Question about 1991 Oldsmobile 88

2 Answers

1991 Oldsmobile 88 Royale loud clunk when turning??

My 1991 Oldsmobile 88 Royale has a loud clunk in the front drivers side when I turn left or right. This only happens when I'm making a very slow turn or sitting still and turn the wheel. It occasionally pulls very hard to the left, but not always. I jacked it up and checked the Ball Joint & Tie Rods, They're dry but tight. I did replace the stabilizer bar a couple years ago but not the bushings. Could someone narrow this down for me????

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Try the axle they usually pop or clunk as you say when they are going bad

Posted on Aug 31, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 3,113 Answers

Ball joint, tie rod end or upper strut bearing. CV joints? Pulling to the left may be an alignment problem with front or rear tires. Get a four wheel alignment.

Posted on Apr 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel pump relay location 1994 olds 88 royale and fuel filter location


pump: is in the tank.

filter: check underneath the car's driver side just in front of the rear wheel.

fuel relay:
Under dash on the right side above the kick panel.


Dec 31, 2010 | 1994 Oldsmobile 88

2 Answers

Need firing order for a 1994 88 delta royal


1994 Oldsmobile Eighty-Eight Royale FWD 3.8 liter V-6

8ed4254.gif

Good luck (remember rated this help).

Nov 26, 2009 | 1994 Oldsmobile 88

1 Answer

1991 olds 88 royale-won't accelerate between 25mph and 40mph.when going up a incline slows down


YOU COULD HAVE CLOGGED FUEL FILTER.BAD PLUGS + COILS.TRANSMISSION IS SLIPPING.DUE TO LOW FLUID LEVEL.SCAN IT TO MAKE SURE THE TPS SENSOR IS WORKING.IT COULD BE OPEN.

Oct 11, 2009 | 1991 Oldsmobile Eighty Eight

1 Answer

Master Cylinder replacement on 1995 Oldsmobile 88


Start with right rear then left rear,then right front then lft front,Would rebleed at master cylinder 1st.

Jun 18, 2009 | 1995 Oldsmobile Eighty Eight

2 Answers

Clunking in front end when turning


  • it sounds like your cv boot is bad and my need to replace or the half shaft is gone bad!!!

Mar 26, 2009 | 1996 Toyota Camry

2 Answers

Catastrophic electrical problems


I'd check the terminal connections and twist them a little to see if they're loose or corroded.
Then follow the wires and check all other connections from the battery.
Can you jump start it?
If not it could be the solenoid or something else!
I once had this problem and finally discovered it was a melted connector under the dash on the drivers side right below the ignition.
I hope this was helpful!
Good Luck!

Jan 20, 2009 | 1991 Oldsmobile 88

Not finding what you are looking for?
Cars & Trucks Logo

459 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...