Question about 1995 Dodge Dakota

1 Answer

Dodge pickup thuck shimmmy,s @ high speed

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Shimmy can come from several areas...check the tires for lumps or defective belts... check for missing or improper balance weight...check front-end alighnment( including condition of parts such as ball joints, tie-rod ends, bearings, a-arm bushings ect) and finally try switching tires from another corner of vehicle to see if it affects shikky. Hope this helps.

Posted on Oct 31, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2008 Dodge Ram wipers would work on intermittent and regular speed, but stop when switched to high speed. Now won't work at all except for short movement occasionally when switched on.


ck for rust around bolts that mount the motor , I had a car that did this and turns out that rust made bad ground connections from a worn out bushing around shaft seal to wiper arm

Sep 14, 2016 | 2008 Dodge Ram Pickup 1500

1 Answer

My 91 dodge Dakota shuts off on me in the middle of traffic. I can hear a puttering sound before it shuts off. Could that be my alternator?


Highly unlikely.
If you are accelerating or moving at high speed when it "shuts off," it is more likely a fuel delivery problem, or perhaps a heat-related ignition issue.
Do a readout of stored codes with an ODB-II reader, and proceed diagnostic from there. Primary culprit: MAGNETIC PICKUP COIL in distributor (they fail when hot).

May 01, 2015 | 1991 Dodge Dakota

1 Answer

What's your problem?high beams wont work on 1990 dodge pickup


may be the switch up above the steering column..or a loose ground at each light..

Feb 24, 2013 | Dodge Ram Cars & Trucks

1 Answer

Blower fan only works on high. Dodge Ram pickup 2001. I would guess its the blower switch. If it is, where is it so I may fix it?


I agree it is most likely the blower switch. It is attached to the knob you turn to select the speed :) Best of luck!

Jan 31, 2010 | 2001 Dodge Ram 1500 Truck 2WD

3 Answers

Blower speeds on ac/heater for 2003 chevy pickup(v6)


Hi, sounds like your blower motor resistor needs to be replaced. If not the resistor, check the blower motor.

Jul 27, 2009 | 2008 Dodge Ram Pickup 1500

1 Answer

Fan on heat and/or a/c won't work unless on high


Your fan speed dropping resistor is burnt out, it is located near the blower motor.

Apr 27, 2009 | 2001 Dodge Dakota

1 Answer

Heater fuse for a 1981 chevy pickup


If it's not working on HIGH speed it's a fuse that you will find inline and up on the firewall amongst the wires coming from the blower motor. I would first hook a wire to the positive side of the battery and touch it to the terminal on the blower motor. If it's the other speeds rather than the high speed I believe that is taken care of by replacing a fuse in the fuse block down under the dash on the drivers side. Good Luck!!

Dec 31, 2008 | 1994 Dodge B Series Cargo

1 Answer

Too high engine rpm at freeway speeds


that is a normal rpm for the nissan pickup (hardbody)

Nov 27, 2008 | 1997 Nissan Pickup

Not finding what you are looking for?
1995 Dodge Dakota Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...