Question about 1999 Acura TL
Dealership cleaned fuel injection and air intake but could not duplicate
Sounds like a mild fuelling fault, start by replacing the cheapest part - The ECU coolant temp sensor.
This sensor is located in the thermostat housing
Posted on Feb 12, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
just did it tke a breath and put on your small hands!If you r talking about hid bulbs i found aftermarket bulbs at www.moble-emotions.com its best to get both and change them togetherso they match i did only one first and you could see the differance big time.On the battery side the black cover to lightbulb neens to b poped off there r two thumb push tab pry light with a screw driver. on pass side take the 10mm bolt off washerbottle and move aside.(.you need a small hex or starbit to remove the set screw.after u get the set screw off takr both hans and twist hard the cover has a slot as u turn off pull out.there is a hook tab about the size of a paperclip un hook at bottom bulb its fixed at top so just lift bottom to top.remove and replace bulb.(twist out )reverse stepsI also looked at a picture on acurra parts site goood luck i think i did it better than discribing
Posted on Nov 11, 2009
Testimonial: "thanks, your direction was very helpful..."
Below are the proper steps to removing your vehicle's fuel tank..
Disconnect the negative battery cable.
Relieve the fuel pressure
Remove the rear seat cushion.
Remove the plastic grommet from the floor pan.
Detach the fuel pump electrical harness.
Disconnect the fuel lines from the fuel pump by compressing the tabs on both sides of each nylon push connect fitting and easing the fuel line off of the fuel pump.
Raise and safely support the vehicle securely on jackstands.
Remove the muffler mount.
Remove the heat shields.
Remove the fuel tank cover.
Remove the drain plug and drain the gasoline into a approved container.
Disconnect the fuel lines and remove the fuel filter and base.
Loosen the fuel tank filler pipe clamp at the fuel tank.
Support the fuel tank using a hydraulic jack and a block of wood or other suitable device.
Remove the two fuel tank support strap bolts and position the straps out of the way.
Partially lower the fuel tank to access the fuel tank filler pipe vent tube and disconnect the vent tube and filler pipe from the tank.
Disconnect the fuel vapor tube from the tank.
Lower the tank from the vehicle.
Installation is the reverse of the removal procedure.
Posted on Apr 23, 2010
Tips for a great answer:
Nov 24, 2010 | 1999 Acura TL
Apr 26, 2010 | 1999 Acura TL
Feb 12, 2010 | 1999 Acura TL
Dec 06, 2009 | 2005 Acura TL
Nov 06, 2009 | 2004 Acura TL
Mar 14, 2009 | 1999 Acura TL
Mar 04, 2009 | 1999 Chevrolet S-10 Pickup
Oct 27, 2008 | 1999 Acura TL
281 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: