apr 22, 2014 | 1993 Pontiac Bonneville

1 Answer

I have a 1993 pontiac bonneville that goes really slow between 20 to 40mph and i have cleaned the mass air flow sensor and the problem persists. The service engine light comes off and on, and the security...


have vechicle code scan, faulty mass air flow sensor will cause engine run poorly stall out.sound like transmission could be slipping not going in over drive if vechicle cant go over 40 miles an hour.change transmission fluid and filter see it helps. mass air flow sensor has to be replaced most people try clean them but best to replace them.

Feb 12, 2012 | 1993 Pontiac Bonneville

1 Answer

Looking for the air conditioning relay on 1993 pontiac bonneville


underneath the hood against the firewall there is a fuse relay panel.. the a/c compressor relay is the very first relay all the way to the passenger side

Jul 10, 2010 | 1993 Pontiac Bonneville

2 Answers

1993 pontiac bonneville electric cooling fans relay location


Hi, check.........I need to know which fuse runs the cooling... on this forum thread. Its not a fuse if the fan turns but could be fan relay. Unplug the coolant temp sensor lovated just below the thermostat houing and see if the fans come on. If they do, it might be the coolant sensor that is bad.

Apr 13, 2010 | 1993 Pontiac Bonneville

1 Answer

I have a 1993 bonneville it is dying after the oil pressure shoot


have you replaced the throttle position sensor? then try running an oil cleaner thru it it sounds lik you have two problems here.

Dec 15, 2009 | 1993 Pontiac Bonneville

2 Answers

My 1993 bonneville keeps shutting off when i come to a stop! help please!


Could easily be a vacuum leak or a faulty throttle posiiton sensor. Is your check engine light on? If so, I would have the engine codes read to pinpoint exact problem locaiton area.

Sep 16, 2009 | 1993 Pontiac Bonneville

1 Answer

1992 ssei, stalls when it warms up and starts back up again a minute or two later. Also have a esc, knock sensor code where is the knock sensor?


Knock sensor will not cause stall, but ign module problem will. Possible you have a bad ign module, but that will be a very expensive guess. Knock sensor is next to the oil filter.

Jun 13, 2009 | 1992 Pontiac Bonneville

Not finding what you are looking for?
1993 Pontiac Bonneville Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...