Question about 2006 Mitsubishi Lancer

1 Answer

How do you replace the driver's side tail light on

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

You will first have to access the trunk and then access the tailight assembly - possibly by removing the upholstery of the molding (not too difficult). The bulb housing can be removed by rotating approximately 90-degrees counterclockwise and pulling the assembly. Simply pull the bulb straight out and insert the new bulb. Be sure to test it before reassembling the unit. Finally, reverse the steps.

Posted on Feb 11, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

leetamara
  • 702 Answers

SOURCE: where is the crankshaft position

near the harmonic balancer.

Posted on Nov 09, 2008

  • 1 Answer

SOURCE: WHERE IS THE CAMSHAFT POSITION SENSOR ON A MITSUBISHI LANCER ES

It is right underneath your air cleaner.

Posted on Jan 15, 2009

c17hydro
  • 2984 Answers

SOURCE: ATF for Mitsubishi Lancer ES 2004

Automatic Transmission,F4A42-1

Posted on Jul 29, 2009

  • 56 Answers

SOURCE: how to reset the

disconect the neg post on the battery for 10 minutes

Posted on Feb 17, 2010

countrybo331
  • 79 Answers

SOURCE: 2003 mitsubishi lancer es fuel filter

ok your fuel filter is located under the car on driver side about half way back......you will need to remove the fuel line from both sides of it witch is a 14mm wrench if im not mistaking....then you will have to loosen up the holder that its in witch is a 10mm wrench...then it should slide right out....if u have any questions just post it

Posted on Mar 28, 2010

Testimonial: "thanks so much!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a CS 2005 MITSUBISHI LANCER AND MY CLOCK, RADIO, INTERIOR LIGHT AND CENTRAL LOCKING HAVE STOPPED WORKING. ALL THE FUSES HAVE BEEN CHECK BOTH INSIDE AND UNDER THE BONNET AND THEY are fine


Your vehicle has similar signs that some VW's showed in the early 2000's. Depending on where you live, here in the Midwest, we found a main wiring harness that ran under the inner edge of the driver side, under carpet was exposed to salt and water during the winter. This caused connectors to brake and cause many issues.

As for your issue, seems that all these components may be sharing the same electrical circuit and therefore not working properly.

Nov 18, 2016 | 2005 Mitsubishi Lancer

1 Answer

2008 Mitsubishi lancer radio from loud squealing noise


What is causing that irritating noise? ' DSMtuners

www.dsmtuners.com > ... > Articles: Miscellaneous
Jun 1, 2009 - 2 posts - ‎1 author Check the ECU power relay in the console, under the radio. ... You hear a loud clicking type noise from under the hood when you try to start the car. .... You hear a squealing, grinding, or rubbing noise in the lower timing belt .... The Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, Mitsubishi Galant VR-4, ... LOUD squeak when turning steering wheel (Video Inside)
22 posts
Mar 5, 2011
Why does my alternator belt squeal so much on initial ...
25 posts
May 14, 2010
More results from www.dsmtuners.com

Lancer Troubleshooting [Archive] - evolutionm.net

www.evolutionm.net/forums/mitsubishi-evolution-forums/f-203.html
NEED RADIO HELP! ... Help not start Lancer GT 2012 EngineOverheating STOP SAFELY warning on ... AC ISSUES 2011 Mitsubishi Lancer ES · 2008 Lancer GTS no start please ... 2011 lancer no sound · Driver/Passenger side floor squeaky? ... plastic piece of rear shelf rattles a lot · Very loud noise on Lancer ES 2008 ...

Dec 03, 2015 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

Trouble identifying problem


There are 2 lots of fuse boxes on cars, one in the engine bay and one normally by the drivers door or just under near the drivers knee... This is where the fuse will be and it should be marked as illum. or tail... Let me know how you go.

Jan 16, 2014 | 1995 Mitsubishi Lancer

1 Answer

Low Beam Wont Turn on, High Beam Yes


I remember a similar problem, replaced the dimmer switch , problem solved, maybe its the same for you, autozone has a website, when you clickon this part, it tells you why it needs replaced, pretty cool , give it a shot, see what happens. tell the parts store you bought the light from what happened, they can help you, customer service is there job !

Jan 13, 2013 | 2006 Mitsubishi Lancer ES

1 Answer

2004 Mitsubishi lancer es stop light switch


the brake lighr switch located : the top of the brake pedal.

May 04, 2010 | 2004 Mitsubishi Lancer

2 Answers

2003 mitsubishi lancer es fuel filter removal/replacement procedures


it's in the fuel tank, you really don't have to replace it unless you have problem with fuel pump.

b340f83.gif
to acess the fuel pump you need to take the rear seat off

bb527be.gif

Mar 28, 2010 | 2003 Mitsubishi Lancer

1 Answer

How to replace rear brake light bulb in mitsubishi lancer'04


Open the trunk and inside you should see the rear plastic panel
of lancer's tail lights.Undo the screws using screw driver and
gently pull the assembly off.You should see 3 light bulbs.
Replace whichever is busted.

Nov 01, 2009 | 2004 Mitsubishi Lancer

1 Answer

My dirver's side mirror has been smashed but the


Most auto parts store have replacements with self adhesive tape on the back. Peal and stick, just remember to clean the surface good. Also, they may need to measure the passenger mirror to give you the correct size.

Sep 21, 2009 | 2006 Mitsubishi Lancer

Not finding what you are looking for?
2006 Mitsubishi Lancer Logo

205 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...