Question about 1999 Pontiac Grand Prix

1 Answer

How do you troubleshoot the horn - 1999 Pontiac Grand Prix

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Pontiac Master
  • 14,036 Answers

If your horns work with alarm using remote, then fuse and relay good if you hear no horn using remote set off alarm,and horn pad dont work, replace horn fuse and relay, if both okay, you have to replace the whole horn pad with air bag in steering wheel both horn control pads and airbag is one assembly.

Posted on Feb 11, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Were is horn relay for sc1 1.9 4 cyl. saturn 1999


The horn system consists of a single horn, a horn relay located in the underhood fuse block, and driver controlled horn switch in the steering wheel. The horn system is designed to provide the driver with an audible warning to signal pedestrians, other drivers, etc.
Operation
Voltage is supplied to the horn relay coil and contacts at all times through a 10 amp HORN fuse, located in the underhood fuse block. When the driver pushes the horn pad, driver air bag module, the circuit completes and energizes the horn relay coil. This causes the horn relay contact to close. When the contact closes, current travels to the horn and the horn emits an audible warning.

Nov 18, 2016 | Saturn Cars & Trucks

2 Answers

Removed the only wire connected to horn it now is only held and connected to frame by a single bolt. Afraid to wire in air horn because horn still sounds even though it has no wire connected to it.


Hi Christian:
Many vehicles have 2 horns so that the sound is more pleasant. If there is no wire connected to a horn, it can not (in my experience) make any sound. May I suggest that you have someone assist you by tapping the horn button while you locate the horn that is sounding.

Sep 16, 2015 | 2000 Isuzu VehiCROSS

1 Answer

How do I repair horn in the steering column


What is the problem with the horn. Check Fuse for Horn. Check Horn it is located under the bonnet. Near the front grill of the car. Check relay for horn most likely also located somewhere in engine compartment in a plastic box compartment with numerous relays. If horn not sounding should hear relay click when horn button pressed.
If horn is getting voltage at horn plug (positively switched horn design) then horn may need replacing.If negatively switched then horn connects to body of car when button pressed and other side of circuit has Plus 12 volts always on it.

Apr 13, 2015 | 2004 Mitsubishi Outlander LS

1 Answer

The horn on my 2010 Santa Fe stopped working. Any suggestions or help


when pushing on the horn pad you may hear a click noise this tells you the circuit is good from the horn pad to the horn relay and out to the horn. find the horn and check for power at the horn terminal when the horn pad is pushed. if it lights up then replace the horn. if it doesn`t then you will have to check for a wire problem from the horn back to the relay. but horns are usually the problem.

Sep 17, 2014 | 2010 Hyundai Santa Fe

2 Answers

How to repair mitsubishi


Not being smart but get a manual or youtube it. You need to remember that the air bag is located near the horn device. You can be hurt by the bag if it inflates.

Apr 16, 2014 | 2003 Mitsubishi Eclipse Spyder

2 Answers

My horn doesent work


WITH KEY ON EVERY THING ELSE OFF PUSH THE HORN YOU SHOULD HEAR A SMALL CLICK THAT THE HORN RELAY IF SO TEST FOR POWER AT THE HORN MAKE SURE IT IS STILL CONNECTED IF POWER IS GOOD REPLACED HORN

Feb 14, 2013 | 1993 Mercury Topaz

1 Answer

For 2004 ford truck f150 extended cab, I found the horn fuse, where is the horn relay?


disconnect the horn or horns, operate the horn and see if the fuse still blows. if the fuse still blows then there is most likely a short in the wiring. relays rarely cause shorts. if the fuse doesnt blow with the horn disconnected, reconnect the horn and operate the horn again, if the fuse blows you have a shorted horn.

Jul 14, 2012 | 2004 Ford F150

1 Answer

Horn does not work, horn buttons are good, horn contact in steering cololm is good, battery level is good, can't find a fuse in fuse box for horn.


if you take a test light and test all the fuses in the fuse box and if they are good then when pushing on the horn button you can usually hear the horn relay working(click).if it does then you need to check the horn itself.take a wire and run it from the battery positive cable and connect it to were the horn wire connects to the horn,it should blow(make sure of a good connection),if it does then it could be a dirty connection at the horn.if it doesn`t blow then the horn needs replacing.you can also use the test light and test for power at the horn wire at the horn itself to see if the horn is being feed power from the horn button to the horn.

Jul 25, 2011 | Pontiac Firebird Cars & Trucks

2 Answers

Where is the horn relay?


The dealer can hook up his diagnostic tool and retrieve the fault code. -------------- SECTION 413-06: Horn 2003 Expedition/Navigator Workshop Manual DESCRIPTION AND OPERATION Horn Horn components include the following items:
  • clockspring
  • horn relay
  • horns
  • steering wheel pad horn switch
Horn switches The horn switch is incorporated into the driver side air bag module in the steering wheel. The switch is powered through the clockspring and grounded through the steering column. For removal and installation of the horn switch, refer to Section 501-20B .
Horn relay The horn relay is incorperated into the central junction box (CJB). The central junction box is located behind the passenger lower kick panel.
------------------------------------------------------------
Symptom Chart
Symptom Chart Condition Possible Sources Action
  • The horn does not sound
  • Central junction box (CJB).
  • CJB fuse 26 (20A).
  • Circuitry.
  • Horn switch.
  • Horn.
  • Clockspring.
  • Powertrain control module (PCM).
  • Go To Pinpoint Test A .
  • The horn sounds continuously
  • Central junction box (CJB).
  • Circuitry.
  • Horn switch.
  • Horn.
  • Vehicle security module.
  • Tire pressure monitor (TPM) module.
  • Clockspring
  • Go To Pinpoint Test B .

Dec 16, 2009 | 2003 Ford Expedition

1 Answer

Horn Wiring 2000 Mercury Mountaineer


no/ you have 2 horns your right about that but its one wire connector for each horn usually one horn on the right and the other on the left/ the horns should be slide in connector and if he cut them for one doesnt seem right/ I bet that was the problem he tried using the same wire from the original horns when he kind of grounded the horn so it would not work / but there is only one wire per horn/ Please rate my response/ Thank you very much

Jan 17, 2009 | 2000 Mercury Mountaineer

Not finding what you are looking for?
1999 Pontiac Grand Prix Logo

523 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...