Question about Chevrolet Impala

1 Answer

It has lost power when you bearly give it gas

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Expert
  • 202 Answers

Fuel starvation

Posted on Feb 13, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Lost power, fuel mpg has dropped,give gas pauses

sounds to me like your catalytic converter is clogged up

Sep 15, 2015 | Cars & Trucks

1 Answer

1998 dodge dakota overheated was ran hot lost all power an shutdown

When an engine gets hot, you must shut it off before it gets so hot that it begins to lose power. Sometimes this simply can't be done safely. Once the engine gets so hot that it shuts down, permanent damage may have be done. Bearing can gall, piston rings can break, piston crowns melt, but usually the oil breaks down and the main damage is to bearings and perhaps the crankshaft. Diagnostics would include changing the oil, attaching a good mechanical oil pressure gauge then spin the engine with the spark plugs removed to see how bad the damage is. If oil pressure is adequate, run a compression test. This should give you enough information to decide if the engine can be saved without a major overhaul. Low compression can mean blown head gaskets, warpped heads, broken piston rings, warpped valves, etc.

Jan 01, 2015 | 1998 Dodge Dakota

1 Answer

Cylender loaded with gas engine making knoking noise

Maybe a spun bearing or an oil pump not turning any more.

Jan 10, 2014 | 2002 Chrysler Sebring

1 Answer

There is apoping & clinging noise in the reaeend when i give it a little gas it gets worse

First check the fluid level in the differential. If fine, then you'll probably have to drain the fluid and open up the cover. Check the magnet on the bottom for any metal shavings. You may have lost a bearing or some of your gears might just be worn out. While in the differential, try moving some of the gears by hand. There should be no play what-so-ever.

Jan 04, 2011 | 1991 Ford F150

1 Answer

1986 accord when shifting, giving gas or less gas power shifts?

Jack car up. Hold the front wheel with both hands in the 3 and 9 poistion. Try and rock it towards you and away. If it is easy to move the wheel bearings need replaced.

Take it to an alignment garage and get the tracking/alignment sorted. Are the inner edges of the tires worn?

Push down on the wing hard to compress the suspension and release, if one side returns slowly, new shock or spring is needed. See if you can spot any cracked springs too.

Jun 23, 2010 | 1986 Honda Accord

2 Answers

Whining on a 2002 Cavalier.

sounds like one of your pulleys. power steering pump, altanator, ac compressor, something along those lines.

Mar 28, 2010 | 2002 Chevrolet Cavalier Coupe

1 Answer

When I give it a little gas the RPMs gradually increace on its own unless I rev the engine. Im lost

Suspect a weak throttle spring and maybe binding in the linkage somewhere. Check the foot-pedal bearing point for friction. Make sure the carburetor mounting bolts/nuts are tight along with the carburetor body screws. Check for leaking vacuum lines from the intake manifold and the carburetor.

Sep 26, 2009 | 1984 GMC K2500

1 Answer


Check the computer trouble codes and see what they indicate it is.

Jun 19, 2009 | 1994 Chevrolet Suburban

1 Answer

1990 isuzu tropper

Since I no longer live in California, I don't care what you do but your problem sounds like the EGR system and if they replaced the valve, it isn't working, probably stuck open. This allows exhaust gases to invade the engine when it can't tolerate it; that path should only be open when the engine isn't pulling hard or at an idle. That widget also costs gas mileage so I always stuck a ball bearing or a screw into the vacuum hose that controls it disabling it so it never opened. On some vehicles that can give back 10-15% of your lost gas mileage. However, if the valve is stuck open, plugging the hose won't help at all.   

May 05, 2009 | 1990 Isuzu Trooper

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides