Question about 2003 Chrysler PT Cruiser
Recently had car repaired as hose or something needed replacing..car was "kangerooing"...anyway now drives lovely but since the repair it fogs up really badly,the side round vents on the dash dont seem to have any air coming out although my mechanic assures me its all working fine?cant see out of the side windows which is a bit dodgy.never did anything like this before? what do you think could have happened?
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: fog lights staying on
1st most newer car cars have a timer delay that helps light the area you are in for a couple of seconds. You may have had the knob turned all the way up on the turn signal switch. The same thing will happened if this switch is turned all the way up, the interrior light will stay on. Turn the lights on with the switch and see if the fog lights come on, do this without the car running.Trun the lights off,see if the fog lights stay on then go out after a while.if so you have a delay on the fog lights or relay. You may need to replace the relay only. Part $ 15 trace fog light wiring to relay usually under hood away from water sources.......runjoe
Posted on Mar 02, 2009
rather than doing that I would take a 1/64 drill bit and drill a hole on the back of the headlight this will let it breathe better.
Posted on Apr 11, 2009
1.At first take out the foglight's fuse before you battery is dead. (Fog lights stays "ON" even you leave the car).
2.You must replace the Multifunction control switch =(
Here is the photo of problem:
Fog lights are connected to pin 13,14.
Fog light switch is "B". Because the current is many Amps, contact surfaces are heating up.
After that the contact opening "C" is melting (made of plastic) so the fog light stays "ON".
Posted on May 29, 2009
There are 2 possibilities. It is on Power distribution Center (mine was there)
or Fuse Block
Here are the photos:
If you like to fix your fog lights, you must replace malfunction switch. It is a typically PT-Cruiser problem.
Posted on Jun 05, 2009
Tips for a great answer:
Mar 26, 2016 | 2002 Chrysler PT Cruiser
Jan 02, 2016 | 2003 Chrysler PT Cruiser
Dec 07, 2012 | 2003 Chrysler PT Cruiser
Mar 09, 2017 | 2005 Chrysler PT Cruiser
Jun 04, 2009 | 2002 Chrysler PT Cruiser
May 20, 2009 | 2002 Chrysler PT Cruiser
May 11, 2009 | 2002 Chrysler PT Cruiser
Jan 30, 2009 | 2002 Chrysler PT Cruiser
116 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: