Question about Nissan Frontier

1 Answer

2000 nissan hazard lights and door locks go on and off by them selves

For no reason the doors lock, lock while I'm driving and also the hazard lights come on. I've seen the hazard turn on and I didn't have the key in the ignition.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 113 Answers

Your and all hazard light systems works hot all the time mean works even car is off!!
you may have problem with your electrical system good idea to get check by electrical specialist! its can be simple worn fuse or relay but right trouble shooting save you money and time!

Posted on Feb 11, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My hazard lights and door locks engage when I accelerate in my 2000 Volkswagen passat


well its normal for door to luck when u start to drive in all Passat or vw. the hazard switch could have short in it or outside where the bulbs are located(inside the wiring of bulb socket). it could also be on ON position. change the hazard switch itself.

Mar 06, 2014 | Cars & Trucks

1 Answer

2000 jeep cherokee door locks click on &off driveing


bad door switches. and locks
get it serviced,
or if DIY person, read the FSM
for the locks, i disconnect the door controls to isolate the cause.
interior lights. are door open switches, the same book covers
the solving of that , circuit.
one switch is stuck, we use Ohmmeter to find it. (resistance or live volatage checks)

Jan 11, 2014 | 2000 Jeep Grand Cherokee

1 Answer

How do i reset central locking on a micra 04 reg


Try the following:

"KEY FOB PROGRAMMING
NISSAN
SYSTEM DESCRIPTION
The Central Door locking is controlled by the Multi-Remote Control system which controls
the door locking, door super locking and hazard reminder. When the doors are locked and
unlocked the unit flashes the hazard lights once for lock and twice for unlock.
A maximum of four remote controls are allowed to be programmed.
ALMERA
ALMERA TINO
PRIMERA
MAXIMA
MICRA
SERENA
VANETTE CARGO
TERANO II
Ensure all the doors have been unlocked, either by using a good transponder key or remote
control plip key.
Procedure
1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds.
2. Then turn ignition switch to OFF position. Leave key in ignition switch.
3. After 2 seconds, the system will enter programming mode and will flash the warning
lights twice.
4. Press and HOLD the unlock button on the Plip.
5. While pressing the unlock button, press the lock button 3 times.
6. Release the unlock button.
7. The warning lights will flash once to indicate successful programming.
8. Repeat procedure 4 to 7 for up to 4 plip key?s.
9. When completed turn ignition ON, and the warning lights will flash 2 times.
10. Remove key, and check all plip key?s for operation.
NOTE : The programming mode will stop when either the ignition is switch ON, 4 plip keys
have been programmed or no input signal either from the switch or plip keys has been received
for 120 seconds."

Mar 12, 2012 | Nissan Cars & Trucks

1 Answer

Audi tt x reg - the key fob is not working. Additionally, the hazard warning lights intermittently come on when i the engine. The hazard warning lights do not stop flashing and i often have to try...


this can be a big problem so will start on easiest first. and try to repair as going, the passenger door the problem with this could be the solenoid for the door lock. and or the switches in the lock. driver door has the same but is the master door. ie if you open door from unlocking at pass door it will only open this door, drivers side will open all doors. flashing hazards this could be because the alarm is not completely turned off this could be because of the doors, mainly the drivers side. try to find the fault with the door lock and get back to me when you have found the fault. you will need a meter to check for volts and the switches, check them as lock unlock from the inside and the key to make sure they working. dpd spray should be able to clean them if you can spray into the lock and housing that is plastic. give a good flush out after its working wipe up the mess from the spray and mear grease on the lock moving parts.

Jun 26, 2017 | 2000 Audi TT

1 Answer

Door open indicator light stays on , automatic door locks go on & off while driving and dome light and outside mirror lights wont go off after the car is turned off


i would hazard a guess and say that wires in the rubber boot from the door pilar to the door are damaged or the connection block in the door pillar in this the terminals are corroded or something similar

Nov 22, 2011 | 2002 Mercury Sable

1 Answer

I have a few electrical problems doors lock and unlock by them selves.only passenger side lights front and back flash when lock and unlock doors.blows fuse on tailights.sometimes alarm sounds and other...


hav car scanned--u may need the modules reprogrammed that operate those accesories--on some expensive autos a certain diagnostic tool is used for the door area

Jun 19, 2011 | 1999 Mercedes-Benz SLK

2 Answers

Town & Country the Power locks


check the switches in the door pillars first then the rubber boot where the cables go from the door to the door pillar

Nov 21, 2009 | 2002 Chrysler Town & Country

1 Answer

Need to know where the horn is located under hood


I suspect right front near battery. On my last Mazda it was there

May 01, 2009 | 2000 Mazda 626

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

209 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...