Question about Cars & Trucks

1 Answer

Code 1574 on 2004 maxama abs, brake an service light on. no odonertor

I have no odometor,abs an brake light is on so. is service engine light

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Cars & Trucks Master
  • 682 Answers

It sounds as though your speed sensor or the wiring going to it is bad.

Posted on Feb 12, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

chuck943
  • 783 Answers

SOURCE: 2004 focus brake & ABS light on

Ok the reason I ask is that will help to pinpoint the concern. See ABS system when you first turn the ignition on will do a self test on itself,light turns on for a few seconds then turns off if everything proves out. Then when you start driving once you reach about 12 mph it will activate the pump and perform a 2nd self test.If everything is ok light stays off,if it see's a problem it turns on the light and disables the ABS.
Since yours comes on after you start driving then problem is most likely a wheel speed sensor concern. Since you just did a rear brake job and the problem started after this I would say it is one of the rear sensors.You need to look at the sensors and make sure the sensor and ring look ok and that you didn't get grease or dirt in the teeth of the sensor ring or maybe bent the end of one of the sensors and make the gap larger between sensor and ring.

Posted on Feb 21, 2009

DOODYDOODYDO
  • 105 Answers

SOURCE: 2002 buick abs, trac off lights come on

BAD WHEE BEARING AND PROBABLY THE PLAY FROM THE WHEEL BEARING HAS DAMAGED THE SPEED SENSOR FOR THE ABS

Posted on Jul 29, 2009

rteemon
  • 578 Answers

SOURCE: ebcm needs to be regrounded need location of ebcm.

how did you come to that conclusion

Posted on Sep 12, 2009

  • 615 Answers

SOURCE: service engine soon/ABS/Trac lights are staying on

Have the ABS codes scanned. This will get you started in the right direction. Possibility is that one or more of the wheel speed sensors is not working or intermittent - could be wiring or connectors on these as well. Another possibility is the EBCM, Electronic Brake Control Module. I believe the EBCM will throw 1216 code in many cases. THese can be rebuilt online for about $150.00.
The more likely problem is the wheel speed sensors. THese are an integral part of the wheel hub. About $100.00 each for the part. About $250.00 each to have them replaced. They can be tested with an AC voltmeter by spinning the wheel. Also, they should read roughly 850 ohms resistance. The ABS codes will tell you which ones are not reporting.

Posted on Nov 17, 2009

  • 1608 Answers

SOURCE: ABS, Service Engine Light

This is normal for your anti-lock brakes to quit when the abs light is on.What you will need to do is retrieve the codes and then you can find out what part of the abs system is giving you the problem.This will also cause the check engine light to come on.You can post back and I can help you with the code or codes that are in the brake control module.Hope this helps.

Posted on Dec 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Abslight stays on. How to fix? This is a2007trailblazer?


First you need to have EBCM - electronic brake control module check for DTC'S - diagnostic trouble code's . If the light is on there is a code stored . I think most part stores can do this and for free . After you find out what code is stored , looking up that code in service repair information for diagnostic trouble shooting chart would be next step . There are a few codes too.
DTC C0035 or C0040
DTC C0045 or C0050
DTC C0110
DTC C0131
DTC C0161
DTC C0186
DTC C0196
DTC C0201
DTC C0240
DTC C0241 or P0856
DTC C0244 or P1689
DTC C0245
DTC C0283
DTC C0287
DTC C0290 or C0292
DTC C0455
DTC C0550
DTC C0558

Find the code do the diagnostic's , fix the problem , wiring issue's , a sensor , bad module ,what ever it is . The light will go out then . Here is a sample of code discription .
• DTC C0035 Left Front Wheel Speed Sensor Circuit
• DTC C0040 Right Front Wheel Speed Sensor Circuit

Dec 30, 2016 | 2007 Chevrolet Trailblazer

1 Answer

My abs light is on in my 95 villager as well as my check engine light, I got a trouble code of 55 I replaced the brakes still can't get rid of abs light or check engine light what can the problem be?


