Question about Cars & Trucks

Open Question

Po183 where is the sensor located for a 2004 nissan sentra

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jadyn08
  • 12 Answers

SOURCE: crankshaft position sensor for 2004 nissan sentra.

mikeworden, It is located on the passenger side,down by the crank pulley near the backside of the engine.

Thanks.

Posted on Nov 15, 2008

  • 14036 Answers

SOURCE: can't find the location for the crankshaft position sensor

you need a haynes manual . because crank sensor can be behind crank pulley or on bottom side of engine that why you need a manual save you time.

Posted on May 13, 2009

SOURCE: WHERE IS THE CAM POSITION SENSOR LOCATED ON A 2004 NISSAN MAXIMA

WHEN YOU STAND ON THE FRONT OF THE CAR YOU ONE IS RIGHT BELOW OF THE INTAKE WHICH IS BANK 2 OR THE ONE CLOSE TO FIREWALL , BANK 1 ONE IS ON SAME SIDE NEXT TO THE RADIATOR BUT THEY BOTH ON THE CAM RIGHT SIDE OF THE ENGINE, THE EASIEST WAY TO IDENTIFY THEM IS THAT THEIR CONNECTOR IS GREEN, ONCE YOU LOCATE THEM THE CLIP NEEDS TO BE PUSHED DOWN TOWARD THE SENSOR FOR THE CONNECTOR TO BE RELEASED, ONCE YOU REMOVE THE CONNECTOR THERE WILL BE ONLY A 10MM SCREW HOLDING THE SENSOR PULL IT OUT , THE SAME SETTING THE NEW ONE PUSH IT ALL THE WAY IN , THIGHT THE 10MM SCREW, CONNECT IT BACK AND YOU'RE DONE,BUT FOR THE ONE ON THE BACK SOMETIMES MIGHT BE NECESARY FOR YOU TO TAKE THE INTAKE OFF....HOPEFULLY IS NOT YOUR CASE....



Good luck!!! and if you need the crank for hard starting on hot/warm, it is located on the botton middle section on the transmission is the only cable that goes down to a small piece of metal and it is held by a 10mm screw only to protect the sensor, you will se the sensor once you remove that small about 6-8 inches piece of metal. Then you'll be able to unescrew the 10mm screw that holds the crank position sensor. when you pull it off you'll be able to see the fly wheel inside the transmission...



you all enjoy your rides out htere!!!

Posted on Jul 01, 2009

  • 19 Answers

SOURCE: 2000 Nissan Sentra Crankshaft Position and Replacement

Go to dealership they will give a diagram to locate every single one. I replace them on my daughter car. I believe there were three sensors. I exactly know what you are talking about. I had a hard time locating the back one right above the drive shaft on driver side.

Posted on Oct 03, 2009

jturcotte
  • 8142 Answers

SOURCE: where is the coolant sensor located on a nissan

I assume you are referring to the coolant temp sensor. as you look at the front pulleys of the engine, its on the right side behind a bracket just above the alternator. See picture below and let me know if you have questions. If you are referring to the coolant level sensor, it would be on the side of the coolant reservoir.

jturcotte_134.gif

Posted on Nov 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan Sentra 2004 oxygen sensor


There are two O2 sensors in 04 Nissan Sentra. One is located in engine compartment in Exhaust manifold while other is located at bottom of car behind catalytic convertor.

Jun 13, 2013 | Cars & Trucks

1 Answer

07 nissan sentra 2.0 crankshaft position sensor location


front of engine, left side, below the camshaft sensor, get a repair manual , HAYNES it will help you be a mechanic , & tell you what all the sensors do, are located, & so on .....................

Jan 28, 2013 | 2004 Nissan Sentra

1 Answer

Po183 nissan murano 2004


Version:0.9 StartHtml: 105 EndHtml: 1264 StartFragment: 334 EndFragment: 1232 The fuel tank temperature sensor is used to detect the fuel temperature inside the fuel tank. The sensor modifies a voltage signal from the ECM. The modified signal returns to the ECM as the fuel temperature input. The sensor uses a thermistor which is sensitive to the change in temperature. The electrical resistance of the thermistor decreases as temperature increases.

Apr 18, 2012 | 2004 Nissan Murano

1 Answer

Where is the throttle position sensor located on a nissan sentra 2004 1.8s


THE TPS SENSOR LOCATED ON THE END OF THE THROTTLE SHAFT ON THE THROTTLE BODY.

Aug 30, 2011 | 2004 Nissan Sentra

1 Answer

My 2004 nissan sentra will not start, just turns over.obd code po455,po183 and po463 not sure what to check. I tried gas cap, took gas line off and turned car over but no fuel, it my be my fuel pump but...


P0183 = Fuel temperature sensor A circuit, high input

P0455 = evaporative emission (EVAP) control system leak detected (no purge flow or large leak)

P0463 = fuel level sensor circuit, high input.

Check to see if the charcoal (evap) canister is full of fuel. If so, empty it. Check for a faulty canister vent valve. Check for a short to ground in wiring to fuel temp sensor and fuel level sensor.

Feb 27, 2011 | Nissan Sentra Cars & Trucks

2 Answers

Where is the throttle position sensor located on a 2005 nissan sentra


For every car that is equipped with a throttle position sensor, it is located in the same place...on the throttle body.

Feb 20, 2011 | 2004 Nissan Sentra

1 Answer

Where can i find the engine coolant sensor on


It is located at the back of the head in the coolant passage that the lower hose connects to.

Dec 05, 2009 | 2004 Nissan Sentra

1 Answer

Crankshaft position sensor for 2004 Nissan 1.8 eng.


This sensor is located at the crankshaft pully . the sensor is mounted on the block

May 22, 2009 | 2004 Nissan Sentra

3 Answers

Crankshaft position sensor for 2004 nissan sentra.


will the crank sensor cause the vehicle to shut down while running?

Nov 14, 2008 | 2004 Nissan Sentra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...