Question about 2001 Mazda MPV
Check or replace the thermostat then check for radiator leaks and sludge in radiator flush out radiator and all water in engine replace with fresh water and anti rust stuff check all hoses connected to radiator and the heater for leaks
Posted on Feb 12, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Mazda MPV 2001 DVD player
it is illegal to drive with this playing,go to mazada dealer and ask for a manual.or go to loacal cafe a breakfast time and try to chat to mechanic
Posted on Jan 01, 2009
It is not a very difficult task, but one that would be better left to a professional for a couple of reasons. First, the system should be tested to be sure this is going to fix your problem. Many times a bad battery is the demon. Second, you will get a warranty with that repair if you have it done at a reputable garage/dealership. Just a couple of things to think about.
Posted on Jan 05, 2009
if you do not here the motor then its the regulator or motor that needs to be replaced/ cif you hear the motor check the control switch on the trim panle coould be just a five dollar part to replace/ Please rate my response thank you very much
Posted on Jan 31, 2009
I replaced this sensor about 6 months ago. (If this is the sensor that is located near the firewall on the exhaust manifold under the ignition coil.) The only way to easily replace it, is to remove the MAF and air filter assy. then remove the intake plenum, remove the ignition coil, and then you'll have access to the sensor. You'll need a sensor removal socket. If the socket slips around the hex of the sensor, then you'll need to use a regular deepwell socket and cut the cable from the top of the sensor, or use a combination wrench that will fit it.
The most difficult part of removing the intake plenum is getting the nut loose from the EGR valve. DO NOT just remove the two bolts holding it to the intake plenum. It will not line up correctly during re-assembly and may not seal tightly either.
This took about a Saturday to do. You'll need new plenum gaskets to replace the old. While your at it remove the throttle body and clean the carbon from the ports that lead to the EGR valve and replace that gasket as well. The gaskets will run about $30.
Posted on May 04, 2009
Tips for a great answer:
Aug 22, 2017 | Mazda MPV Cars & Trucks
Jun 22, 2012 | 2001 Mazda MPV
Aug 26, 2011 | 2001 Mazda MPV
May 25, 2011 | 2001 Mazda MPV
Jan 20, 2010 | 2001 Mazda MPV
Aug 26, 2009 | 2001 Mazda MPV
Apr 07, 2017 | 2001 Mazda MPV
Apr 06, 2017 | 2001 Mazda MPV
425 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: