Question about Nissan 350Z

Open Question

Challenge Grundig CL2200 Manual - 350Z Nissan Cars & Trucks

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How hard is it to replace an emergency brake on a 1999 Chevy s-10?


if you have never done one , it will challenge you for several hours . buy a repair manual before you start

Mar 03, 2016 | Chevrolet Cars & Trucks

2 Answers

Bought car at auction- no keys. Had key made at GM dealer. Programmed key- key works. Car wont start- Codes are P0633 and P1629. cannot clear codes


DTC P0633 : Theft Deterrent Key Not Programmed

When learning the pre-release password, as well as the challenge and response sequence, the engine control module (ECM) is placed in learn mode. DTC P0633 will set automatically as an indicator that the system is in learn mode and not as a fault indicator. Once the password and challenge/response are learned, learn mode will be exited when the engine is successfully started. At this point, the DTC will be cleared. If the ECM does not exit learn mode, P0633 will remain current and indicate a fault.
The "key" referenced in the DTC descriptor does not refer to the vehicle key. In this case, "key" is referring to the challenge response.
DTC P0633 requires a successful engine start to exit the learn procedure and clear the DTC. If an unrelated malfunction exists that causes engine starting to be disabled or otherwise unavailable, learn mode will not exit and DTC P0633 will remain current. In this situation, the cause of the inoperative engine starting must be corrected before diagnosing DTC P0633.
DTC P1629: Theft Deterrent Fuel Enable Signal Not Received
The theft deterrent module (TDM) sends the pre-release password to the engine control module (ECM) via the serial data circuit. The ECM then sends a challenge to the TDM. Both the ECM and TDM perform a calculation on this challenge. If the calculated response from the TDM equals the calculation performed by the ECM, the ECM will allow vehicle starting.
DTC P1629 is an indicator that the challenge response was not received within the required 2 second window. This does not necessarily indicate a fault is present with the TDM or ECM. Factors such as a long engine crank, a delay in the serial data communication, or B-codes set in the TDM will cause DTC P1629 to set. This DTC should not be used as a fault indicator, but rather as a symptom to assist in the diagnosis of these other systems.
Who checked the codes , you -dealer ? You need to have BCM checked for codes B - codes ! you need a up scale diagnostic scan tool for that , dealer Tech -2 !
DTC B3935 57 : Transponder Authentication Error
DTC B3976 46 : Unconfigured Transponder/Vehicle Configuration Not Programmed
DTC B3060 : Unprogrammed Transponder Identification Code Received
DTC B3055: No Transponder Modulation or No Transponder
DTC B3031: Security System Controller In Learn Mode

Aug 07, 2015 | 2006 Buick Lucerne

1 Answer

How do I replace t heater core 2008 Pontiac torrent


That's a headache of a job. But if you're in for a challenge, you should invest in a manual. Also there are some other things you might want to pay special attention to during installation to avoid possible damage to other components which will have to be removed and reinstalled.

Nov 24, 2014 | 2008 Pontiac Torrent

1 Answer

Code reader plug location on my grand vitara


wow no year stated, what a challenge.
top of right knee, usa , lhd.
all usa cars, obd2, are 1meter from steering wheel center.
by law.
16pin d-shell and female, and pin 16 is 12vdc keyon.

its in the fsm ,rtm ,read the manual?>

https://suzukipitstopplus.com/products/10046-2005-grand-vitara-grand-vitara-xl-7-service-manual-sq625-gv-ja627-xl7.aspx

above is 2005 ,i rolled the dice

Sep 25, 2013 | Suzuki Grand Vitara Cars & Trucks

1 Answer

I am looking for a radio code for a grundig RCD 300 1K0 035 186P GRO 9.18438-6151, Serial Number VWZ2Z2E1095777, Vin # AAVZZZ6SZCU029020 > Hillazw@gmail.com


Sorry tried my grundig code maker but cannot use the chassis number ,only the radio number and from the look of it this one is too new for my code generator.What i often do is to take the radio apart and run the feed wire to the first component and sometimes i by pass the code bit and the radio works

Aug 22, 2013 | Cars & Trucks

1 Answer

Install a distributor on a 1998 Suburban


you need a repair manual for details--buy one at parts place or online-----can be a challenge for a novice mech--take it slow -timing must be acurate

Jul 11, 2011 | 1998 GMC Suburban

1 Answer

How do I get to the altenater on a 1994 chevy lumina v6.


If you have the 3.4l v6 it is a challenge. You should get a repair manual if you are going to try this. On the 3.1l v6 it is not that hard off a job. 3.4l you have to remove the wiper motor the motor mount on the strut and the alternator mounts.

Oct 24, 2009 | 1996 Chevrolet Lumina Mini

1 Answer

I need a alterntor wiring digram for an 85 f250


Check out your local library to see if they have the schematic books.
Or, Autozone, AdvanceAuto, NADA, or CarQuest for online Mitchell's
or the Haynes books, that have schematics.

Also, on the online Ford Forums, there are schematics.

The real challenge for mechanics is to get, and read, the entire Service Manual
(helm's has the two volumes of Ford Factory Truck Service Manuals for $49.00)!

Dec 24, 2008 | Ford F-250 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...