Question about Cars & Trucks

1 Answer

Starting engine 307hdi

Taking a lot of time starting engine

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    Visited the website for 10 consecutive days.


    Visited the website for 3 consecutive days.

  • Expert
  • 37 Answers

Replace spark plugs check all leads to plugs

Posted on Feb 12, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2001 Buick lesabre sometimes takes a few times to start other times will start right up and other times will start but when put in gear will die if you don't keep your foot on the gas

Could be several thing's . fuel system , ignition system . engine sensor etc... Instead of replacing a lot of parts that don't fix the problem ,take it to a qualified repair shop an have it diagnosed ! Because without testing no one on hear could say for sure it's this part or that part . There are videos on youtube for trouble shooting ignition systems , fuel systems , engine sensors etc... Sensors that could cause this problem , mass air flow , crankshaft position sensor - of which your vehicle has two .

Nov 13, 2016 | 2001 Buick LeSabre

1 Answer

307hdi engine turns over like its got a flat battery leave for 10min and it will start

loose battery or starter connection,or corroded terminals,also,could be starter solenoid

Mar 09, 2015 | Cars & Trucks

2 Answers

Peugeot 307 gearbox problem

sounds like the gearbox selector, by the way have you checked the gearbox oil to see if its low or contaminated

Aug 11, 2014 | 2004 Peugeot 307 1.6

1 Answer

307hdi 51regmaking noise grinding

If it makes the sound during idle and you have manual transmission, check the clutch plates, pressure plate and related bearings. If it happens when the car is moving, check driveshafts, wheel bearing and brake pads.

May 02, 2014 | 2001 Peugeot 307 2.0

1 Answer

Sticky clutch

its clutch fork is not reversing check if its fork spring is missing.clutch bearing keep moving with clutch.
it could be pressure plate spring fingers soften.

Feb 05, 2014 | Peugeot Cars & Trucks

1 Answer

Will turn over and will not start

Lots of things to look at. Engines need fuel, a spark and power to electronic control modules. There are a lot of components in these systems, so it'll take some time to check them all.

Nov 19, 2013 | 1987 Toyota Camry

2 Answers

My 1995 grand cherokee takes a lot to start. turns over fine, but won't fire. checked fuel rail, no pressure. after trying 15 times or so, it will start and run just fine. starts right back up unl

Your Jeep has what's known as the delayed start, no check engine light problem. The Jeep will not start until the check engine light comes on, on the dashboard. Next time it cranks but will not start, look at the dashboard to see if the check engine light is illuminated. If it's not lit up, then your Jeep does have that problem and your Jeep ecu is in need of repair or replacement. There are components inside the ecu that are going bad and will continue to get worse, eventually leading to a permanent no start condition. There are ecu repair services and replacement ecus on ebay.

Jan 17, 2013 | 1995 Jeep Grand Cherokee

1 Answer

Timing marks on peugeot 307hdi

on the facing outer edge of the crank and cam pulleys you will find a small (0) dimple.these are the timing marks.....

Sep 09, 2010 | Peugeot 604 Cars & Trucks

1 Answer

Peugeot 307hdi rapier 2002, won't rev above 3000rpm

this happened to ours running on emptyish sucked some **** of the bottom of the tank took ours for a run thrashing it a bit worked out the problem otherwise i think u have to have the filter changed wich is the catalytic converter

Apr 28, 2009 | 2005 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79123 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

13723 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides