Question about 2008 Chrysler Sebring Convertible

Open Question

+PTCM 2008 sebring

Where is the Power Top Control Module on 2008 sebring hardtop convertible?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Lowering convertible top

You have to pull down the visors and release the top handles to free the top. Hit the button enough to raise the top slightly and put the handles back in the closed position. Then you can put the top all the way down. There is a built in safety feature, where the window go down slightly as the top starts to open.

Posted on Apr 07, 2009

  • 50 Answers

SOURCE: 2000 chrysler sebring convertable top will go down but will not

Typically, when when this happens, the system is low on fluid and/or must be bled. Here are the procedures:
Lower the top to the full down position.

  1. Remove the rear seat cushion, seat back and inner quarter trim panels. Pull up sharply on the seat cushion at the front about midway between the middle of the seat and the outside edges. The seat back is held in by nuts. The quarter trim panels are held in by screws I think.
  2. Remove the cylinder mounting brackets and remove the cylinders from the trunnion pivot mounts.
  3. Rotate the cylinders 180 degrees (the hose fittings will now face to front of the vehicle.
  4. Disconnect the motor/pump retaining clips from the body.
  5. Rotate and raise the motor/pump assembly so the reservoir is in the up position. The rubber filler plug will be at the top.
  6. Raise motor/pump fitting to at least 2 inches above the horizontal rear seat back reinforcement.
  7. Tilt the motor/pump assembly to approximately the 10 o'clock position, with the rubber filler plug still at the top CAUTION: THE MOTOR/PUMP ASSEMBLY MUST REMAIN IN THE CURRENT POSITION UNTIL THE RUBBER FILLER PLUG IS REINSTALLED IN THE Step 12.
  8. Remove the rubber fill plug from reservoir.
  9. Fill the hydraulic system by adding Dexron 2 Automatic Transmission Fluid to the bottom of the fill hole CAUTION: DO NOT OPERATE THE TOP SWITCH IN THE UP (CLOSING THE TOP) DIRECTION.
  10. With two people, activate the top switch in the down (opening the top) position to fully retract the cylinder rods and hold for approximately 5 seconds, until the motor/pump stalls. A percolating or gurgle sound/feeling is an indication that the procedure is working.
  11. Top off the motor/pump with Dexron 2 and insert the filler plug.
  12. Install the motor/pump assembly into the vehicle mounting bracket.
  13. Rotate the cylinders back to the original position (hose fitting rearward)
  14. Install the motor/pump lead and hydraulic line clips (the hydraulic line clips are to assist in the production process) to ensure that the seat back/seat cushion do not pinch the lines. If the sticky side is no longer holding to the floor pan, the clips can be left off.
  15. Ensure that the bushing is still on the trunnion pivot mount and bracket. Tap the top switch in (raising the top) to get the cylinder trunnion onto the trunnion pivot mounts, if needed.
  16. Install cylinder mounting brackets.
  17. Raise and lower the top to ensure proper operation.
  18. Install the inner quarter panels, and the rear seat back and cushion.
  19. And Just a fair warning here - you WILL spill fluid inside your car. If you manage not to, I want to know how. I cover everything with garbage bags because there have been a few instances where I accidentally hit the button the wrong way and that stuff went EVERYWHERE. Be careful and good luck.

Posted on Apr 17, 2009

  • 93 Answers

SOURCE: bleeding hyd system on 05 sebring convertible top

You are probably low on fluid.
Behind the rear seat is your motor/pump/reservoir combination.
With the top down, fill the reservoir to overflowing with ATF.
Cycle the system a few times and repeat.
Do this till the reservoir will take no more fluid.
Check the lines and cylinders for leaks. If you replace any lines or cylinders, always do them in pairs.
Karl at Topgunwon.com

Posted on Jan 25, 2010

teemossinmia
  • 265 Answers

SOURCE: can the top of a 2008 sebring convertible be

No..... unless you unhook the motor an all its mechanisms, then you can do it manually..Gooduck

Posted on May 07, 2010

  • 383 Answers

SOURCE: my 2008 sebring convertible top will not go back

try the fuses for the roof, and try calling the dealer ship

Posted on Sep 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Belt diagram routing


go to www.automecanico.com translate this web with your browser
and get the topic.
God bless you

Jul 29, 2013 | 2008 Chrysler Sebring Convertible

1 Answer

Where are the fuses for the 08 sebring convertable


Main Power module is located in engine compartment near the air cleaner. The center part contains fuses and relays. Remove the top and on the inside part of the top are the numbers for the diagram. You will need the owners manual to see the fuse labels5_26_2012_12_44_42_pm.jpg5_26_2012_12_47_26_pm.jpg

May 26, 2012 | 2008 Chrysler Sebring

1 Answer

Top won't go down


Hi,

There are already couple of recalls for the same.

