Question about 1994 Toyota Pickup

Open Question

Toyota pickup 1994 speed sensor location picture

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 599 Answers

SOURCE: Remove and replace 1994 Toyota pickup starter

disconnect battery ..remove skid plate..remove battery/ignition wire from starter (2 nuts)..remove starter bolts(2 )

Posted on Nov 07, 2008

Ad
jebild
  • 178 Answers

SOURCE: 1994 TOYOTA PICKUP A/C FUSE WHERE IS THIS LOCATED

Mine's in a different location than the previous post ... I've got a '94 Xtra Cab from Japan (pre-Tacoma). Pull the glove box ... 3 screws across the
top and then a screw and bolt below. There's a small covered fuse box for a/c and heater on passenger side about where the upper door hinge
attaches to body.

Posted on May 09, 2010

alicantecoli
  • 22156 Answers

SOURCE: 1994 toyota pickup, 4x4, 3.0

if i am not mistaken then these wires can be connected either way around as its only a temperature sensor in the air flow

Posted on Jul 07, 2010

jebild
  • 178 Answers

SOURCE: replace alternator for 1994 toyota 4 cyl. pickup

I've found the bolt that the alternator pivots on to be not much fun. A small palm type ratchet has been helpful. Here's an online manual's alternator section: http://myweb.dal.ca/is353832/93fsm/charging/3generato.pdf

Posted on Aug 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

22RE TOYOTA 1993 PICKUP BASE MODEL 4WD 4CYI 5 SPEED MANUAL


its located on transfer case rear end near propeller shaft , have 3 wires plug

Jun 27, 2017 | 1993 Toyota Pickup

2 Answers

Where does the speed sensor go on the transmission?


u need to know if its 2wd or 4wd. ill give u a link to help u more. usually they r on the end of the tranny. those trucks are known to have gauge cluster failure. heres ur link, good luck
http://www.nissanforums.com/truck-suv/61923-1994-nissan-pickup-help.html

May 03, 2011 | 1994 Nissan Pickup

1 Answer

I have a 1994 toyota pickup 22r the idle surges when at a stop is it the throttle or the speed sensor


clean throttle body and make sure its full of coolant please rate ps love your user name

Mar 08, 2011 | 1994 Toyota Pickup

2 Answers

Speedometer on my 1994 standard toyota pickup only works intermittently. The odometer works fine. Where should I start... speed sensor, cable or speedometer?


neoprene gear in transmission were the speedometer cable goes into transmission should not have a dished appearance if you pulll it out of transmission look at it from the side it should appear flat from the start of the gear to end of gear no dish down in center

Nov 27, 2010 | 1994 Toyota Pickup

1 Answer

Where is the fuel pump relay switch for a 1994 toyota pickup


"Where is the fuel pump relay located on a 1994 Toyota pickup

Jul 03, 2010 | 1994 Toyota Pickup

1 Answer

I need to know the location of the knock sensor in the engine


i do not know the best thing for you to do is stop by your local Toyota dealer ship in the parts department and they can print you off picture and diagrams showing you where it is located Merry Christmas & Happy New Year as always wih you the best of luck Michigan Man.

Dec 21, 2009 | 1994 Toyota Pickup

3 Answers

1994 Toyota pick up Truck will crank and fire, but has difficulty starting. Once it starts, it dies at idle at stop signs/lights.


i would check your idle air control valve. And you might want to take a look at your fuel injectors/ fuel filter. To check the IAC motor remove the unit, with the wires connected turn the key to the "on" position without starting the engine, the IAC should move in or out. If the IAC motor does nothing it has probably failed, replace it with a new unit and recheck system. Note: while the IAC motor is removed clean (use aerosol carburetor cleaner) the passages the IAC uses to control idle air speed.

Jul 06, 2009 | 1994 Toyota Pickup

2 Answers

Location of knock sensor on 1994 toyota 22vre engine


The Knock sensor on a 22re is located under the intake manifold on the engine block. to the upper left of the oil filter. With is the passenger side of the engine. I believe it is yellow in color. Not do be confused with the oil pressure sensor which is close by. The knock sensor has a larger electrical connector. Good luck it can be hard to get to.

Apr 10, 2009 | 1994 Toyota Pickup

1 Answer

1994 Toyota Pickup 4 cylinder 22 re


throtle postion sensor is going bad located on the front of the intake manifold

Jul 16, 2008 | 1994 Toyota Pickup

Not finding what you are looking for?
1994 Toyota Pickup Logo

Related Topics:

177 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...