Question about 2003 Toyota Tacoma

Open Question

Horn fuse box on 2003 toyota tacoma - 2003 Toyota Tacoma

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1999 toyota corolla Horn doesn't work.

Usually the wire from the steering wheel is Green w/Red and the wire to the horn from the fuse box is White. There is only one fuse, sometimes shared with the emergency lights. Check to see if there is power to the horn itself with a volt meter.

Posted on Dec 30, 2008

Ad
  • 1 Answer

SOURCE: where is the horn relay on a 1998 toyota tacoma

left of steering column almost behind fuse box way at the top you have to stick your head under there with a flash light to see it but it's there.

Posted on May 09, 2009

  • 87 Answers

SOURCE: need fuse box diagram for 1996 toyota tacoma

go to local library and look @ hanes manual for free. You can also purchase one at napa or autozone, or buy the toyota shop factory manual for 100 dollars.

Posted on Jun 05, 2009

  • 1 Answer

SOURCE: 2003 parking bulb toyota tacoma

OK, I just fixed mine. The unit pulls out. You have to get a screwdiriver, wrap it with a cloth so it doesn't scratch the paint, then gently wedge the entire unit out. When it pops out, you'll see the clips that keep it in place. You might think its breaking when you pull it out, but trust me this is how you do. Just be gentle with it. After you get the unit out, simply take the socket out and replace the bulb. I did it in five minutes.

Posted on Nov 14, 2009

Pointnino
  • 14 Answers

SOURCE: check engine light on 2003 toyota tacoma, O2 sensor?

An O2 sensor code is a tricky one. It could mean SEVERAL different things, and I know how bad it sucks to hear this, but your best bet is to take it in and have a diagnostic ran on it at either a dealer or a good mechanic shop with a computer they can hook up to it. I had an "O2" code come up a while back on another car I used to have, and literally spent weeks and hundreds of dollars trying to fix it, and never did. Finally out of desperation took it in, paid the $90, and they found the problem and fixed it in like 30 minutes. Something I would have never even thought of was causing it (can't remember off the top of my head). After that I stopped wating time and money on check engine lights. One comes on in my car, I take it to have it ran for free at and auto parts store just to make sure it's not a loose gas cap or something, just to get an idea of what I'm looking at, then go and make an appointment to have to hooked up to a diagnostic computer to track down the problem. Good luck, and hope this helps save you some time and money.

Posted on Apr 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I am looking for the fuse to the power ports located under my cigarette lighter in my 2003 Toyota Tacoma .


HERE IS A LINK ON YOUTUBE WITH A FEW VIDEOS...MAYBE YOU CAN FIND WHAT YOU NEED.....
https://www.youtube.com/results?search_query=POWER+PORT+FUSES+2003+Toyota+Tacoma

Dec 02, 2014 | 2003 Toyota Tacoma

2 Answers

How do you fix the horn of a tacoma truck?


Have you checked the horn relay to see if it is working ?

Jul 16, 2014 | 2004 Toyota Tacoma

1 Answer

Where is Radio fuse on toyota tacoma 2003


My radio stoped then I noticed so was my cruise control and rear view mirrors it was the acc 15a fuise on my 2003 tocoma I found it all in the manual

Aug 02, 2013 | 2003 Toyota Tacoma

1 Answer

2000 Toyota Tacoma Horn Relay location needs replacing


1- The HORN fuse is located in the fuse panel on the driver's side under the engine hood. Of course, if it is "blown" replace with the SAME size or smaller and retest the horn.
2- Verify the horn itself (isolated) using one wire attached to the Main Battery + (POSITIVE) to the spade terminal on the horn. The horn can be accessed after carefully unclipping the fasteners connecting the front grill to the radiator area- just be careful- work slowly. The horn is naturally grounded to the vehicle frame.
3- If the horn sounds with the direct bypass voltage test move to the cab. when you depress the combo horn pad/airbag listen carefully for the relay behind the left under-dash area. If you hear it, then the relay is "closing" but it still may be bad or the voltage from the horn relay is not getting to the horn. I would replace the relay. However, there may still be a wiring problem to the horn.
4- The Horn Relay for the '00 Toyota Tacoma V6 4WD I worked on was BEHIND the cabin fuse panel on the far left driver's side (oh thanks guys). I went to the trouble of pulling down this relay/fuse block- it was not exactly "easy" but I am not a beginner and had the tools and my curiosity and sleuthness prevailed. If the new relay does not fix this issue my next step is to replace the wire from that relay to the horn. Again, not easy but not impossible either. Take you time, use the right tools and materials & check your work. The only other option was mentioned earlier- drop in a new momentary switch (lighted?) into the dash and run a new wire. I would NOT use switched power so it can be used without the vehicle running... I think it is safer. This is a view of the interior panel dropped down. One of the relays can be seen- the grey cube with a empty relay socket just to the right. Why they put these here- is anyone's guess.
dd4132f7-8aa0-48cf-bfcf-8b105e59429b.jpg

Feb 18, 2013 | 2003 Toyota Tacoma

1 Answer

Toyota Tacoma '03 horn sticks


If you are getting water in the fuse box, it could be shorting the system out and in turn the horn would blow. Some manufactures put 2 fuses for the horn too. One for the horn and one for the horn relay. That is another one, maybe the relay is bad or wet. Hope i put some light on your answer. Good luck!!

Jun 06, 2009 | 2002 Toyota Tacoma

1 Answer

Horn/lights on 2002 Toyota Tacoma


Rewire your horn from the steering wheel to the horn. Its not difficult, I can't tell you how to take the steering wheel apart but you can get a Haynes Repair Manual. It'll have all you need and more. You can use speaker wire, split it in two. Run one cable from the positive in the battery to the horn switch in the steering wheel. Another from the switch to the horn. You have a short somewhere, to me is easier just to run new wires than to find the short-circuit. Make sure when you run the cables through the firewall you run through a grommet so it does not get damaged by metal. Before anything check your headlight wires that they are not touching the horn.

May 18, 2009 | 2002 Toyota Tacoma

2 Answers

Where is the horn relay on a 1998 toyota tacoma


left of steering column almost behind fuse box way at the top you have to stick your head under there with a flash light to see it but it's there.

Mar 29, 2009 | 1998 Toyota Tacoma

Not finding what you are looking for?
2003 Toyota Tacoma Logo

Related Topics:

186 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8572 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...