Question about Cars & Trucks

1 Answer

Rumble in front of jetta

Rumble in front end when accelerating

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 22,156 Answers

In all honesty i would need a drive to be sure but i would hazard a guess and say the wheel bearing

Posted on Feb 11, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
BigBlue77
  • 59 Answers

SOURCE: 98 Chevy Lumina has front

I may be a wheel bearing. Try shifting the weight of the car on the front tires by turning the wheelslightly while driving about 30 MPH. Don't turn enough to change lanes, just enough to put the load on the outside bearing. It may quiet down in one direction. The failed bearing is generally the side that you turned to in order to make the noise go away. Say the noise goes away when you steer to the right, the failed bearing is usually the right one.

You can also check for play by jacking up the car and shaking the tire. There should be no play.

Posted on Sep 06, 2008

  • 1 Answer

SOURCE: 2000 Lincoln LS rumble from 40 - 45 mph

I read the consumer reports found this problem with the drive shaft. My 2000 V8 has done it for 4 yesra now and no problem othen then being anoying. They fixed it in new years, but it just a hum at 40 - 50mph.

Posted on Mar 07, 2009

djwest3453
  • 8 Answers

SOURCE: front end shaking on 2004 jetta

Are the wheels stock, or aftermarket? Is the engine missing maybe under a load?
Had an '02 Jetta TDI I put fancy rims on it, the rims weren't made for the torque the car put out under acceleration, and were actually twisting in there centers causing a severe vibration! Put the steel wheels back on, "Fixed It!"

Posted on Jul 17, 2009

  • 750 Answers

SOURCE: I have a 1999 Lincoln navigator that has a

take an oil sample and check for cutting if any is found then you may have some worn or broken components llike bushings or bearings causing misalinement

Posted on Jul 22, 2009

  • 1 Answer

SOURCE: Front end Rumble Simalar to worn Ball joint Noise

this is going to sound craZy but i had the same problem . 5 different techs, still same problem. sounded like front end was coming through the floorboard. CHANGE ALL SWAY BAR BUSHINGS. QUIET AS A CHURCH MOUSE. GOOD LUCK

Posted on Sep 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1992 Ford Ranger 4 cylinder. Low rumble and vibration as I accelerate or highway speed. Decelerate rumble and vibration go away? Need an answer! Thanks


See if the wheel bearings are ok Sometimes if you jack the vehicle up and spin the tires by hand you can find this. Just a thought as mine did that and noise went away after it was repaired.

Sep 23, 2014 | 1992 Ford Ranger

1 Answer

Rumble after hitting a small bump in the road


need a little more detail here.
Rumble from front? rear? left or right side?
And shake in the steering wheel?
How big a bump and how fast were you going?
Was the rumble instant after the bump?
Is it constantly making the noise or now and again?

Jan 06, 2013 | 2004 Hyundai Tiburon

1 Answer

96 4x4. has rumble at about 55 mph. seems to come from front.


it is very common after a wheel get hit the wheel bearing goes bad

Jun 21, 2012 | 1996 Ford Ranger SuperCab

2 Answers

2003 jetta gls rumble in the front end


sounds like a gearbox bearing ,,,this sounds like a growling noise usually when accelerating although as the problem gets worse it can happen constantly ,,, wheel bearings can growl too but will give a constant noise regardless of acceleration ,,, you need to see to this quickly as the more you drive you will cause more damage and cost to you ,,,,bearings will fix it in the early stages but if more damage is done you could have to pay for new gears and shafts which is expensive

Feb 11, 2012 | 2003 Volkswagen Volkswagen Jetta

1 Answer

I ha ve a grand am 97 when i acelered to 40,000 rpm the motor rumble and go down to 30,000 rpm and go up and down i don't know what happen


You must mean 4000 to 3000rpm. A 1997? Unless it was't taken good care of it shouldn't have hurt it. A lot of front wheel drives have "rumbles" from normal wear and tear. Check all of the belts and pumps for any things that may unbalance the motor such as loose belts or the devices themselves. Automatic transmissions can make this rumble too. Do not go that high in acceleration unless motor has a load on it for that vehicle being old.

Jan 02, 2011 | 1997 Pontiac Grand Am

1 Answer

If my ac compressor or ac belt is going out in my chevy tahoe (2003) will the engine make a rumbling sound when you only turn the ac on and will there be a squeal when you turn the ac on and accelerate the...


sounds like the belt needs tightening or replacing so yes you are indeed correct about the squeal, as for the rumble depends on how bad the rumble is but it shouldnt be caused by either you mentioned.

Jun 20, 2010 | 2003 Chevrolet Tahoe

1 Answer

Ford F350, 7.3 powerstroke, accelerating from 0-60


does it have acentre bearing in the tail shaft ?if so ,fhat is more than likely the problem .also check that all the tail shaft yoke s are in line,they only have to be 1 spline out togive those symptoms ,a rumble ,is definatly coming from the driveline

Nov 13, 2009 | 2001 Ford F350 Super Duty SuperCab

1 Answer

Front end rumble


Check for broken tire belts. Make sure your front struts are secure. Rebalance tires. Also clean any mud stuck to tires.

Sep 11, 2009 | 2008 Chevrolet Cobalt

2 Answers

Engine noise


getting good lubrication flow to the top end of the engine ? maybe some lubrication flow is being blocked to the top of the engine and you hear valve system noise.

Jun 17, 2009 | 2006 Suzuki Forenza

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...