Question about Ford Mondeo

Open Question

2008 ford mondeo 2.0l petrol engine light on traction control light on and abs light on any ideas what mat be wrong

Engine managment light abs light and traction control light all staying on when driving any idea what may be wrong

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2920 Answers

SOURCE: ESP/ABS warning lights illuminates

the abs switch could be going bad or the relay for it could be weak.the relay is under the hood.have it checked taking care of one problem could solve the other

Posted on Nov 16, 2008

madadam1965
  • 79 Answers

SOURCE: ford mondeo 2001 has misfire and wont tick over

Any engine will have trouble ticking over if only 3 of the 4 cylinders are working. Check the spark plug for a consistent spark on all cylinders. Check the connections to the fuel injectors on the cylinder head, and check the compression in all cylinders (take spark plugs out and use a compression tester whilst turning the engine over on the key). Low compression in one cylinder may mean head gasket failure, valves out of adjustment (staying open) or bigtime piston or piston-rings failure.

Posted on Sep 07, 2009

Testimonial: "thanks"

michigan man
  • 3533 Answers

SOURCE: 2007 ford edge, three lights are on: ABS, wrench

it sound like a ABS-sensor is sticking are its bad give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car wish you the best of luck Michigan Man.

Posted on Jan 12, 2010

  • 84 Answers

SOURCE: ABS & traction control just went out on 2008 Ford Escape.

Chances are it is a bad ABS sensor. Need to get scanned to know for sure and which one.
Not much i know but I hope that helps.

Posted on Feb 03, 2010

  • 1 Answer

SOURCE: both abs and traction control light stays on also

my engine light and the tcs light stays on and the car is running rough any help

Posted on Feb 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 ford escape traction control light abs light and brake light are on contstant and it barely moves


check hub /wheel bearing and or brakes for damage or failure --also need to check the abs system which is incorporated into the hub
2008 Ford ESCAPE Traction Control System problems defects barely moving is possible your in limp mode --if drive able need to have scanned for trouble codes to see if its abs or other possible problem

Dec 28, 2016 | Ford Cars & Trucks

1 Answer

2008 ford escape abs and traction control light is on, if the car sets over night the traction control light and abs lite doesn't come on until a few minutes and after the car sits around awhile the...


2008 Escape has a terrible reputation for ABS light and traction control light being. All due to broken ABS tone ring cracked and out of position flopping on frt bearing. Go to local AutoZone store and they will scan this to find which wheel has the broken tone ring. The replacement ring is cheap in the $7 range. It is labor that will sicken you as this ring must be pressed on after the front half shaft is removed. Not a driveway job if you are considering DYI.

Jun 21, 2011 | Ford Escape Cars & Trucks

1 Answer

I have a 2008 Ford Taurus x that went into limp mode while I was pulling onto a 4 lane highway. Nearly hit by semi this is not a "safe mode" The traction control light started blinking and the...


I have run into this on several fords this winter. What I have found in all of them is that a speed sensor had not necessarily failed but was no longer providing the correct information. The traction control saw this as "wheel spin" and started to apply the brakes to the wheels that where "spinning" although they where not.

Since this happened from a dead stop the ABS would not see the fault because all of the sensors started at 0 mph and only one stayed at 0mph and according to the programming this is perceived as wheel spin.

The pop and grind was the abs system kicking in. The traction control system uses the ABS system to control wheel spin.

If the system did not act up at the shop than there is no way they will be able to resolve it until it happens for them. All the ones I have dealt with have had no trouble codes but the symptoms where present and like you found out nearly impossible move (to pull into the shop)

Feb 16, 2011 | 2005 Ford Freestyle

1 Answer

ABS & traction control just went out on 2008 Ford Escape.


Chances are it is a bad ABS sensor. Need to get scanned to know for sure and which one.
Not much i know but I hope that helps.

Feb 03, 2010 | 2008 Ford Escape

1 Answer

I have a problem on my mondeo st tdci withthe


hi check your coil first if this faulty it can cause all these problems please rate this answer good luck

Nov 19, 2009 | 2005 Ford GT

3 Answers

Both abs and traction control light stays on also spedo not working have checked all related fuses all ok have tried to scan with both snapon solus and launch x431 niether will communicate with abs ecu but...


had my 2000 chev impala 3.8 liter ,traction control llight and abs light both go on the reset it and go right back on .so i replaced both sides of the bearing hub assembly this is connected the senser,so far so good.replaced it dec 21 2009 about 3 hours ago. because the assembly came appart when took off.

Oct 30, 2009 | 1997 Acura CL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...