Question about Isuzu Cars & Trucks

Open Question

Convertion of power steering pump for c190 isuzu engine

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: I need to replace the altenator in my 1994 Isuzu Trooper. Do I have to remove the Power Steering Pump to reach the part?

no just jack the vehicle and go through the passenger fenderwell, its there and you do not have to remove the p/s pump

Posted on Sep 02, 2008

Ad
  • 232 Answers

SOURCE: Location of power steering pump

Usually they are located near or part of the power steering reservoir. Look for the cap to fill the power steering with fluid the pump should be underneath.

Posted on May 06, 2009

  • 22 Answers

SOURCE: replacing the power steering pump on a 1998 isuzu rodeo

Remove low pressure and high pressure hoses (this one could be hard to break loose). You might want to have an oil pan handy, to capture the oil. Disconnect electrical sensor. Remove the bolt that holds belt tension adjustment plate. And finally remove the bolt that holds the pump in place. It is bolted from the back and located at the right lower corner of the pump if you are facing the front of the car. Remove the pump assy. I could not remove belt pulley at home, no matter how hard I tried. Ended up taking it to an automotive shop and they removed it in no time, using one of those "pneumatic impact guns". Assemble new pump. Fill the reservoir with PS oil. Make sure both of the front wheels are off the ground, start the engine and slowly spin the steering wheel back and forth for about 5 minutes or untill screeching sound stops and the liquid in the reservoir stops foaming. That will bleed any air that is in the system. Don't go all the way to the end of stroke. Good luck.

Posted on May 09, 2009

  • 1 Answer

SOURCE: whining noise from engine compartment

Its the pully. I have a 2006 and had the same issue. It went on for months and I was told it was "normal". Well the bearings on the puly were blown and it broke the belt while I was driving. Cost 20 bucks to fix.

Posted on Feb 08, 2010

  • 1 Answer

SOURCE: I need a wiring diagram for a Isuzu c190 diesel

my isuzu c190 engine has smoky exhaust and it is hard starting

Posted on May 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Isuzu c190 wont start when warm


C190 is a 2.0 L OHV 8V engine same as marine 4AA1.
when warm did you try diesel test fuel?
runs now , right, or runs and stalls. right?
that be the biggest clue there.
besides black smoke.
lost compression hot.
or lost fueling hot.
simple test for compression and test fuel....... leaving what?

Oct 10, 2015 | Isuzu Cars & Trucks

1 Answer

Where is power steering res 2004 Isuzu npr diesel


or ELF is real name.
see the power steering system and pump
see those related hoses, one goes to the res.
or on some cars the pump has a res. on top.

we dont have these Gen 5 trucks here,
cept
Chevrolet Tiltmaster, and also as the GMC Forward.
this is a USA forum so , finding non USA car facts are are IFFY at best. so join a real ISUZU forum near you?

Jan 28, 2015 | Isuzu Cars & Trucks

2 Answers

2002 isuzu trooper looses power on climbing, not responding to acceleration


Is the transmission dropping down to lower gear when climbing ? (automatic only ) Will it accelerate good to pass on level road?
Proper fuel pressure, and possible exhaust restriction, such as partially plugged/plugged catalytic converter, are 2 things I would check as well. All provided engine is also in good shape to begin with.

Apr 09, 2012 | 2002 Isuzu Trooper

1 Answer

Power steering heavy turning left in isuzu rodeo 4x4


check the power steering pump, if its good than it will be rack and pinion issue. the pump create a high pressure to help assist with steering, and the rack and pinion work like hydraulic cylinder which receive the pressure from the pump and the steering work like control valves. by turn left or right you controling the pressure to make the wheels turn either right or left. check and see if you have any leaks.

Oct 02, 2009 | Isuzu Rodeo Cars & Trucks

1 Answer

Location of power steering pump


Usually they are located near or part of the power steering reservoir. Look for the cap to fill the power steering with fluid the pump should be underneath.

May 06, 2009 | 1998 Isuzu Rodeo

1 Answer

Power steering


when the engine is idling is it stiffer than normal,does it get lighter when revved,any noises,1st to check is the power steering pump drive belt if the tension is ok then may have a pump fault as it it not maintaining pressure.

Mar 05, 2009 | 1992 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...