Question about 1997 Chevrolet K1500

1 Answer

I need to know what sensor is just to right side,almost unxer disributor on 1997 c1500, 350vortec 2wheel drive

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Should be your oil pressure sending unit.

Posted on Feb 12, 2012


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 12 Answers

SOURCE: knock sensor for 1997 chevy C1500 Pickup Truck

Located on right hand side of block (pass side). It is between motor mount and starter.

Posted on Nov 27, 2008

  • 12 Answers

SOURCE: No fuel to the injectors on a 1997 Chevy c1500.

can be the distributor or maybe the fuel pump let the truck sit and then turn key almost on but not enough to initiate start up and see if you hear pump in the gas tank and if thats not it, it could very well be your distributor it might  be moist in the cap or button area

Posted on Dec 11, 2008

  • 10319 Answers

SOURCE: 1997 chevy k1500 4x4 Makes

most likely a thrush washer is at fault since the 4x4 kicks in for you
Have a trans shop give you an idea how much to repair before you grind this thrust washer to bits

Posted on Feb 19, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the speed cable at for a 95 f150

I do not think this truck uses one, if it did the cable would be under the truck on the driver side going into rear of ******, you would see the cable, i am pretty sure this truck uses a sensor and not a cable, the sensor is on the rear of the ******, now this all depends on if this is 2wheel drive or 4 wheel drive.

i have also seen this trucks operate the speedo from the rear diff abs sensor, so check the ****** for a sensor on drivers side rear of transmission, if not the rear diff should have a sensor on the top area

Nov 03, 2012 | Cars & Trucks

2 Answers

Replaced fuel pump & battery will not start

you have a ignition modulor in the distributor and the crank positon sensor. I have a 1997 grand cherokee and I go through a few crank position sensor

Oct 29, 2012 | 1994 Jeep Grand Cherokee

1 Answer

1997 chevy k1500 4x4 Makes a weird noise when in 2wheel and goes away when in 4 weel drive. Noise is in right front. transfer case location.

most likely a thrush washer is at fault since the 4x4 kicks in for you
Have a trans shop give you an idea how much to repair before you grind this thrust washer to bits

Feb 19, 2011 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

1997 golf mk3 gl 2.0 8vProblem starting my car in the morning

Change ECT/engine coolant temperature/sensor.Black with 4 wire plug.No screw there-only with pin.

Jun 25, 2010 | 1997 Volkswagen Golf

1 Answer

Where do i add frion to my 97 ford pickup its extended cab 2wheel drive v6

Add freon in the port closest to the accumulator. That is the low side.

May 26, 2010 | 1997 Ford F150 Regular Cab

1 Answer

The left front antilock brake shows a problem with hand held meter!light on dash stays on!what does the sensor,follow is it a gear in the backside of the rotor?these hubs are all one piece!this is an s10...

Yes,the sensor picks up and counts the teeth on the relucter ring on the back side of the rotor!! Make sure that the teeth on the ring are clean and the sensor have no metal brake shavings on it,this can cause the sensor to miss count at higher speeds and create a speed discrepancy between wheels creating a ABS DTC! Also check the wire harness to the sensor for cuts and abrasions that could cause a open or shorted condition to the sensor!I've also found allot sensor harness plug issues on these vehicles!
Good Luck and have a nice day! GMJ

Mar 09, 2010 | 1997 Chevrolet S-10 Pickup

1 Answer

How to determine if 97 Ram 1500 has 2- or 4- 2wheel brakes? Need info for wheel bearing replacement.

on 1997 dodge ram 1500s you can look at the back of the front brakes and if you do have 4wheel abs you will have a brake line and an electrical line running tto the brake caliper. you can also look at the master cylinder, on the right side of the power brake booster (if youre looking from the front of the truck) there will be a metal brake distribution block if it has 2 lines running out of it you have 2 wheel abs...4 lines means 4 wheel abs

Oct 23, 2009 | 1997 Dodge Ram 1500 Club Cab

1 Answer


check the coolant sensor, check for possible fuel filter clogged.

Jul 25, 2009 | 1997 Chevrolet S-10 Pickup

1 Answer

1997 Isuzu Rodeo 2wheel drive. Repalced

Get a Beck Arnley alternator. The auto-zone, Napa etc. alternators are a problem for Isuzu's. I worked at a dealership and a lot of them came in for this problem. If you still have the original have it rebuilt. Check yellow pages.

Apr 25, 2009 | 1997 Isuzu Rodeo

Not finding what you are looking for?
1997 Chevrolet K1500 Logo

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

78936 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides