Question about Chevrolet Colorado

Open Question

How do i change the blower motor in a 2005 chevy colorado?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2005 chevy colorado the fan

I had this same problem on my 2006 colorado. when i purchased a new resistor and went to replace it, I decided to check the resistance of each position on the old one with the resistance on the new one. they were both the same. then I decided to look at the harness. I was told that it needed to be replaced as well but I decided to try just the resistor. The harness had one of the connections in the plastic connector that looked like it had over heated. (IE browned char like look) after installing the new resistor, it ran ok for about 2 days then started acting up again. Then I tried my own solution. I pulled the harness loose from the resistor and with the ignition and fan switch off took a paper clip and manuevered it under the connection with the charring and slightly bent the metal connector out. when complete, the adjusted connector appeared to be a tad too far out compared to the other connectors in the plastic. then I reconnected it to the resistor and haven't had a problem since. I did, just out of curiosity switch out the new resistor with the old one and it too also works with no problems. Of course, the dealership will not take back electreical parts that have been placed in use. This should have been a chevy recall but apparently they don't care about anything but the initial sale of their products. I sent an email to GM and got to not response.

Posted on Mar 02, 2009

Ad
farroutideas
  • 78 Answers

SOURCE: blower only works on 4,123 not working.

Hi There;
You say your heater fan only works on high.

This issue can be repaired by replacing what is called the "blower motor resistor". The electrical current flows through this unit in all positions except #4.
If you look under the dash on the passenger side with the heater fan on #4 you will hear the blower motor running. Just slightly toward the drivers side of the blower motor & closer to the firewall you will see a four wire connector. this is attached to the "blower motor resistor". If you get a replacement one & examine it you will see two screw holes where you will need to remove the 9/32nds screws from the one in your truck to remove the fauly one & install your new on. This part is relitivly inexpensive & it is not worth trying to locate a used one.
Please let me know if you need more info on this
Farrout!

Posted on Mar 17, 2009

  • 118 Answers

SOURCE: How do i change the Blower motor resistor on a 2005 chevy impala?

The blower motor resistor is located behind the glovebox mounted in the fan housing box under the dash.

Posted on Jul 20, 2009

  • 447 Answers

SOURCE: how to replace blower motor 2005 chevy 1500 5.3 L

The blower motor is located under the passenger side of the dash. You have to take off the panel that protects the underside of the dash from the passengers feet and you'll find the blower above it. Some of the blowers have another sound insulator around the bottom of the motor but you should be able to easily spot it once you look up there. Takes about an hour to replace if it's your first one. Takes a bit of wrangling but they come out fairly easily.

Posted on Jun 17, 2010

  • 1 Answer

SOURCE: 2005 chevy equinox. Blower stopped working..

John,
What's it going to take to pry that corrective action out of you? I've been trying to help someone w/ the same identifcal problem for a few days now.

Posted on Jul 22, 2010

Testimonial: "Bossier62 Is AWESOME! John Cushing, 6308087542 Thanks for posting my name on the internet. Not very nice. Answered ealier. Did not show. Not my fault"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 colorado new blower motor stop working


When you replaced the motor did you replace the resistor and its wiring harness as well? I had to replace all 3 on mine to get them to work this is typical on the Colorado and trailblazers

May 11, 2014 | 2005 Chevrolet Colorado

1 Answer

2005 colorado new blower motor stop running, hooked the motor to battery and it works?


Replace the blower motor resistor. It is right there with the blower.

May 11, 2014 | 2005 Chevrolet Colorado

1 Answer

05 chevy colorado blower motor only works on high


Check the blower motor resistor in the front of the passenger side floorboard

Dec 15, 2013 | 2005 Chevrolet Colorado

1 Answer

The heater fan in my 2005 colorado sounds like a kids bicycle with a card in the spokes. How do i remove the fan to remove or clear whatever is making the noise?


Remove the blower motor mounting screws.
  • Remove the blower motor cooling tube (2).
  • Disconnect the blower motor electrical connector (4).
  • Remove the blower motor (3).


  • mrtechwrench_7.gif

    Nov 21, 2010 | 2005 Chevrolet Colorado

    1 Answer

    2005 Chevy colorado blower motor only work on high.


    The blower only works on High because something called a "blower motor resister" has gone bad. The resister works by resisting/absorbing the power to the blower motor on the lower speeds, At high speed it lets all the power go through. The part is about $20.00 for a Jeep (common problem). Getting at it and knowing where it is I can't help. But with that knowledge, you should not get screwed by the repair shop.

    Apr 29, 2010 | 2005 Chevrolet Colorado

    1 Answer

    Where's the hvac blower/resister located on 2005 Chevy colorado


    Your blower motor resister is inside the cab under the dash on the passenger side below glove box area right around passenger foot area.

    Nov 19, 2009 | 2005 Chevrolet Colorado

    1 Answer

    On low speed there is a ticking in the fan as though something was rubbing. The noise goes away on higher speeds. How can I remove the heater motor to see if there is something rubbing. This is on a 2005...


    It's on the pasenger side of the truck. Where the persons feet would be if sitting there. Lay down on your back and look up under the dash. There will be you blower motor. There are three gold or siver colored 5.5mm headed bolts holding it up to the heater case. Pull those out and the blower motor will drop down. Also you will need to remove the electrical connector before pulling the screws out. I will bet a peice of paper has been sucked out of you glove box and is in the blower motor. Be sure to note the position of the blower motor, it can only go in one way.

    Oct 15, 2009 | 2004 Chevrolet Colorado

    1 Answer

    How do i change the Blower motor resistor on a 2005 chevy impala?


    The blower motor resistor is located behind the glovebox mounted in the fan housing box under the dash.

    Jul 20, 2009 | Chevrolet Impala Cars & Trucks

    1 Answer

    Blower only works on 4,123 not working.


    Hi There;
    You say your heater fan only works on high.

    This issue can be repaired by replacing what is called the "blower motor resistor". The electrical current flows through this unit in all positions except #4.
    If you look under the dash on the passenger side with the heater fan on #4 you will hear the blower motor running. Just slightly toward the drivers side of the blower motor & closer to the firewall you will see a four wire connector. this is attached to the "blower motor resistor". If you get a replacement one & examine it you will see two screw holes where you will need to remove the 9/32nds screws from the one in your truck to remove the fauly one & install your new on. This part is relitivly inexpensive & it is not worth trying to locate a used one.
    Please let me know if you need more info on this
    Farrout!

    Mar 17, 2009 | 2005 Chevrolet Colorado

    3 Answers

    A-c switch on my 2005 colorado only works on high speed


    I had the same problem on my 2005 Colorado. I changed the blower resistor but still had the same problem. I had no voltage at the blower except on high. After talking with the local Chevy dealer, I found the plug-in connector that goes to the resistor had a burnt place on one of the terminals. AC offers a kit that you can splice into your existing wiring. Took me around 30 minutes to change. Costs around $50. So be sure to check the plug before changing anything out.

    Sep 05, 2008 | 2005 Chevrolet Colorado

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    223 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    76109 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8270 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...