Question about Cars & Trucks
Need to remove bumper to fix dent in drivers side
What year? if its older then its just 4 (on on each side) mounting bolts to the frame. if its newer its the same however there may be body screws to the fenders and any farings, also do not mess with it unless you disconnect battery/disable the airbags if its the front bumper and unplug license plate lights if its the back
Posted on Feb 12, 2012
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
That works fine on a relatively new vehicle but one that has run in salt etc you'll save a lot of time if you remove the steering knuckle completey by separating lower ball joint and outer tie rod end ball joint and bring the whole steering knuckle to a bench to separate the hub/bearing. Soak everything with penetrant, loosen the bolts a few turns and try hitting right on the bolt heads. I also made a very sharp wedge from a chisel and rammed it hard on the other side to seoarate the hub. It will finally come apart then you'll see all the **** that was binding it due to an alumininum knuckle re-acting with a steel hub. Clean the hole and grease everything and fit new bearings
Posted on Feb 15, 2009
The combination fuel filter and fuel pressure regulator is used on all engines. It is located on the top of the fuel pump module. A separate frame mounted fuel filter is not used with any engine.
Both fuel filters (at bottom of fuel pump module and within fuel pressure regulator) are designed for extended service. They do not require normal scheduled maintenance.
Posted on Mar 22, 2009
There are plastic clips that hold the door panel inplace .. First look for any hidden screws near the door handle . there might be a little plastic cover that you need to remove with a small screw driver to find the screws.. look under the handle also to see if there are any hidden screws . next take a flat blade screw driver and start at the bottom corner and try gently prying the door panel off . try to stay close to the plastic clips not to damage them by prying real hard .. once you have snapped them loose all the way around .. lift up on the door panel to remove it from around the window lip and out it should come.. holler if you have any problems.. usually The mirrors on the chevys are up above the panel and there is a triangle plastic cover over it on the inside .. it will pry off also gently and there are 3 nuts there that need to be removed .. use caution these fall behind the door panel ... holler if you need more. Jerry
Posted on Apr 24, 2009
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them.
Posted on Aug 14, 2009
Tips for a great answer:
Jun 20, 2017 | Honda Cars & Trucks
Feb 10, 2016 | 2012 Buick LaCrosse Base Sedan 2.4L 4-cyl....
Mar 23, 2015 | 1997 Dodge Ram 1500 Club Cab
Dec 07, 2012 | 2007 Chevrolet Impala LS Sedan New Cars
Dec 06, 2011 | 2001 Dodge Ram 1500 Truck 2WD
Jul 01, 2009 | 2000 Toyota Corolla
Apr 03, 2009 | 2006 Toyota Sienna
Feb 24, 2009 | 2003 Toyota Camry
Jun 16, 2008 | 2004 Toyota RAV4
86 people viewed this question
Usually answered in minutes!