Question about 2007 Chevrolet HHR Special Edition
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2007 HHR Wiring diagram
is there spark? is their fuel? also if it was wrecked chances are that the fuel cut-off switch was triggered. i have not ever worked on one so i don't exactly know where it is but i would check behind the fabric/hard plastic right rear/left rear wheel hosing and see if you can hit the reset switch. another suggestion is go to napa or oreillys and get a repair manual for it it has diagrams and schematics in it and it cost about 20 bucks.....good luck please rate this.....thanks
Posted on Sep 01, 2008
SOURCE: Head light 07 HHR
The headlight assembly is accessed from inside the fender well. There are two pop out plastic rivets and a small (4mm? head) body screw that secure the fender liner to the fender. Those need to be removed. Pull the fender liner back enough to work your arm into the fender. Locate the wiring to the headlight and grasp the plug. Rotate it to the left until the bulb is free of the reflector. Pull the lamp and wiring out from behind the fender liner. Remove the bad bulb. There is a release tab on the plug. Insert the new bulb into the plug. DO NOT touch the bulb glass. The oil from your skin can cause the bulb to explode when it gets hot. Hold the plug and work the bulb and wiring back to the original position. It is a little easier to look through the headlight lens as you work the bulb back into the reflector. Turn the plug to the right until it is properly seated. Replace the two pop out rivets and the body screw.
You should replace the headlights in pairs. I didn't and the right bulb went out in a couple more weeks when the weather was much worse. The right bulb was more of a pain to replace than the left, probably because I am right handed.
Hope this helps.
Posted on Jan 08, 2009
Get yourself to a junkyard and pack yourself a light lunch while you're at it. Take a leisurely stroll through the junk that closely resembles the one you need parts for. Go to the closest wiring harness to the headlight assembly, take your time and don't go trying to **** it, and unplug it from the bulbs up front. Make a simple and straight forward swap and do take the time to stop and smell the junkers, it's quite relaxing! Then, you should seriously make sure your new wiring harness is properly grounded (!), which I suspect to have been a contribing factor to your problem of overheating the bulb socket. Do take the time to go over the stuff that should be grounded and make it so. Th e job is quite simple and well worth you taking the time to do it yourself.
Posted on May 27, 2009
H13 HALOGEN HEADLIGHT BULB, SOLD INDIVIDUALLY -- Low 55/high 65-watt
halogen bulb; 12.8 volts; P26.4t base; A high quality, direct fit OE
replacement headlight bulb
How to Replace a Headlight Bulb
(DIY Complexity: Easy / Time: 0.9 hour)
1. Headlight Bulb
2. 1/4 in. Drive Ratchet
3. Socket Set
Step 1 Open the hood and locate the headlight assembly.
o Tip: Most headlight assemblies have a place in the rear to gain access to the headlight bulb.
o Tip: It is recommended that headlight bulbs are replaced in pairs.
o Tip: Always make sure the struts on the hood can fully support the weight of the hood so that it does not close on you while working. The use of a hood prop can securely hold it in place.
o Tip: Safety Tip:Always wear safety glasses when working on your vehicle. Wear other personal protective equipment (PPE) when necessary, for example latex gloves or safety shoes.
Step 2 Gain access to headlight bulb.
o Tip: It is a good idea to check the high beam and low beam headlight bulbs at this time.
Step 3 Disconnect the wiring harness and replace the old headlight bulb with a new one.
Step 4 Turn on the headlights and check high and low beams to verify repairs.
Hope this help (remember rated this help). Good luck.
Posted on Mar 30, 2010
Tips for a great answer:
Dec 12, 2017 | Cars & Trucks
Jan 01, 2016 | 2007 Chevrolet Chevrolet HHR LT
Mar 16, 2013 | 2007 Chevrolet HHR Special Edition
Mar 11, 2013 | 2007 Chevrolet HHR Special Edition
Apr 06, 2012 | 2007 Chevrolet HHR Panel LT New Cars
Jan 18, 2010 | 2007 Chevrolet HHR Special Edition
Dec 26, 2009 | 2008 Chevrolet Hhr
Jun 24, 2009 | 2008 Chevrolet Hhr
Nov 24, 2008 | 2007 Chevrolet HHR Special Edition
111 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: