Question about 2008 Chevrolet Malibu

Open Question

2008 chevy malibu alarm randomly going off. why?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2001 chevy malibu alarm keeps

Hey! I pulled out my manual and there is no fuse specified for the alarm. Whoever put the alarm in will have to tell you what fuse is used for it. If you purchased it from the dealer with one, then they should be able to tell you. If all else fails, I found a link to the pdf file of the owner's manual. If you click this, it should take you right to the actual file for you to download.

https://www.mygmlink.com/pdf/go2content/manual/US/en/chevrolet/2001malibu.pdf

Posted on Dec 24, 2008

simard2
  • 124 Answers

SOURCE: Horn alarm randomly beeps

Make sure to check all doors, the trunk latch, and the hood to ensure that they are shut. I have looked up your 2006 Chevy Malibu and there has been a lot of people complaining about the alarm system and it going off. There is a TBS (Technical Service Bulletin) out for your car. The TBS says that the Faulty Door Sensor. Take it to your local dealership and tell him what I found for you and they should get you a quote on how much it would cost to repair it.

Thank you for using Fix Ya!
Good Luck!
Any questions don't hesitate to ask me.

Don't forget to rate the overall satisfaction of this solution.

Posted on Feb 02, 2009

  • 68 Answers

SOURCE: 2008 chevy malibu. cannot unlock doors from dirver

Intermittent door ajar switch contacts.

Posted on Mar 05, 2010

  • 3230 Answers

SOURCE: Change headlight on 2008 Chevy Malibu

Hi there,

Well first you can please follow the below steps -
1. Make sure the ignition key is in the off position and the headlight switch is off. Release the hood latch.
2. Open the hood and locate the top of the headlight assembly where you intend to change the headlight. If a plastic shroud is present, locate the center bolt and remove it with a ratchet and a socket. Lift the shroud out of the way to access the headlight assembly retaining brackets. Some later models may feature a snap-release shroud requiring no tools to remove.
3. Locate the brackets on the top rear of each side of the headlight assembly. Lift them all the way up to align the hole on the bottom of each bracket to the retaining tabs on the assembly.
4. Pull the assembly forward away from the Malibu, but be careful not to scratch the bumper. There are three guide pins that require unseating. The guide pins are what aim the headlights and it may take some wiggling to get the pins from their seats.
5. Support the assembly with one hand and then reach behind the unit with the other. The low beam bulb is on the outside, the high beam bulb is on the inside. You can also replace the parking light if desired. Locate the wire harness connection. Un-clip the wire harness from the back of the bulb socket. Remove the bulb by turning it counterclockwise 1/3 of a turn to align the release tabs of the ring and the assembly. Wiggle the bulb out of the assembly.
6. Place the latex gloves on your hands before opening the package of the replacement bulb. Oil in our skin can damage the glass bulbs of halogen headlights.
7. Carefully insert the new bulb into the ring and then align the tabs of the ring to the tabs of the headlight assembly. Push inward and then twist clockwise 1/3 of a turn to lock the bulb in place. Reattach the wire harness. Rest the headlight assembly inside its cavity and test the operation of the headlight before securing the headlight assembly in place. Be sure to turn the lights and ignition back off.
8. Align the three guide pins to their seats and push the assembly back into them gently until they snap into place. Replace the retaining brackets by pushing them downward to lock into place. Replace shroud, if applicable. Remove the tools and old bulb and close the hood. Post comments for further help or information......

Good Luck!!

Posted on Mar 27, 2010

  • 977 Answers

SOURCE: diagram of a 2008 chevy

the power steering reservoir should be under the hood it should'nt be hard to find it usually a round container with a screw top & it is towards one side of the engine.....hope this helps.....cheers

Posted on Aug 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i change the cabin filter on a 2008 chevy malibu


It is located under the cowling on the right side if you have one ( note you will have to take off the windshield wipers off to get to it.

Oct 17, 2014 | 2008 Chevrolet Malibu

1 Answer

My 2008 Chevy Malibu won't go into park and I can't take the keys out of the ignition.


There is a problem in the shift linkage or internally in the transmission.
Needs further diagnostics.

Jul 27, 2012 | 2008 Chevrolet Malibu

1 Answer

I need to disable my alarm on my 2005 chevy malibu because the remote is no longer working


What about the alarm system on a 2005 chevy malibu-if I change the radio will the alarm system still work?

Jun 18, 2011 | Chevrolet Malibu Cars & Trucks

2 Answers

P0300 random misfire on 2002 chevy malibu


go to the link, it has everything u need to check to isolate the cause of a radom missfire

http://www.random-misfire.com/

Nov 18, 2009 | 2002 Chevrolet Malibu

1 Answer

Car will not start due to alarm being armed


FIND ALARM /IMOBILISER BOX AND DISCONECT , YOU CAN THEN GET A NEW KEY BARREL INSTALLED AND GET NEW KEYS,.

Oct 21, 2009 | 1998 Chevrolet Malibu

2 Answers

2008 chevy malibu will not start sometimes


I have same problem with Malibu 2003,use the remote to lock the car2_bing.gif then unlock it and start the car again.if this won't work probably it's the theft alarm stopping the engine from starting

Aug 13, 2009 | 2003 Chevrolet Malibu

1 Answer

Horn alarm randomly beeps


Make sure to check all doors, the trunk latch, and the hood to ensure that they are shut. I have looked up your 2006 Chevy Malibu and there has been a lot of people complaining about the alarm system and it going off. There is a TBS (Technical Service Bulletin) out for your car. The TBS says that the Faulty Door Sensor. Take it to your local dealership and tell him what I found for you and they should get you a quote on how much it would cost to repair it.

Thank you for using Fix Ya!
Good Luck!
Any questions don't hesitate to ask me.

Don't forget to rate the overall satisfaction of this solution.

Feb 02, 2009 | 2006 Chevrolet Malibu

Not finding what you are looking for?
2008 Chevrolet Malibu Logo

Related Topics:

489 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...