Question about Chrysler Voyager

Open Question

How to replace front timing cover on chryser grand voyager 3.3ltr v6

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 337 Answers

SOURCE: 1999 plymouth grand voyager se removing dashboard

Posted on Dec 03, 2008

michigan man
  • 3533 Answers

SOURCE: serpentine belt and tensioner replacement 1999

try to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

Posted on Mar 20, 2009

  • 3051 Answers

SOURCE: how do i change my drive belt on my 2000 chryser

Hello there:
If you have 2 people it is a lot easier You will need to remove the fan guard if there is no room. than on the idler pulley there is a square hole that a 3/8 socket wrench handle with a cheater bar and a socket extention will go in to now just push hard on the handle and the pully will take the tension off the belt so that you can remove it. please please if you dont have the routing diagram for the belt write it down how the belt goes before you remove it. put on the new belt and once again use the socket wrench and push hard on the idler pulley and slide the belt under the pulley and slowly release the wrench

Posted on Aug 04, 2009

  • 258 Answers

SOURCE: how to change 1998 Plymouth grand Voyager front sway bars

unbolt the sway bar links from the control arms and the two brackets holding it to the frame. make sure if you jack it up jack up the front end. if you jack up one side and not the other and take the sway bar loose it will be loaded and could cause injury if not careful as long as both front tires are off the ground the sway bar will not be loaded and will be safe to deal with

Posted on Oct 19, 2009

  • 1757 Answers

SOURCE: have 1988 pontiac grand prix se with 2.8 v6

My sincere apologies for the delayed response.
I am personally going back to answer your unanswered question.

For the 2.8L
Firing Order:


Ignition Connections (Spark Coils):

Again my apologies....
Let me know if this helped...

Posted on Mar 16, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why does my 2002 chryser voyager keeps cutting off and back fires

Any codes,tune up,fuel filter,could be crankshaft sensor.

Aug 20, 2014 | 2002 Chrysler Voyager

1 Answer

When replacing water pump on V6 3.O Do we need to change timing belt also?1997 Plymouth Grand Voyager

No. But if your that far into the engine it is very little more that you need to remove to replace it. If it has never been replaced and you have more than 50,000 miles I would recommend replacing it.

Sep 22, 2010 | 1997 Plymouth Voyager

3 Answers

Oil leak on a 96 plymouth voyager between the oilpan and pulley.3L v6. where is it coming from?

Oil pan gasket or crank shaft seal its going to be one or the other you just have to get down there and see which one it is.

Jan 19, 2010 | 1996 Plymouth Voyager

2 Answers

1997 plymouth grand voyager v6 3.0L broken timing belt

I had the same thing happen, No, I was told this is not one of the engines that allows the piston to contact the valves. I replaced the timing belt 2 years ago and had no valve problems.

Sep 22, 2009 | 1997 Plymouth Grand Voyager

2 Answers

2000 Grand Voyager front A/C works off and on, back works good

check the condensor for debris, also check the front blower fan an its resistor, and again check your freon level

Aug 24, 2009 | 2000 Chrysler Grand Voyager

1 Answer

How to change spark plugs on 2000 chrysler grand voyager v6 3.3l

use a lift, let van cool or change front three while van is cooling and from the under side of the engine change the other last three. They can be reached easily. No need to remove plenium.

Jul 08, 2009 | 2000 Chrysler Grand Voyager

1 Answer

Front speaker access

the covers are either held down by srews or simply snapped in.

Dec 01, 2008 | 1998 Plymouth Grand Voyager

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

78289 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides