Question about 2001 BMW X5 3.0d

1 Answer

There is an indication in the dashboard of fuel injection system. How can i fix it

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 4,803 Answers

You can start by scanning your onboard computer system so you can find out what kind of failure of your fuel injection system has caused the light to come on.

Posted on Feb 11, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

After sitting for a few days truck will not start without using starting fluid or gas?

this indicates a leak back problem if on a fuel injected system or a leak in the carby system
if a manual pump it would indicate that the pump valves are faulty and not sealing properly and on an electronic system, it indicates a faulty pressure regulator , failing fuel pump, faulty filters , leaking hose connections

Jun 27, 2015 | Cars & Trucks

1 Answer

Error code p1450

P1450 EVAP Control System Fault, P1450 Unable To Bleed Up Fuel Tank Vacuum.
These are Emmision system faults, the can be as simple as the gas gap on the filler spout is not correct placed, or is missing. It can also indicate other issues with the fuel system from
gas tank to injection. Sometime replacing the gas gap with a correct new one solve the problem.

Oct 07, 2014 | 2009 Mazda 6 2.5

1 Answer

What is wrong when a 1995mercedes benz runs rough intermittently

CHeck fuel pressure and clean fuel injection system; additionally, checl air intake system. Some "check engine" light on dashboard?

Dec 24, 2012 | Toyota Camry Cars & Trucks

1 Answer

Fuel light is on

The typical cause for this is a low fuel level; indicating that your tank will be empty soon. It is never used in the automotive industry to indicate a problem with fuel quality, or the performance of your fuel system. Only for volume.
Adding a few gallons should immediately cause this light to shut off. If it does not, then there is an electrical contact problem in the dashboard cluster located between your fuel level guage and the low fuel indicator light that you are seeing. It is likely that the switch is simply stuck. A few well placed taps on the dashboard may remedy this annoying driver distraction for you.

Jun 19, 2012 | Cars & Trucks

1 Answer

Toyotacorolla 2007

The electronic fuel injection system in your 2007 Toyota Corolla is an extremely technologically advanced, computer controlled, engine fueling system that consists of hundreds of parts, sensors, solenoids, relays and electrical circuits. It also consists of a computer-controlled pump as well as high-pressure lines and fittings that deliver the fuel from the fuel tank to the injectors. The computer system that controlls your fuel injection system has nearly 100,000 times the computing ability of the computers that were on the Apollo space craft that put put man on the moon.
To say something as simple as "fuel injection problem" and expect a viable "solution" for your problem is like saying "water problem" at Niagra Falls and expecting somebody to fix it for you.

What kind of "fuel injection" problem? Have you tried interfacing with the computer that controls your fuel injection system? If so, what did it tell you? If not, that would be a real good place to start.

May 03, 2012 | 2007 Toyota Corolla

1 Answer

Po193 is registering an unpassable emission reading. What should we do?

This fault code is indicating a fault in your fuel rail pressure sensor. It is a very common fault with this model, usually just replacing the fuel pressure sensor that is located on your fuel rail will fix the fault. Here is a discription of it and location:

The Injection Pressure Sensor (IPS) :

  • is attached to the fuel injection supply manifold.
  • uses a replaceable O-ring seal.
  • senses the fuel pressure of the fuel injection supply manifold.
  • is referenced to the intake manifold vacuum.
  • sends electronic signals

  1. Disconnect the battery ground cable. For additional information, refer to Battery.
  2. Relieve the fuel system pressure.
  3. Disconnect the fuel line from the IPR.

Disconnect the IPR electrical connector and the vacuum tube.


  1. Remove the IPR.
    • Remove the bolts.

  1. To install, reverse the removal procedure. NOTE
    • Before installing the IPR, inspect and lubricate the O-ring seal with clean Super Premium SAE 5W-30 motor oil XO-5W30-QSP or equivalent meeting Ford specification WSS-M3C153-G.
    • Hand-tighten the bolts before applying the final torque.

Hope helps.

Sep 22, 2011 | 2003 Ford Freestar

1 Answer

What looks like a curled yellow wire is flashing on the dashboard. After 5 mins of driving the engine cuts out and dies.

this engine heater glow indicator .this indicate if you have water with diesel inside the injection pump or if you have problem with brake light S.W can be check if rear light is ok on /off with brake and in this case engine will not cuts off .check fuel replace fuel filter if you can find injector cleaner is good to clean injection pump and lubricate to avoid injection pump noise and low pressure

Jul 13, 2011 | Volkswagen Passat Cars & Trucks

1 Answer

Whenever i try to cut it on it sounds like its going to cut on but it doesn't. A message appears and says that car is immobilizing see manual

It sounds like you have an issue with your key. It is not communicating properly with the car's security system, thus it sees you as an auto thief.

Immobilizers have a radio frequency transmitter that goes on your keychain. The sensor that is in the dashboard or somewhere near the ignition detects the unique frequency of the transmitter in order to allow the car to run.

For example, a car with an electronically powered fuel pump (which is likely fuel injected) can be easily immobilized if the power relay to the fuel pumps operation is intervened from the immobilizer system. A fuel injected car with an immobilizer circuit would typically disable the fuel pump, fuel injection control, as well as the ignition circuit.

Nov 09, 2009 | 1999 Volvo S80

1 Answer

Engine cut while going dashboard sya injection fault

the multiport fuel injection module could be bad.check the injector pulse with a scope and make sure they are all the same.

Jul 04, 2009 | 2005 Renault 181

Not finding what you are looking for?
2001 BMW X5 3.0d Logo

Related Topics:

232 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Anthony Jones
Anthony Jones

Level 2 Expert

128 Answers


Level 2 Expert

281 Answers

Chris Bowser

Level 1 Expert

18 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides