Question about 2006 Chevrolet Colorado
Looking for the airbag module location on a 2006 colorado that was in an accident.
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Looking for location of ECM
Hope this helps
UPLANDER 06 Elec Cont Unit (ECU); (left front of engine compartment), 3.5L.
Posted on Nov 13, 2008
That is the only sensor to trigger the bags. The new module needs to be programmed to the car by the dealer or someone with a scan tool capable of that.
Posted on Nov 22, 2008
SOURCE: Air bag light
Usually a lit airbag can be attributed to faulty wiring, crash sensor behind the front bumper, bad connection between the airbag and lower part of the steering column, or a faulty airbag module. I've also heard of clockspring wiring harness problems. An airbag "on" light means that your airbag system is INACTIVE. Be careful. Check for a safety recall. You must have the battery disconnected for at least 15 minutes for a reset and double check your battery. I know it seems simple, but a poor battery will trip a code. 15 minutes allows the SDM (Sensing Diagnostic Module or Airbag computer) to discharge the backup power for airbag. Do this especially if you're poking around the controls. It sounds like a bad connection which is not allowing communication between all parts of the system. Also check the fuse (can't hurt).
Posted on Feb 17, 2009
SOURCE: malibu air bag module location
The module is under the passenger side seat,under the carpet.You will have to remove the seat to access it easier.Lift up the carpet and it will be mounted to the floor.
Posted on Mar 03, 2009
The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.
Posted on Jun 20, 2009
Tips for a great answer:
Jul 09, 2017 | Cars & Trucks
Mar 31, 2016 | 2006 Toyota RAV4
Oct 19, 2015 | Cars & Trucks
May 27, 2014 | 1995 Chevrolet Monte Carlo
Oct 14, 2013 | 2011 Ford Fiesta
Dec 11, 2012 | 2002 Ford Explorer
Nov 02, 2012 | 2006 Kia Rio
Jan 06, 2011 | 2006 GMC Envoy
Jul 03, 2009 | 1999 Chevrolet Silverado 1500
Jul 10, 2017 | 2006 Chevrolet Colorado
449 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: