SOURCE: need firing order for 1986 nissan pickup with a
Here is the firing order diagram for that engine.
SOURCE: Nissan navara 1986 2.4L petrol timing problem
For timing, on 1981 and later 4 cyl engines (from the Haynes manual):
1. Turn camshaft so both valves for #1 cylinder are closed, and turn the crankshaft so #1 piston is at top dead center (woodruff key should be pointing up).
2. Engage the camshaft sprocket (with stamped numbers facing out) into the timing chain, and install the chain around the crankshaft sprocket. The bright links on the chain should be aligned with the timing mark on the crankshaft sprocket (on the right side as you look at it) and with the number "2" stamped into the camshaft sprocket, which should also be on the right side as you look at it.
3. Install the camshaft sprocket onto the camshaft, aligning the camshaft dowel pin with the number "2" hole near the center of the sprocket.
For the firing order and wiring routing for the 8 plug 4 cylinder engine: (Plugs on the intake manifold side are coded "I", and on the exhaust manifold side are coded "E")
Wire to 1I should be connected to tower on the distributor facing directly to the front of the vehicle. Going counterclockwise from there, the order is (1I), 2E, 3I, 1E, 4I, 3E, 2I, and 4E.
SOURCE: navara d22 on 53 plate missing at 2.500 r.pm and
i had a similar problem it turned out to be a neuteral selecter sensor located on the gear box
SOURCE: 2002 Nissan Navara will not start after changing battery
dealer only to reset factory immobiliser
SOURCE: 2007 Nissan Navara Service ligth reset.
You will need to send the navara workshop it needs to be hooked up to a special computer to be reset.
695 views
Usually answered in minutes!
×