Question about 1985 Toyota Pickup

1 Answer

I have a 1985 toyota pu while driving it just quit. it has no spark, changed the rotor, spark plugs, it is getting fuel any help out there

Could it be the igniter, or the pickup coil

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,212 Answers

Igniter.

The pickup coil should probably be changed too since the vehicle is as old as it is, and it is likely original.

Be sure to clean the mounting area for the igniter and use adequate heat transfer/dielectric grease on the metal mounting plate for optimum heat transfer.

Posted on Feb 13, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
stormbrewin
  • 426 Answers

SOURCE: 1985 toyota 4x4 22re missing and rough idle

Have you pulled out the spark plugs to see if there are any tell tale signs on them.They are a good indicator of many problems that occur and can save a lot of time isolating the problem.They should all be the same colour.Is the air box and lid properly secured with no leaks or splits in the intake tube.Have you put injector cleaner in the fuel tank to clear up any possible dirty injectors.Therse a few things your problem could be including engine vacuum leak which you can find by lightly spraying carburettor cleaner around suspect places such as inlet manifold and around injector seals.

Posted on Oct 24, 2008

  • 1 Answer

SOURCE: 94 toyota camery no spark

I had the same problem recently but replacing the ignition Coil under the distributor (inside) solved the problem. Also replaced the distributor Cap and rotor at the same time.

Posted on Oct 31, 2008

  • 112 Answers

SOURCE: Removing rotor on a 1991 toyota 4x4 pickup

You have to take apart the 4x4 hub to get to the lock nut for the bearings then you have to reome the hub and rotor assy,then you have to press the wheel studs out to remove the rotor,then reverse the process.

Posted on Mar 29, 2009

tragedy lok
  • 266 Answers

SOURCE: No spark on my toyota camry. Changed coil pack and

what about wires pull the wires from the plug and make sure u got fire u need to see where ur loosing ur fire if u got it there pull from other end make sure u got fire off of coli pack its either or

Posted on Jun 20, 2009

  • 11 Answers

SOURCE: 1990 Toyota Camry just stopped running has no spark but has fuel.

check the main fuses under the hood to see if any are blown

Posted on Jul 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 toyota tacoma 2.4 liter, cranks but no start, got fuel, got air, no spark. changed cap, rotor, and coil still no spark.


did you get the plug wires on correctly. check any electrical connections you may have undone. check for codes. it may be coincidental that you lost spark and a sensor may have gone bad.

Sep 25, 2015 | Toyota Cars & Trucks

1 Answer

Have a 1994 chevy suburban changed wires cap rotor ignition coil plugs no spark to plugs disturbed turns was driving home it sputtered than died well crank no start help only car I got


02 sensor is not you main problem.
Have you got good spark and fuel pressure when it acts up or quits?
Is it dead now or just acting up?

Pull the throtle body and replace the base gasket to start with.
Clear codes and see what comes back.

Check fuel pressure when it quits.
Post back fuel pressure readings.

Get some good repair info on the code for fuel pump relay and fuel pump and fuel pressure.
Let us know how it goes.

Jun 30, 2015 | Cars & Trucks

1 Answer

88 chev 3/4 ton PU, quites running when it warms up


Does it start right back up ?
Are you loosing spark to the plugs or fuel to the injectors ?

Feb 03, 2013 | 1988 Chevrolet C1500

1 Answer

My 1985 Skyhawk won't start. Cranks well but no start


BAD COIL OR IGNITION MODULE INSIDE DISTRIBUTOR RUN OHM TESTS TO VERIFY

Dec 08, 2012 | 1985 Buick Skyhawk

1 Answer

I HAVE 1985 TOYOTA CELICA SUPRA THAT WON'T STARTED. HAVE REPLACED SPARK PLUGS, ROTOR, DISTRIBUTOR CAP. WHAT CAN I DO?


Check your fuel delivery system, if the car is turning over and not starting you might have a bad fuel pump or fuel rail. Do you smell fuel when you try and start the engine? Or there is a longshot that the timing is off. Check the timing first.

Feb 28, 2011 | 1985 Toyota Celica

1 Answer

I have a 1985 toyota pu 22r motor it has been sitting a while and it wouldn't start.It would with starting fuel so i drained the old gas and replaced with good checked the fuel pump which i replaced just...


mcdevito75 here, I think you mean the acclerator pump in the carb, here"s how to check it, Operate the gas pedal linkage from the carb itself and at same time look into carb. see a straem of gas each timeyou operate the gas pedal linkage, if not check for fuel at the carb. You could also have a dirty gas filter or a problem with the ignition system, check for spark at plugs.

Mar 31, 2010 | 1985 Toyota Pickup

2 Answers

I was driveing and my 1985 toyota truck died and i cant get any fire from my coil


replace the coil after testing the no. 1 spark plug. pull the high tension cable and put near about 2mm from the ground. if no spark is seen. check the contact point, capacitor and distributor.

Aug 12, 2009 | 1985 Toyota Pickup

2 Answers

1985 Ford Ranger will not start when damp and cool outside.


possibly distributor cap getting wet. Try this. When it's not starting, remove distributor cap and dry inside and outside with hair dryer on warm setting. See if it starts then. If yes, replace cap and rotor and make sure plug wires are clean.
If it still doesn't start, you may be getting mositure in a wire connector that operates spark to plugs.

Are you getting spark at plugs when it own't start?
Check by getting a spark plug and plugging a spark plug wire into it and grounding the side of the plug. crank engine and watch for spark at gap.

May 25, 2009 | 1985 Ford Ranger

1 Answer

No power


When you have no power, it is either the gas or the spark. Check fuel delivery systems to see if they are working. If it is spark, get a helper (in tennis shoes), and hold a plug wire to see if there is any spark when you crank the motor. If there is no spark, then look at your cap, rotor, and the black module under the cap. Over time, the module will quit working.
Most Sincerely, Kristopher Gerbracht

Feb 25, 2009 | 1985 Pontiac 6000

1 Answer

87 4Runner 22RE problem


Replace the number one injector; it is sticking open.

Oct 07, 2008 | 1985 Toyota Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...