Question about 1994 Honda Accord

1 Answer

DRL PROBLEM DRL dosent work, when i start my car DRL dosent work,and also when turn on the light and trying to go to high beam,only left high beam works and right high beam stay off.I checked bulbs are good. What is the problem? ASIM

Posted by on

  • Anthony Gonzalez Oct 27, 2008

    i have the same problem but mine the Low ligths sometime works and sometime no works, The bulbs are good.



    3 weeks ago i cleanned the connector near or the bulbs and was working just for one day after that stop working again. any help please. thank !

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Guru:

    An expert who has written 7 tips or uploaded 3 video tips

  • Expert
  • 200 Answers

Check fuses, check wiring.

Posted on Oct 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4 Answers

I have a 2006 civic SI. DRL indicator is on, driver side low and high beam ok. Passenger side low beam ok but DRL and hi beam not working. Any help is appreciated.


When either the high or low beam light is out in either side, DRL (daytime running lights) indicator will come on. When one bulb goes out, that's a clue the opposite bulb will burn out soon, so its best to replace both bulbs. If it was a fuse issue, both left and right side would be out. If driver side is OK but passenger side is not, then its a bulb issue. A 2006 Honda civic takes 9006 (HB4) low beam bulbs and 9005 (HB3) high beam bulbs. Cheapest is online from Walmart site-2-store. After procuring, wear latex, vinyl, or ANY gloves to keep your (corrosive) oil skin from coming in contact with headlight glass bulbs. Your skin oil will chemically react and cause shorter life span on glass bulbs. Instruction don't tell you this, so you handle with your hands, then need to replace bulbs 3 years later instead of 5 years (or more) in the future. With gloves on, pop the hood and look behind each headlight. Turn counter clockwise to unlock headlight bulb holders. Its a quarter to half turn to unlock bulb holder lock. Replace one bulb at a time so you don't confuse high beam from low beam. The wire has a tab you need to lift to pull out & disconnect wire connector. You might need a slim narrow-**** (NOT phillips) screwdriver to lift the tab; or use your house key. Snap the wire connector to the new bulb, then twist into headlight housing to secure bulb holders, then move on to the next bulb to repeat the procedure. Pict below, 9005 high beam is on the left, 9006 low beam is on the right. Handle by grasping the plastic base, not the glass bulbs. The raised potrusion on the bottom center is where the tab locks onto wire connector. Replace all 4 bulbs now, but in the future, its likely the low beam will wear out before the high beam. In the future, replace only the pair, not all 4. The factory installs inferior bulbs that go out sooner, hoping you'll take to dealership and they ******** you with higher parts-n-labor fees. As opposed to Walmart online site-2-store, it would cost you AT LEAST triple in parts & labor from dealership to replace all 4 headlight bulbs :-(
45d1f6ac-2983-42b9-a46c-30ef441b89e7.jpg

Nov 29, 2013 | 2006 Honda Civic

3 Answers

Daytime Running Lights Inoperative 2002 Toyota Camry


[Information] For a 2002 Toyota Camry, the Daytime Running Lights (DRL) operate utilizing the High Beams (inner Lamps closer to the center of the vehicle front) at a reduced power.

[The troubleshooting process:] Review the Owner's Manual and ensure the test configuration matches the following criteria:
1. According to the 2002 Toyota Camry Owner's Manual (Check your Owners Manual):
"The DRL system will make your headlights come on at a reduced brightness when:
The light switch s in the "DRL" position.
The ignition is on with the engine running.
The headlight switch is off.
The parking brake is released."


2. Set the Test Conditions according to Step 1 above.

3. Check the headlight bulbs to ensure they are not burned out. If one burns out, there is a fair chance that the other would have burned out at the same time. Replace as necessary. In this case, if the high beams operate, the DRLs should also operate.
4. Test the system, ensuring the step 1 conditions are set. (Engine running, Multi-function Switch on Turn Signals in "DRL" position, headlight switch off (repeating what the manual says -- it should be obvious that in the "DRL" position, the headlight switch should be off / do not have the switch positioned to "High Beam"), and the Parking Brake "off").
5. If DRL lights do not work, check the engine compartment Fuse and Relay Box. there is a 5 Amp DRL fuse -- replace it with the spare. Test (step 4).
6. If it does not work, swap around or replace relays -- there are three (3). Any one of them could be bad (stuck or burned out). Test (step 4).
7. Other less likely possible issues could be that the Multi-function Switch is broken or a connection / wire is broken. [Beyond the scope of this process.]


