Question about 2005 Kia Sedona

Open Question

2005 kia sedona engine code p0320 - 2005 Kia Sedona

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75807 Answers

SOURCE: kia sedona

P1119 Inlet Metering Control Abnormal

Posted on Feb 17, 2009

emissionwiz
  • 75807 Answers

SOURCE: i have codes po430 and p2422 kia sedona

P0430 Catalyst System Efficiency Below Threshold (Bank 2)
P2422 Evaporative Emission System Vent Valve Stuck Closed

Posted on Jun 19, 2009

MNfisherman
  • 11896 Answers

SOURCE: 03 Kia -P0320 Ignition/Dist Engine engine Speed

You most likely have a bad crank or camshaft sensor. Either way it is a bad sensor that is not being read correctly by the computer.
You can go to autozone.com and register for full free online repair manual. It will also tell you exactly what the code is for and what should be replaced.

Posted on Sep 28, 2009

  • 87 Answers

SOURCE: Crankshaft position sensor replacement on 2005 Kia Sedona

the crankshaft position sensor for that car is located on top of transmission housing close to engine block.

Posted on Jan 26, 2010

  • 67 Answers

SOURCE: 2005 Kia Sedona, Trouble Code P0320. Everything I

This is a common problem usually related to the crankshaft position sensor. Before you replace it, disconnect the electrical connector to the CPS sensor and clean it with electrical contact spray and add a dab of dielectrical grease. If the problem continues, replace the CPS sensor. It is easy to replace and is not very expensive. It just bolts to the engine block with one or two bolts. I believe the CPS sensor on the Sedona is behind the timing cover on the front of the engine.

Posted on Feb 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kia sodona wont start


Have you had the battery tested?


And you can also get some OBD2 scanner to check your car.

Sep 12, 2012 | 2005 Kia Sedona

1 Answer

Kia sedona 2005 cold start rpms?


Around 1500 for the first few seconds depending on engine and air temp.

Aug 03, 2012 | 2005 Kia Sedona

2 Answers

2005 kia sedona engine coolant sensor


The Engine Coolant Temperature (ECT) Sensor is located in the thermostat housing of the cylinder head.


2005-kia-sedona-engine-coolant-sensor-ir03o0ur3ff3pxc4zrfsqvc4-3-0.jpg

Jul 26, 2012 | 2005 Kia Sedona

1 Answer

2005 Kia Sedona Fault Codes


you can try to read the fault codes with ELM327 V1.5 scanner, and know where is the problem, and then you can fix the problem. It is cheap and easy to operate.

Jun 26, 2012 | 2005 Kia Sedona

1 Answer

What is the engine belt routing on a 2005 Kia sedona


The engine belt routing. See pictures below:
1. For Kia Sedona 2.5 V6 engine (engine code GV6):

285e4ae.png

2. For Kia Sedona 2.9D CRDi engine (engine code: KJ):

47e707d.png

Feb 25, 2010 | Kia Sedona Cars & Trucks

1 Answer

2005 Kia Sedona, Trouble Code P0320. Everything I read online tells me its a Crankshaft Sensor. I called Kia and then sent me to www.kiatechinfo.com were it says that the code is an Ignition System Failure...


This is a common problem usually related to the crankshaft position sensor. Before you replace it, disconnect the electrical connector to the CPS sensor and clean it with electrical contact spray and add a dab of dielectrical grease. If the problem continues, replace the CPS sensor. It is easy to replace and is not very expensive. It just bolts to the engine block with one or two bolts. I believe the CPS sensor on the Sedona is behind the timing cover on the front of the engine.

Feb 08, 2010 | 2005 Kia Sedona

1 Answer

I went to have an emissions test and I failed.


code P0320 stored.
Tests/Procedures:
1. Check if the oil pump drive housing has rotated on the hold down clamp. If it has, replace the oil pump drive gear and housing.

2. Scope the Crankshaft Position (CKP) sensor.

3. Scope the Camshaft Position (CMP) sensor.

Potential Causes: Camshaft Position Sensor (CMP)
Crankshaft Position Sensor (CKP)
Distributor Sync

Only a qulified mechanic will be able to tell you the cost once he eliminates each possibility.

Jan 31, 2010 | 2003 Kia Sedona

1 Answer

03 Kia -P0320 Ignition/Dist Engine engine Speed Input Circuit Malf. What does that mean?


You most likely have a bad crank or camshaft sensor. Either way it is a bad sensor that is not being read correctly by the computer.
You can go to autozone.com and register for full free online repair manual. It will also tell you exactly what the code is for and what should be replaced.

Sep 28, 2009 | 2003 Kia Sedona

1 Answer

Check Engine light on 2005 Kia Sedona


This is the KIA tech site. Free to register and use. It lists the repair tech manuals, Sevice Bulletins,Trouble Code identifications, How-to's, and troubleshooting guides the factory trained repair guys use:
http://www.kiatechinfo.com/index.asp

AutoZone will read trouble codes for free

Mar 17, 2009 | 2005 Kia Sedona

Not finding what you are looking for?
2005 Kia Sedona Logo

Related Topics:

235 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...