code 55 on a 95 villager means "no codes found". If you are getting this code but the check engine light is on as well as the ABS light, then there is a good chance there is a problem with the ABS system itself. Manufacturers will often set it up so that multiple trouble lights will turn on to get your attention in the event of a major problem. If these lights are on together but you are getting 55, you will need to check the ABS system. It could be low brake fluid, or a problem with the ABS pump... There is also a chance that there is a blown fuse for either the ABS system or the diagnostics system which could also cause lights to turn on. One other possibility is that they are on for a factory set maintenance/service interval, meaning Mercury may have set these lights to turn on at a pre set mileage so that you will have the ABS system inspected at that point, although I don't believe this was very common in 95. My best advice is to check your fuses and fluid level, if none of these are the problem it might be a good idea to seek the help of a professional garage, you should never take chances when you're brakes are involved. Good luck :)

Apr 07, 2015 | Cars & Trucks

1 Answer

ABS/Parking Brake?Service Engine Lights are on But Runs Great


Does ABS work properly? Get on dirt road and try to lock brakes (do this carefully insuring no police car tailgating,lol) Could be bad wheel speed sensor. Check codes with scan tool capable of reading ABS and trans codes.

Feb 22, 2014 | 2001 Chevrolet Blazer

1 Answer

Why are my service vehicile soon lite,brake lite, antibrake lite, and change oil lites on after i start car


service engine light------scan for codes
brake light and antilock brake light ----abs problem scan for codes
change oil light ----- change oil and reset system light

May 21, 2011 | Oldsmobile Alero Cars & Trucks

1 Answer

I have a 1999 dodge durango, I just had new transmission installed, front and rear brakes installed and rear bearings installed. However the brake light is on, the ABS light is on, the speed odometor is...


Hello, most of the issues you're having are surely the result of the work you had done on your vehicle. You have to go back to whoever did the work and see if they will honor their work. If they are not willing to correct their poor workmanship you should document everything you can and threaten them with a, " small claims lawsuit ", that is sooo outragious. Have you made them aware of the issues your having?, most states $35.00 to file small claims, up to $5,000 in damages, plus court cost.
WOW! Good luck my friend.

Jan 15, 2011 | 1999 Dodge Durango

1 Answer

ABS light, Brake light, and trac control lights on no brake problems. have to turn off engine and restart to clesr lights 2001 windstar


You most likely have a problem with the ABS brake system. First, check your brake fluid level as many vehicles have a fluid level switch that monitors brake fluid level and if the level is low it can turn off the ABS and turn on all those lights.[ABS is part of the Trac control] If that is good then you may have a failing wheel speed sensor, wiring, or a problem with the ABS controller itself which would require having someone connecting to and reading the ABS service codes with a scan tool to identify what the system saw that caused it to turn itself off. Brakes are a very important safety item so you should get it repaired as soon as possible!

May 15, 2010 | Ford Windstar Cars & Trucks

1 Answer

I replaced the transmission in my 1998 oldsmobile intrigue and now the service engine soon, abs ans tcs lights won't turn off. I have had diagnostics run on it and no codes are found on the computer. I...


THE SERVICE SOON LIGHT IS DIFFERENT FROM THE SERVICE ENGINE SOON LIGHT. MINES ARE ALSO ON AS WE SPEAK . I THINK I NEED TO SERVICE MY ABS BRAKES. WHEN YOU PUT YOUR CAR ON THE SCAN IT SCAN ENGINE CODES

Feb 13, 2010 | 1998 Oldsmobile Intrigue

1 Answer

ABS, Service Engine Light


This is normal for your anti-lock brakes to quit when the abs light is on.What you will need to do is retrieve the codes and then you can find out what part of the abs system is giving you the problem.This will also cause the check engine light to come on.You can post back and I can help you with the code or codes that are in the brake control module.Hope this helps.

Dec 14, 2009 | 2002 Oldsmobile Intrigue

2 Answers

Abs light and brake light are on. also service


You can test the wheel speed sensors by unhooking the connectors and put ohmeter test leads on the sensor terminals should read around 1100-1600 ohms also the connectors themselves were bad for wires breaking inside the insulation at the connectors from flexing when the wheel is turned back and forth..Note excessive wheel bearing noise from bad bearings have also been known for interferring with clean abs signal also causing abs codes good luck

Nov 06, 2009 | 2004 Pontiac Grand Am

2 Answers

02 DODGE RAM 1500 4.7


Check engine light: Turn the key on three times in succession and wait for the codes. What are the codes?
Brake ABS light: When did you last have the brakes serviced?
No AC: Do you park your truck/car in a garage? Check the AC housing for leaves and debis which will burn out the AC fan motor.

Jun 27, 2008 | 2001 Dodge Ram 1500 Truck 2WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...