Location of abs control module 2000 astro van

ZJ Limited

• 17989 Answers
• Posted on May 23, 2011

SOURCE: where is the EBCM module located on a 2000 Chevy

The EBCM (Electronic Brake Control Module) is mounted to the BPMV (Brake Pressure Modulator Valve) located at the left front (lower) engine compartment.

EBCM Removal & Installation Procedure

1. Remove the Brake Pressure Modulator Valve (BPMV). Refer to the Hydraulic Control Unit (BPMV) procedure in this section.
   
2. Remove the 4 T-25 Torx® bolts (1) from the EBCM (2). (click image for zoom)
   
   
   

   Fig. Bolts (1), EBCM (2), bracket (3), bolts (4) and BPMV (5)
   

3. Disconnect the 2-way ABS pump motor connector.
   WARNING Do not use a tool to pry the EBCM or the BPMV. Excessive force will damage the EBCM.
   
4. Remove the EBCM (2) from the BPMV (5). Removal may require a light amount of force.
   1. Do not reuse the EBCM mounting bolts. Always install new bolts.
5. Clean the EBCM to BPMV mounting surfaces with a clean cloth.

1. Install EBCM (2) onto BPMV (5).
   
2. Install the 4 EBCM bolts (1).
   1. Tighten the 4 bolts to 39 inch lbs. (5 Nm) in an X-pattern.
3. Connect the 2-way ABS pump motor connector to the EBCM.
   
4. Revise the tire calibration using the Scan Tool Tire Size Calibration function.
   
5. Use the scan tool to check and clear DTC memory.

SOURCE: fuel pump problem

Its under the hood there is no iternal fuse for the fuel pump

Harvey N Tawatao

• 3854 Answers
• Posted on May 26, 2009

SOURCE: location of the camshaft sensor on a 2000 chevy astro van

The sensor is in the distributor you can get it out with out pulling the distributor but its tight and has to be perfect .... pull the cap off and then the button youll see a sensor under a metal cup looking thing with a wire harness coming out of it i believe you need torks bits for the whole job if you go to any parts store and buy one then pull the cap this will make more sense.
Good luck and hope this helps.

SOURCE: I have a 2003 Chevy Astro Van and the air does not

Check vacuum line running from left side of fuel injection to the right side by the blower motor it is a small diameter line. if that came apart you will only get air coming out of defroster exits.

SOURCE: 2000 astro van won't start

What you have to do is check and see if you have fuel pressure.You have to remove the engine cover to check it.If you don`t have a pressure tester then remove the air cleaner hose to the engine and spray it with carb.cleaner or brake cleaner.If it starts for a few seconds then it is more than likely a fuel pump.If it does not start then you have to check for spark at the spark plugs.Make sure you check more than one plug.If no spark then you have to check the distributor cap and rotor.Make sure the rotor is good and cap also.Things that can cause no spark are the ignition module,coil,and cap and rotor.Hope this helps.Good luck.