Question about 1995 Mitsubishi Eclipse

Open Question

No 2nd 4th or reverse on my 5 speed

It will go into 1st 3rd and 5th but not the bottom gears we think its the shift linkage cable but we cant figure it out or how to fix the cable

Posted by on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: after new clutch installed, shifter

Your shifter cables have gona bad, i had the same problem and its not your clutch thats causing the problem. Your shifter cables are just worn out and you need to replace them

Posted on Sep 24, 2008

  • 4 Answers

SOURCE: cant get 1st gear. 2nd gear nosiey and crunches,

check the gear linkage first for smooth operation, then check/or change your gearbox fluid with the following (before going and ordering a gearbox rebuild - it's much cheaper). Make sure you have it filled to the correct level (see below).

The reverse switch is located on the gearbox, and the switch I have heard, do fail (or you have a short in it's wiring).
Manual transaxle and transfer case:
Hypoid Gear Oil, SAE 75W-90 or 75W-85W conforming to API classification GL-4

Rear differential:
Hypoid Gear Oil API classification GL-5 or higher

Above -23ºC (-10ºF)
SAE 90, 85W-90, 80W-90
From -34ºC (-30ºF) to -23ºC (-10ºF)
SAE 80W, 80W-90
Below -34ºC (-30ºF)
SAE 75W

Lubricant capacities (from the service manuals)
Manual transaxle [to bottom of filler hole]:
FWD: 2.3 L (2.4 qts)
AWD: 2.4 L (2.5 qts)

Posted on Aug 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Shift patterrn


5 speed 1st top left 2nd bottom left 3rd top middle 4th bottom middle 5th top right reverse bottom right
4wd 2wd top 4high one click down neutral shift to right then push down 4low bottom lowest point

Mar 26, 2014 | 1992 Jeep Wrangler

1 Answer

Gear shifter cable


sounds like a stretched gear shift cable or the linkage on the tranny may need some adjusting i would start with the linkage first jack vehicle up and do a visual while some one goes through the gears make sure to use jack stands so that the power wheels are off the ground.....good luck

Nov 09, 2013 | Nissan 200SX Cars & Trucks

1 Answer

Saturn 1996 SC2 5 speed driverside shifter cable stuck not broken but wont move


Check the linkage at the tranny... make sure that the levers can move. It sounds like they may have messed up their proper positions.

Apr 12, 2017 | 1993 Saturn SC2

1 Answer

I have a saturn sl2 with a 5 speed transmission. i was driving and heard a ping and now 2nd 4th and reverse are gone but i still have 1st 3rd and 5th. i have no idea where to start fixing the problem


If you have inspected the shift linkage and found no missing or loose parts, then unfortunately an internal shift mode fork, syncro assembly,shift rail or possibly a snap ring has been damaged. This is not an easy fix on any vehicle and will require transmission removal to diagnose. Before the trans is removed, inspect the shift linkage while someone moves the gear selector to all gears. This would be the best case scenario, internal damage, of course, would be the worst.

Feb 06, 2011 | 1997 Saturn SL

1 Answer

I have a 96 sl1. I only have 1st,3rd and 5th gear. If I try 2nd 4th and Reverse, it's like they aren't even there. Is it my linkage cable? And should I get a new transmission?


This does sound more like a bad cable. You'll need to find the shift tower on the transmission and have someone move the shift so you can see if it moves when trying to put it in the bottom gears.

Jan 05, 2011 | 1996 Saturn SL

1 Answer

93 toyota pickup. 4 cylinder, 5 speed manual 98k. ...


possible selector linkage adjustment , loose or shifted

Jul 02, 2017 | Cars & Trucks

1 Answer

Cant find 5th r reverse, transit


recheck for proper cable adjustments 5 -rev

Nov 28, 2008 | 2000 Ford Expedition

Not finding what you are looking for?
1995 Mitsubishi Eclipse Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...