Question about 1995 Ford Windstar

1 Answer

How do i change waterpump on 1995 windstar with a 3.8 engin

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 430 Answers

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the thermostat in a 1995 toyota 4runner?


1995 Toyota Truck 4 Runner 3.0L EFI 6cyl

zjlimited_361.jpg

Fig. 1: On, 3VZ-E engines the thermostat is located in the waterpump (click over pic for zoom)

zjlimited_362.jpg

Fig. 2: Exploded view thermostat and housing on the 1FZ-FE engine


zjlimited_364.jpg

Fig. 3: Exploded view thermostat and housing on the 2RZ-FE and 3RZ-FE engines


zjlimited_363.jpg

Fig. 4: Exploded view thermostat and housing on the 5VZ-FE engine


Hope helps (remember to rate and comment this answer).

Dec 29, 2010 | 1995 Toyota 4Runner

1 Answer

Just change transmission filter in 95 ford windstar put 5 quarts in stick still read empty. how much fuild does it take?


IF YOU REPLACE THE TRANSMISSION IT TAKES ABOUT 8 QUARTS. 3 IN THE CONVERTER AND 5 ON THE PAN. NORMALLY IT ONLY TAKES 5 IF YOU CHANGE THE OIL AND FILTER.. MAKE SURE THE STICK IS GOING ALL THE WAY... YOU MUST ALSO CHECK OIL WHEN ENGINE IS ON.. NOT OFF...

Dec 15, 2010 | 1995 Ford Windstar

1 Answer

Must crank 10 -15 x's before engine starts. i checked fuel rail for both fuel and pressure. both are present however couldnt determine how much pressure. 95 f. windstar any suggestions appreciated


i would try to cycle the key a couple or 3 times on and off before starting it.. how long has it been since the fuel filter was changed?? might be getting restriction from it.

Dec 01, 2010 | 1995 Ford Windstar

2 Answers

What is the trick to change the back 3 spark plugs?


The best way i found on my 95 windstar is to remove the cowl panel below the windshield,you need to remove the wipers and screws holding the panel in place,also unscrew the antenna ,underneath you will see another plastic panel holding the wiper motor,this needs to be removed too by removing the 8mm attaching bolts around the edges and middle,also unplug the wiper motor, then simply lift the panel off to reveal the whole engine bay giving you easy access to everything,although this sounds alot of work it actually only takes about 15 minutes to do so.

Jun 07, 2010 | 1995 Ford Windstar

1 Answer

2003 windstar 3.8 liter V6 Must crank 2 or 3 times before engine start when hot or cold. Dealer was talking about possible electronic choke defective. Where is the location of this part


There is no electronic choke on this vehicle. this engine control adds more fuel on cold starts for through injectors pulse width to quicker starting. you may have a camsynchronizer and sensor going bye bye. looks like a little distriburor on top of waterpump. must have special tools to synchronize so don't pull out. also your fuel pump may be getting weak. you can try cycling key a few time to build fuel pressure before starts,replace fuel filter also and make sure air filter is ok.

Jul 16, 2009 | 2003 Ford Windstar

1 Answer

I need to know where the oilpump is located and how much of a chore it is to change out, and how much is one? 1995 Ford Windstar 3.8 engine.


raise safely support vechicle.oil pump is in front of the engine where your oil filter is.remove oil filter. then you have to remove 6 bolts .then remove oil pump.

Apr 21, 2009 | 1995 Ford Windstar

1 Answer

1995 ford windstar missfiring


Did you try fuel filter. test the pressure in each cylnder could be a bad valve

Apr 09, 2009 | 1995 Ford Windstar

3 Answers

1995 Windstar transmission problem


having same problem with tranny but the overdrive light keeps blinking any ideas?

Feb 01, 2009 | 1995 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...