Question about 1991 Toyota Land Cruiser

Open Question

1991 toyota land cruiser kill switch location?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: 1997 Toyota Land Cruiser rain water leak

i had the same problem. Flushed the sunroof drains, replaced the windsheild, and weather stripping on passenger and driver side doors. Car is still leaking. No one can figure it out.

Posted on Jul 31, 2008

Ad
Technopro
  • 243 Answers

SOURCE: quantity of engine oil used in 1 HD engine toyota land cruiser

The Landcruiser 1HD engine uses 9.3 liters of oil with the filter. The oil is replaced every 5000Kms.

Posted on Nov 12, 2008

  • 1 Answer

SOURCE: what kind of oil for toyota land cruiser 2008

best u use mobil one synthetic motor oil

Posted on Jan 19, 2009

  • 94 Answers

SOURCE: 2004 Toyota Land cruiser key programming

you need to take it to the dealer so they can program the key to the car which requires there software. hope this helps

Posted on Mar 09, 2009

  • 2 Answers

SOURCE: Toyota Land Cruiser Prado (LC90) Owner's Manual (free download)

hi sir/mam,i have tryed to get help from allover,can i know who can.
i have Toyota land cruiser Model GF-RZJ 95W-GKPSK-D.
Engine-3RZ-FE.
Fram-no rzj95-0047087.
This vehical does not start,Digonest code 002:-Fauity RPM Signal(no RPM,NE and crankshaft position signal trnsmitied to ECU after started for 2 secondes)
1.CKP and CMP sensors short open
2.Distibutor fault.
3.start circuit open or short.
4.module fault.
i have changed distibuteor (NEW)

Posted on Jun 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 1991 toyota land cruiser where's the fuel


I have always known the fuel filter to be attached to the fire wall inside the engine compartment at the rear of the engine . It will be a tin can about jam tin size with 2 or 3 pipes in the head piece.

Sep 22, 2013 | Cars & Trucks

1 Answer

Location of neutral safety switch on 1994 toyota land cruiser?


It's located on the right side of the transmission where the shift selector rod attaches to the selector lever on the trans, near the front of the transmission, it also has a large electrical connector on it.

Feb 28, 2012 | 1994 Toyota Land Cruiser

1 Answer

Where is the fuel filter located on a 1991 toyota land cruiser?


It should be under vehicle, passenger side, below seating area, passenger side of transmission, mounted on frame in fuel line.
If you have not changed in a few years I would first spray with oil of some type for a week or two every day as it is probably very rusted

Feb 17, 2012 | 1991 Toyota Land Cruiser

1 Answer

Fuse for sun room, 1991 Land Cruiser


On the Land cruiser there are two fuseboxes. One is beside the battery. The other is just above the drivers right knee. There is a fuse panel under the drivers left knee and an additional one in the engine compartment on the left front fender well along with relays. Look in these to find the sun roof fuse. I'm not a 100% sure which one it is in but this should help.

Jul 14, 2010 | 1991 Toyota Land Cruiser

1 Answer

Where can I get the user and service/repair manual Toyota HZJ77?


Try http://www.toyota.com

Make enquiries from them, they'll send you a pdf if you request for 1.

Rate this

Apr 06, 2009 | 1991 Toyota Land Cruiser

1 Answer

Differetial locks for 94 land cruiser


91-97 Land Cruisers had a factory option for front and rear locking differentials. This is a seperate switch and is usually located to the left of US model Land Cruisers. The center dash button locks your transfer case differential changing your Land Cruiser from all wheel drive to four wheel drive depending if you have ABS or not this button either says ECT or Center Dif Lock. If you do not have the Front/Rear locking differential option then your Land Cruiser has open Front and Rear. Hope this answers your question.

Jan 19, 2009 | 1994 Toyota Land Cruiser

1 Answer

Overheating 1991 toyota townace


most engines the thermostats let water out into the top hose . toyotas thermostat is fitted in the engine block letting the water into the bottom hose. water goes the opposite way around.

Jan 15, 2009 | 1991 Toyota Land Cruiser

Not finding what you are looking for?
1991 Toyota Land Cruiser Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...