Question about 1998 Isuzu Rodeo

3 Answers

1998 Rodeo TF Series 2WD 5-speed manual

I have a 1998 TF series Holden Rodeo which, when idling, revs very high and then very low. The high revs get progressively higher with each cycle and the low revs get progressively lower until the engine stalls. Revs can be held at a constant 1200rpm by applying a little constant accelerator. When stopping the engine has a tendency to stall. The problem is not noticeable when the engine is cold and gets progressively worse as it warms up.

Posted by on

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 39 Answers

Check throttle positioning sensor or mass air flow (maf) sensor

Posted on Nov 21, 2011

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

Or turn the air con off this will also help but not fix

Posted on Dec 23, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 599 Answers

Vacuum leak......bad tps.......bad mass airflow meter system........any of those are suspect...... also check for bad ground at battery to be sure all is not computer freak out from bad readings ...good luck

Posted on Nov 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is 1995 holden rodeo high beam switch located


http://www.ebay.com.au/itm/Indicator-High-Beam-Stalk-Switch-Rodeo-TF-1988-97-Holden-TFR-TFS-Blinker-Turn-/261941117019

it will be on the indicator stalk from the part link above. probably pull or push the stalk gently forward or towards you .

Jun 08, 2016 | Holden Cars & Trucks

1 Answer

Flasher relay location


TFS pickup sold to what country??? its not here in USA.
3rd gen pickup not sold here, so where?
and says last one is 2002.
read the WIKI
see the massive confusion there , under gen3

massive
Isuzu Rodeo (Japan)
Isuzu Dragon Eye (Thailand)
Isuzu Dragon Power (Thailand)
Isuzu Fuego (Philippines)
Isuzu Invader (Sabah)
Isuzu Ippon (Israel)
Isuzu KB
Isuzu Pickup (North America)
Isuzu TF
Isuzu TFR (Thailand)
Isuzu TT Fortigo
Chevrolet LUV
Chevrolet T-Series (Egypt)
Holden Rodeo
Honda Tourmaster (Thailand)
Opel Campo
Vauxhall Brava
Foton Aoling T-Series (China)
Jinbei SY10 (China)

May 03, 2014 | 2003 Isuzu Rodeo

1 Answer

Holden rodeo is idling very high


Spray aero start around manifold while idleing. if revs pick up there is a leak. repair the leak

Oct 03, 2012 | Holden Rodeo Cars & Trucks

1 Answer

I have an old holden rodeo KB series. The complience plates say it's a KBD42 made in 1985, yet I am told KBD42 stopped being manufactured in 1983 and that mine might be a KB43 or KBD43 as mine has a f


Have a careful look at the compliance plate. It's possible the 3 looks like a 5. The 5 speed transmission may have just been put on. Sure enough GM stopped manifacturing KBD42s in 1983.

Nov 26, 2011 | Isuzu Rodeo Cars & Trucks

1 Answer

My1998 Mazda B3000 4x4 3.0 5 speed idles high almost all the time. It gets worse when coming to a stop and then will idle down. Sometimes it wil rev up to almost 2800 RPM. Avg. idle speed is 900 RPM.


This sounds like the TPS. Thottle Position Sensor. This controls the idle. Your local Advance Auto Parts should have this part. It should not be that expensive.

Mar 23, 2009 | 1998 Mazda B-Series

1 Answer

Low/poor idle


Here is what you need to do, a cleaning of the intake throttle blade and the idle speed control air-bypass valve, they get full of gunk over the miles and cause idle issues (stalls) like yours,
Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake

Oct 31, 2008 | 1994 BMW 3 Series

Not finding what you are looking for?
1998 Isuzu Rodeo Logo

704 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...