Question about 1991 Honda Accord

Open Question

How to remove dashboard panel for 1991 honda accord

How to remove dashboard panel

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
MNfisherman
  • 11896 Answers

SOURCE: Honda Removal of factory radio 1991 Accord lx

start by removing the console. there should be four screws that hold it in; two on each side; one in the front and one in the rear. you may have to take the gearshift knob of if the car is manual trans.then, remove the ash tray. there are two screws at the front of the ashtray receiver and one at the back.with the ashtray and slide removed, take the bezel off of the radio. there should be two screws behind or above the air outlet vents on top andn two screws in the under the center dividing rail. you may have to pop out the air outlets to get to the screws. there may also be a screw at the bottom of the bezel in the center.with the bezel removed the only thing that holds the radio in at that point is two screws that come up from underneath where the ashtray receiver was. take out those two screws and the radio should pull out from the front. Be sure to disconnect the antenna lead and the connector from the back of the radio before pulling on it too hard or you'll damage one or the other.hope that helps

Posted on Jan 17, 2009

Ad
  • 1 Answer

SOURCE: 1994 Honda Accord Ex dashboard removal

You have to remove the console and radio pod. Then remove 2 screws that you can now get to behind the pod. Then pry out the dash light dimmer switch (the one you use to adjust dash light brightness) remove the screw behind it that holds in the gage cluster trim. Then there is another switch on the other side under the cluster (don't remember what it is) and there is another screw behind it. Have fun, LOL!

Posted on Jun 28, 2008

  • 159 Answers

SOURCE: diagram of the 1991 honda accord firing order

What type of diagram?

Posted on Dec 09, 2009

  • 1 Answer

SOURCE: 1999 Honda accord dashboard clock light

need type A T3 8mm base
http://superlumination.com/74.htm
http://superlumination.com/images/auto_bulbs/neoglass_all_wm.jpg

unless you want stock clear color i think at dealer its under $3

Posted on Dec 19, 2009

  • 25 Answers

SOURCE: blower motor 1991 honda accord ex

the blower motor is located behind and under the glove box. its held to the blower housing by three screws. remove the three screws and the motor will slide down and towards you. to test the motor. apply power to the yelllow/black wire and ground to the blue/red wire. the motor should run. if not you prob have a faulty power resistor. 0881be0.jpg

Posted on Mar 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Is there another fuse box, beside the one under the hood for a 91 Honda Accord. My tail light and dashboard lights are out,....HELP


there is one inside the car. 3 possible places; under the glove box, under the steering wheel or if you open the driver side door the corner of the dashboard usually triangular piece of plastic to remove

Dec 21, 2012 | 1991 Honda Accord

1 Answer

In my 1991 honda accord break light is on in dashboard when the car is runung


Check your break fluid level. When the fluid gets below the sensor, the dash board break light will come on and stay on.

Feb 05, 2012 | 1991 Honda Accord

1 Answer

Flashing Green Light on 1991 Accord DX


usually the problem is the TCM or transmission control module. They are known to go bad. If transmission is working ok then this is most likely the problem.

Apr 27, 2010 | 1991 Honda Accord

1 Answer

How do you remove the clock in a 1991 honda accord?


For dashboard mount:
Disconnect the negative battery cable.
Carefully pull the clock bezel from the dash.
Remove the screws securing the clock to the dash.
Pull the clock out slightly and unplug the electrical connector.
Installation is reverse of removal.

For console mount:
Disconnect the negative battery cable.
Remove the rear console.
Remove the screws securing the front console cover and pull the assembly out slightly.
Unplug the electrical connectors on the back of the panel.
Remove the screws securing the clock (they come in from the back of the panel), then remove it from the panel.
Installation is reverse of removal.

Hope this helps you.

Oct 12, 2009 | 1991 Honda Accord

1 Answer

Remove rear passnger rear door panel 1991 honda


As I remember, you need to remove the front seat belt mount, & completely remove the back seats, in order to remove the rear door cards, without breaking them.
Have fun;)

Jul 17, 2009 | 1991 Honda Accord

1 Answer

Dashboard s light stays on 1991 honda accord


Have you mistakenly push the "sport"button at the gear shift knob? Because if you do so, the S ligh will stay on.

Jan 30, 2009 | 1991 Honda Accord

Not finding what you are looking for?
1991 Honda Accord Logo

Related Topics:

268 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...