Question about 2002 Chevrolet Impala

Open Question

2002 chevrolet impala full tune up how to do it yourself

Change oil and cabes

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
Pattods
  • 116 Answers

SOURCE: change oil light

Engine Off, Key to Run position, depress and release gas pedal 3 times within 5 seconds.


Only do this after changing the oil. Don't worry so much about 3,000 miles, the silverado will calculate when to change your oil next based on miles and driving conditions. -This only works if you only reset the oil light soon after changing the oil.

Posted on Sep 24, 2008

Ad

SOURCE: 2002 chevy impala

I have a 2002 Impala and to reset my change engine oil light I turn the ignition on to setting right before actually starting the car and I press my gas all the way down three times within 5 seconds and that usally turns it off. Usually it works

Posted on Oct 08, 2008

texastbone
  • 63 Answers

SOURCE: jumps when it changes gears

my guess is that it might be a mount bad and your feeling it jump in the housing of the mount. its also possible that there is a computer malfunction but its not common. my last educated guess is that there is a mechanical problem in the transmission. but it the clutches are not slipping and you don't hear any noises and the fluid is at the right level then it doesn't sound likely. its hard for me to tell exactly without me being able to be there and diagnose it. try sitting in park and holding the brake. shift from drive to reverse and back again to see if it feels like its jerking into gear. if so i would really check for a bad mount. i work a little on rear wheel drive transmissions. but don't have much experience in front wheel drive ones. but they are similar. hope this helps. texastbone

Posted on Jan 05, 2010

  • 10 Answers

SOURCE: Chevrolet 2002 Venture

the oil light comes on every 3,000 miles or so as set by the dealer. It doesn't actually 'check' your oil. So your oil changes are probably not going to coincide with the change oil light. So you will have to reset the light on your own. The solution above is what the manual says to do, however, my venture is temperamental, and I have found that I have to press on my accelorator 5-6 times before it will reset the light.

Posted on Jan 07, 2010

Zeevert
  • 373 Answers

SOURCE: 2003 Impala: HOW DO I CHANGE BATTERY 2005 CHEVROLET IMPALA...

The battery is under the hood, just behind the passenger headlight.
There is a black bar that crosses over the battery and goes back towards strut tower. Remove this bar and the three bolts; probably a 12 or 13mm socket.
Remove the negative (black) battery cable with an 8mm socket or wrench. A 5/16" should work also.
Then remove the positive (red) cable with same socket.
Remove the battery clamp and bolt. Probably a 12mm socket with extension.
It's tight, but the battery can be removed.
Reverse instructions for installing the battery. (That includes hooking up the red battery cable first, then the black cable.)

Posted on Jun 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I reset the change oil light on 2002 chevy impala


Turn key on ,,,hit brake pedal 3 times with in 5 seconds,,, thats how you do it on chevy trucks,, so maybe it will work for you

Feb 01, 2015 | 2002 Chevrolet Impala

2 Answers

How do i get piece out of transmission that speedo cable goes in on 88 suzuki samurai.


You can try using some heat to free up the corrosion around seam. Or a penetrating oil and let soak for some time

Nov 26, 2014 | 1988 Suzuki Samurai

1 Answer

I want to wire cab lights into my 2006 gmc sierra how do i do it


it depends on what you want then for if its just night driving you can use a relay and wire kit from your side lights and wire into the cabe. same for any time lights but you can run the power from the ignition switch and main battery line and wire into the cab. make sure you put an inline fuse in best to put it near to the battery as it will be better for you if you need to change the fuse or have a fault. spotlight kit will do for the wiring and easy to put in this way.

Nov 25, 2013 | GMC Cars & Trucks

3 Answers

What does a major tune up for a 2004 chevy impala consist of? What should be done and needs to be done?


New spark plugs, oil and oil filter, transmission flush and fill, fuel filter, air filter, coolant flush and fill, clean throttle body plate and bore, clean the MAF sensor, replace any loose or cracked vacuum lines, PCV valve, new air filter, new battery.

99% of the time all you should ever need for a tune up is new spark plugs, and a clean air filter and throttle body. But since your inquiry indicated "major" I gave it more critical thought.

Feb 18, 2011 | Chevrolet Impala Cars & Trucks

1 Answer

Toyota 2003 tundra changed battery now won,t idle


check to see if your air cleaner housin is loose or not on right
try taking cabe off battery for 5 minutes then put back on and try it

Dec 29, 2010 | 2003 Toyota Tundra

1 Answer

2002 Impala: I do not have a manual...how many quarts of oil wh...


Start with 5 quarts. Start engine for one minute. Shut off and recheck. It should be OK.

May 17, 2010 | 2002 Chevrolet Impala

1 Answer

The sensor reading engine hot a/c off on my 06 impala has came on what should i do


Sir,
You are suggested to check if your Mobloil is full and fine in the engine. and check if plugs are not getting Oil.You might have to get you car tuned.

Oct 17, 2009 | 2006 Chevrolet Impala

1 Answer

Power freakout


Sounds like the battery won't pass a battery test, but if it does your explaining dirty battery cable connections clean and or replace as needed as this is the number one reason for a no start . This corrected and known good battery and it still acts up follow the negitive cabe from the battery and disconnect it and clean and reconnect it everywhere it goes. Don't look at it do it. It can look good and be bad. Still bad? the positive cable right at the battery is the root of all evil and you may want too fix it first as soon as the neg cable is removed. Follow the wire and clean everything.

Aug 11, 2009 | 1999 Subaru Forester

Not finding what you are looking for?
2002 Chevrolet Impala Logo

Related Topics:

572 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...