Read

January 2008

Dealer Service Instructions for:
Customer Satisfaction Notification G41
Reprogram PTCM and Install Luggage Compartment
Warning Tag


Effective immediately Rapid Response Transmittal (RRT) 07-040 is cancelled
and all repairs on involved vehicles are to be performed according to this
notification. Those vehicles that have already had this repair performed, as determined by our warranty records, have been excluded from this notification.



Models

2008 (JS) Chrysler Sebring Convertible
NOTE : This notification applies only to the above vehicles built from August 31, 2007 through September 28, 2007 (MDH 083100 through 092821).


IMPORTANT : Some of the involved vehicles may be in dealer vehicle inventory. Dealers should complete this repair on these vehicles before retail delivery. Dealers should also perform this repair on vehicles in for service. Involved vehicles can be determined by using the VIP inquiry process.



Subject
The Power Top Control Module (PTCM) software on about 1,200 of the above
vehicles may deform the convertible top header motor gear(s) under certain
operating conditions. In addition, storing objects forward of the trunk cargo shield can damage the convertible top mechanism if the top is lowered. Either condition can cause the convertible top to become inoperative.



Repair

The Power Top Control Module must be reprogrammed and a luggage compartment warning tag must be installed.

Special Tools

Completion Reporting and Reimbursement
Claims for vehicles that have been serviced must be submitted on the
DealerCONNECT Claim Entry Screen located on the Service tab. Claims
submitted will be used by Chrysler to record Customer Satisfaction Notification service completions and provide dealer payments.

Use the labor operation number and time allowance shown.

Dealer Notification

All dealers will receive one copy of this dealer notification letter by mail. To view this notification on DealerCONNECT, select "Global Recall System" on the Service tab, then click on the description of this notification.

Owner Notification and Service Scheduling

All involved vehicle owners known to Chrysler are being notified of the service requirement by mail. They are requested to schedule appointments for this service with their dealers. A generic copy of the owner letter is included.

Enclosed with each owner letter is an Owner Notification postcard to allow owners to update our records if applicable.

Vehicle Lists, Global Recall System, VIP and Dealer Follow Up

All involved vehicles have been entered into the DealerCONNECT Global Recall System (GRS) and Vehicle Information Plus (VIP) for dealer inquiry as needed.
GRS provides involved dealers with an updated VIN list of their incomplete
vehicles. The owner's name, address and phone number are listed if known.
Completed vehicles are removed from GRS within several days of repair claim submission.



To use this system, click on the "Service" tab and then click on "Global Recall System." Your dealer's VIN list for each recall displayed can be sorted by: those vehicles that were unsold at recall launch, those with a phone number, city, zip code, or VIN sequence.
Dealers should perform this repair on all unsold vehicles before retail
delivery. Dealers should also use the VIN list to follow up with all owners to schedule appointments for this repair.



VIN lists may contain confidential, restricted owner name and address information that was obtained from the Department of Motor Vehicles of various states. Use of this information is permitted for this notification only and is strictly prohibited from all other use.

Additional Information

If you have any questions or need assistance in completing this action, please contact your Service and Parts District Manager.
Customer Services Field Operations
Chrysler

Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Jul 07, 2010 | 2008 Chrysler Sebring Convertible

2 Answers

My 2004 chrysler sebring electical is not working.


Check around the MAP sensor area for any connections that may have been disturbed while you were replacing the sensor. Most or all of those functions are controlled by the body control module. I would think that a fault like that would show on the scanner readouts.

Aug 23, 2009 | 2008 Chrysler Sebring Convertible

Not finding what you are looking for?
2008 Chrysler Sebring Convertible Logo

Related Topics:

243 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...