My problem was that the test configuration did not have the engine running and parking brake off - Step 1. Problem solved with much thought, repetitive tests on the vehicle and going back to the basics -- what does the Owner's Manual say and where are the applicable fuses and relays located?

Dec 30, 2011 | 2002 Toyota Camry

2 Answers

Daytime running light module location 2001 impala


The daytime running lamps in your 2001 Chevrolet Impala are controlled by the Body Control Module (BCM) Here is a description of how the system works:

The ambient light sensor is a light-sensitive transistor that varies its voltage signal to the Body Control Module (BCM) in response to changes in the outside (ambient) light level. When the BCM receives this signal, the BCM turns ON either the DRL or the headlamp relay for auto headlamp operation. Any function or condition that turns ON the headlamps will cancel the DRL operation.
Thirty seconds after you start the ignition with the headlamp switch set in the OFF position, the DRL will perform one of two actions:

Illuminate the high beam headlights at a reduced intensity in daylight conditions
Illuminate the low beam headlights in low light conditions
The DRL/EXT lamps fuse in the top of the engine fuse block supplies battery positive voltage to both the DRL switch contacts and to the DRL relay coil. When the BCM energizes the DRL relay coil, current flows through the right high beam lamp, to the left hand high beam lamp, to the energized DRL relay switch contacts, to ground G101.
The high beam headlamps are now in series, and split the voltage so that the headlamps illuminate at halt intensity. The DRL operates when the ignition switch is in the RUN position, and the parking brake is not set or the transmission is not in park. When these conditions have been met and the ambient light sensor indicates daytime conditions, the DRL will illuminate.

Oct 10, 2011 | 2001 Chevrolet Impala

1 Answer

I have a 94 Nissan pickup, I don't know if it has daytime running lights (DRL) or not however the issue is that the driver side head lamp turns on when start the engine. The passenger side does not. The...


i have a 94 nissan pickup, the right side light beam works low and high but the left side dosnt work.... my friend thinks its aground problem how ever there appears to be ablack box looking like a day time night time module located at the left fender inside ...behind the battery fastened by two screws holding it to the body....

Nov 13, 2010 | 1994 Nissan Pickup

2 Answers

Repair a stuck DRL relay on a 1997 Pontiac Sunfire? At least I think it's stuck. The DRL don't work but if I turn my lights on the low beams work and when I switch to high beams the passenger side...


Passenger side high beam element burned out. DRL problem might be the emergency brake suppose to turn off when engaged. Slightly depressed will cause DRL not to work.

Sep 27, 2009 | 1997 Pontiac Sunfire

1 Answer

Day time running light problem


The problem with the DRL issue describd in the above posts is the DRl module(it needs to be replaced). The buzzing relay and intermittent on/off of passenger side DRl are indicators that the module needs to be replaced.

Feb 14, 2009 | 2004 Honda Pilot

1 Answer

Honda Accord 1994 LX DRL not working


check the fuses under the hood or relays for ur headlights

Oct 23, 2008 | 1994 Honda Accord

1 Answer

Left blinker works, but left daytime running light does not.


The DRL is usually a high beam run at about 80%. Do both high beam bulbs work? If not, replace the bad one. If they do work as high beams but not as DRLs, replace the DRL relay.

Aug 02, 2008 | Pontiac Montana Cars & Trucks

1 Answer

DRL and High Beam do not work right on Honda Accord EX 1998


Some time back I found some data on a similar website suggesting that the Day Light Running circuit board, just under the steering column, developed cracks in some of the soldered joints. Your high beams should also be affected with loss of day light running lights.
Resoldering repaired the continuity of the circuits. Ours is now working quite reliably. Some of the defective areas developed slight brownish discoloration, that's how I was told to recognise the areas to be resoldered. Hope this will help you solve your problem.

May 24, 2008 | 1998 Honda Accord

Not finding what you are looking for?
1994 Honda Accord Logo

Related Topics:

429 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...